2007 Aston Martin Vantage, Meteorite/bitter Chocolate, on 2040-cars

Auto blog

2019 Aston Martin V8 Vantage First Drive Review | A sportier bark and bite

Aston Martin's 21st century renaissance kickstarted with the DB11, a high-dollar grand tourer that upped the outgoing DB9's dynamic envelope while keeping one foot firmly planted in the brand's aesthetically elevated roots. The sequel to Aston's bid for relevancy is the V8 Vantage, a more agile and track-focused two-seater, perennially the company's best-seller that guns for the heavyweight in the segment, the Porsche 911. With a completely updated design language and laser-like focus on performance, the 2019 Aston Martin V8 Vantage is arguably the most important modern car to come out of Gaydon in... well, forever. Forget everything you know about the late, great V8 Vantage (and its sublime V12 counterpart). The 2019 model is a completely re-imagined beast, built from the ground up with around a turbocharged engine from an unexpected source. The old Vantage V8's naturally aspirated V8 is gone, and in its place is a Mercedes-AMG-sourced twin-turbo 4-liter V8 producing 503 horsepower and 505 lb-ft of torque (up from the old 4.7-liter mills' 430 hp and 361 lb-ft). The new donor powerplant receives a re-tuned intake and exhaust to give off a slightly different aural impression that's slightly raspier than the thumpy AMG. Unlike its AMG counterpart, the Aston version adopts a wet-sump oiling system, with the benefits of sitting lower to the ground and improved fuel economy due to the system's slightly reduced parasitic losses. Senior Vehicle Engineering Manager Craig Jamieson says that his team's learnings developing the wet sump system in the V12 Vantage enabled them to fine tune this setup for track duty. The engine mates to the ubiquitous ZF 8-speed automatic gearbox, which comes equipped here with stationary paddle shifters. Power is routed through Aston's first use of an electronic differential at the rear transaxle, which helps achieve a balanced 50/50 weight distribution. Seventy percent of the bonded aluminum chassis, which is derived from the DB11's, is unique to Vantage. Its dry curb weight is 3,373 pounds (a more standard wet curb weight wasn't available at press time), and it'll sprint to 60 mph in a claimed 3.5 seconds on its way to a top speed of 195 mph. Though much of the Vantage's design direction comes from the obvious decision to depart from the brand's bygone era, a few choices were informed by function – most controversially, those squinty LED headlamps which some detractors have slammed as being "Mazda-like".

GM says second recalled ignition switch was made in China

The defective ignition switch that led General Motors to recall an additional 3.4 million large sedans earlier this month was manufactured in China, according to a report filed with safety regulators obtained by Reuters. The switches can be knocked out of the run position, much like those affecting the Chevrolet Cobalt and other GM small cars, turning off the engine and safety systems like the airbags. Unlike GM's previous ignition switch recall, though, this latest issue will see dealers simply modify the key rather than replace the ignition switch outright, despite the fact that the switches were "slightly" below torque specifications. If what GM is claiming about this switch's origin is true, it'd mark the second high-profile recall of a part manufactured in China, following Aston Martin's (relatively) huge recall due to faulty accelerator arms in over 75 percent of the cars it had built since 2007. For what it's worth, from our perspective, the link between the Aston plastics and this GM switch seems just a bit too tenuous for us to put a lot of stock in GM's problems stemming from the location of its parts supplier, especially when the related investigation into its corporate culture has resulted in so many other culpable actors. Featured Gallery 2008 Buick Lucerne CXL Special Edition News Source: Reuters Recalls Aston Martin GM Safety supplier gm ignition switch recall gm safety ignition switch

Aston Martin recalling all DB11s over Daimler steering column

Aston Martin has become the latest carmaker to be caught up in a major recall of faulty Daimler steering-column components that can cause unintended airbag deployments. The British sports car maker is recalling all 3,873 DB11 coupes built since late 2015, when production of the flagship model began, Aston Martin spokesman Kevin Watters confirmed. He said repairs would be carried out to "address an issue with the DB11 steering column upper." Daimler last year recalled more than 1 million Mercedes-Benz cars fitted with steering-column parts also supplied to Aston and Nissan. The Japanese carmaker's Infiniti brand recalled 17,500 affected vehicles. The issue is unrelated to a global recall of faulty Takata airbag inflators that have been blamed for 20 deaths. Inadequate grounding in the Daimler units leaves their circuitry vulnerable to electrostatic charges that can trigger unintended airbag deployments, according to earlier warnings. Mercedes reported "a handful of instances where drivers suffered minor abrasions or bruises" as a result of the problem. No Aston Martin customers have reported any such incidents to date, the company said, adding the necessary repair work would be carried out free of charge in less than two hours. Reporting by Laurence FrostRelated Video: