2012 Bmw 128i Sport Package & Premium Package 2 Automatic 2-door Convertible on 2040-cars

Auto blog

BMW i3 gets official worldwide

Even though we recently drove a near-production version of the BMW i3, the car still wore light exterior and interior camouflage. Today, BMW took off that little bit of camo and made a big announcement: The i3 will go on sale in the US for $41,350 in the second quarter of 2014. That does not include any state or federal incentives that could lower the price or the $925 destination fee. The i3 will debut with three trim levels, which BMW is referring to as Worlds: Mega (standard in the US), Giga and Tera.
The BMW i3 is chock-full of new technology afforded by its design as an EV from the start of development, which has resulted in a vehicle layout unique to the i3. BMW has named it LifeDrive architecture, and it features the Life Module and the Drive Module. The Life Module is the i3's pillar-less passenger cell, which is the first mass-produced monocoque made of carbon fiber reinforced plastic (CFRP). The tougher-than-steel material is also 30-percent lighter than aluminum, which contributes to the i3's relatively light weight of 2,700 pounds (preliminary US figure) and, in turn, increases its energy efficiency. Expect more of this technology to find its way into future BMWs.
The Drive Module, a 100-percent aluminum chassis mounted under the Life Module, houses everything that makes the i3 go. It includes the 22-kilowatt, 450-pound lithium ion battery mounted as centrally as possible, and provides power to a rear-mounted electric motor that turns the rear wheels. With 170 horsepower and 184 pound-feet of torque from zero rpm, the single-gear i3 can accelerate from 0-30 miles per hour in 3.5 seconds and 0-60 mph in about 7.0 seconds, but it has a top speed of only 93 mph. BMW says the i3 has a real-world EV range of 80-100 miles, and the standard charger can fill the battery in three hours. Opt for the SAE DC Combo Fast Charger and 30 minutes is all it takes for a full charge; 20 minutes will bump the battery to 80 percent. For customers who have range anxiety, BMW gives them the option to install a 34-hp, 650cc two-cylinder generator as a range extender for the electric drive system.

BMW 1 Series prototype packs direct water injection

Just a few months ago, BMW showcased an M4 that was modified to serve as the safety car for the MotoGP racing series. The flashing lights and emergency equipment, however, weren't the only modifications BMW made to the performance coupe. It also packed an innovative new water injection system. And now it's furthering the development of that system by running it in a 1 Series hatchback as well. Revealed at the BMW Group Innovation Days 2015 event, this five-door 1 Series packs a three-cylinder gasoline engine – like the one found in a Mini or i8 – but fitted with the direct water injection system. In this application, the system sprays a fine mist of water – yep, regular old H2O – right into the combustion chamber. While mixing water with gasoline normally wouldn't be recommended, in this case it evaporates immediately and helps cool the engine from the inside, allowing it to run at higher efficiency. That cooler running engine brings with it several benefits. It delivers improved fuel economy and lower emissions, to start. It also allows for an earlier ignition point, higher compression ratio, and higher boost pressure in turbocharged engines, delivering increased output. It even cuts down on engine knocking (where combustion occurs spontaneously), reduces wear and tear on the engine, and makes better use of lower octane levels. If that sounds like a win-win-win... win (we're losing count of all the wins here), it's because BMW just may be on to something. Of course it does require a water tank to be fitted on board, which means added weight, but instead of requiring the driver fill up the water tank, BMW has fitted this prototype with a system that replenishes the water level from the air conditioning system when the vehicle is switched off. So unless it's being driven in a particularly extreme climate, it doesn't even need topping up. Add one more "win" to the list, then. Extra power, improved real-world fuel economy: Direct water injection enhances efficiency. With direct water injection for turbocharged petrol engines, the BMW Group has again succeeded in enhancing the capabilities of conventional engine technology through an ongoing process of refinement and improvement. The precisely controlled injection of water into the engine cylinders produces a cooling effect that boosts power and torque, particularly when operating at or near full throttle, while at the same time reducing fuel consumption and emissions.

BMW 4 Series Gran Coupe caught again

It's been a while since we've seen the upcoming BMW 4 Series Gran Coupe out testing, but we're sort of inclined to ask "Why?" yet again. After all, the 4 Series is what the new 3 Series-based coupes and convertibles will be called, so the idea of another four-door version just sort of seems redundant. In other words, just how different will a 4 Series Gran Coupe be from a 3 Series sedan, aside from perhaps a more rakish roofline or a four-passenger seating configuration? Probably not much, but BMW clearly thinks it can use the additional bodystyle to rake in some extra profits.
Anyway, back to these spy shots. No more of the 4GC's skin has been revealed since the last time we saw it, but we fully expect it to share a lot of its design DNA with the 3 Series sedan, not to mention the attractive 4 Series coupe concept that bowed at this year's Detroit Auto Show.
Powertrain options should carry over direct from the 3 Series line, so we expect to see 428i and 435i models on hand, packing turbocharged four- and six-cylinder engines, respectively. We're sure that BMW's xDrive all-wheel drive will be available, and who knows, we could even get a 428d version with the new 2.0-liter turbodiesel four that debuted in the 328d at the New York Auto Show last week, or even an M4 variant.