2008 Bmw M3 Coupe!! 6-speed Heated-sts 414hp Xenons Push-start Moonroof 18"whls! on 2040-cars

Auto blog

BMW mulled ten, eight, and six-cylinder engines for i8 before going hybrid

There's little doubt that the 2015 BMW i8 is one of the most radical and groundbreaking performance cars this industry has seen in a long time. From its unique carbon-intensive construction to its 1.5-liter, three-cylinder and electric motor plug-in powertrain to its concept-car appearance, the flagbearer for BMW's new i venture challenges the very notion of what it takes to be a supercar.
Yet apparently the i8 almost didn't do that at all. Yes, it probably still would've had innovative assembly techniques, serious performance and come-hither bodywork, but according to a new report in the Telegraaf, it was very nearly a much more conventional beast, drawing its power from a V10 engine. According to the report, that line of development never got much beyond the drawing board, but BMW engineers then shifted their focus to both V8 and six-cylinder motivation, going so far as to build prototype cars. The higher cylinder-count engines were eventually dropped altogether after BMW decided to turn the i8 into a hybrid, with the six-cylinder reportedly nixed due to heat management and weight issues. In the end, of course, BMW went with the PHEV powertrain that offers a total system output of 362 horsepower and 420 pound-feet of torque - plenty of thrust for this lightweight, all-wheel drive coupe while still enabling an incredible 94 miles to the gallon on the EU cycle. Regardless of how it turned out, it's still fascinating to think that BMW didn't have a much firmer conceptual idea of what it was after when it started the i8's development.
Here at Autoblog, we're genuinely thrilled about this new generation of greener hybrid super- and hypercars, a movement spearheaded by the i8, Porsche 918 Spyder, Ferrari LaFerrari and McLaren P1. But even so, our inner-gearheads can't help but wonder what might have been had BMW pursued a more conventional i8, either in place of, or in addition to, the car they did build. What do you think? Have your say in Comments.

This Alpina C1 is a rare bit of BMW 3 Series history

Over its five decades in the business, German tuner-turned-automaker Alpina has established a long history of taking great BMWs and making them just a bit tastier, more luxurious, and well... faster. Of course, they haven't always been the land rockets of modern day, however that's not to say they were exactly tame. Back in the early 1980s, this was one of the cars to have—an Alpina C1 2.3. Based on the original E21 BMW 3-series, the C1 2.3 bridged the performance gap between the standard BMW 323i and Alpina's hard-charging B6 2.8. It summoned up a heady 170 horsepower and disposed of the 60 mph sprint in just seven and a half seconds. Not shabby at all. 33 years later, this '83 Alpina C1 is back up for sale , and it's still quite the head-turner. RELATED: Check Out the Hard-Charging 2016 Alpina B6 xDrive A look back at the C1's contemporary relatives show just how wide Alpina's performance gap had been. Introduced in 1977, the BMW 323i offered up 141 horsepower courtesy of BMW's famed M20 straight-six engine, a big performance improvement over the E21's previous four-cylinders. The Alpina B6 2.8 3-series on the other hand, introduced in 1978, blew its doors off thanks to the bigger 2.8-liter straight-six plucked from the BMW 528i, offering up 200 horsepower. All that, in an early 3-series. With that in mind, a middle-of-the-pack car made sense, so Alpina treated the 323i's straight-six to some of the B6 2.8's goodies, minus the former's Bosch fuel-injection system. Bilstein shocks were part of the diet too, along with oversized disc brakes, sleek alloy wheels, as well as the tell-tale Alpina front splitter, rear spoiler, and racy side-stripes. RELATED: The BMW Isetta is Coming Back, But as an Electric Vehicle! Inside, Alpina added a dose of luxury as well. One could order their C1 2.3 with the gorgeous optional Recaro seats with Alpina stripes, as well as a bespoke leather steering wheel, gear knob, and speedometer. Top speed? About 130 mph. Compared to regular E21 BMW 3-series cars, these are quite rare. How rare is a point of debate, however. Production estimates range from as few as 35 to as many as 400, depending on the source. Regardless, you certainly don't see them everyday, and if this one fits your fancy... it lives in Philadelphia, Pennsylvania. Related Video: This article originally appeared on Boldride.com. Aftermarket BMW Auctions Coupe Classics eBay alpina

Is BMW ready to increase i8 production?

The BMW i8 plug-in hybrid is really fast. But the car is getting to customers really slowly. The German automaker might be doing something about that. Bimmer executive Ian Robertson, speaking with reports at the Los Angeles Auto Show this week, commented on the high demand for the super-PHEV and said the company may step up production in Germany, Automotive News Europe says. That's because the wait list for the i8 is approaching 18 months in some global markets. And Robertson would like to get that timeframe down to about six months. No details were disclosed about how fast the i8 is being produced or how much faster that production rate may get. The i8, which retails for about $135,000, started sales in Europe in June and in the US two months later. As for the smaller, slower i3 electric vehicle, BMW is making about 2,000 units a month, and wait lists are down to about four months. Part of the reason for that is because BMW shifted distribution rates for that model towards the US to meet higher-than-expected demand from stateside consumers and slow German sales. Through the end of October in the US, BMW had sold almost 4,300 i3 vehicles and 271 i8 models, including 204 i8 units last month alone.