Acura, Silver, Automatic, Leather, Heated, Navigation, Warranty, Clean Carfax on 2040-cars

Auto blog

2020 Acura RDX Driveway Test | How does a stroller fit?

From the people who brought you the Luggage Test, it's the Stroller Test! I know, sequels, right?  However, as someone who was recently in the market for a stroller and didn't want to buy a new/gigantic family vehicle to accommodate it (not to mention needing to potentially store it in every vehicle currently sold), knowing how big strollers were and how they might fit in cars was important.  Now, I can't do much in terms of testing a variety of strollers. For that, I would direct you to Baby Gear Lab, which has quite the comprehensive stroller testing program (Wire Cutter is another good source). One of the things I appreciated about Baby Gear Lab was their independent measurements of each stroller, which through the magic of maths, they translate into more easily comparable cubic-inch measurements.  I ultimately chose the new Thule Spring, which is one of the most compact regular strollers on the market, with a folded volume of 5,402 cubic inches (my own independent measurement based on 30 inches long, 16.75 inches wide and 10.75 inches tall). By comparison, the comparable Baby Jogger City Mini 2 when folded is 8,300 cubic-inches according to Baby Gear Lab, while Thule's top-rated jogging stroller, the Urban Glide 2, is 15,388 cubic inches. In other words, if the Thule Spring takes up a lot of space in a trunk, virtually everything else apart from ultra-compact travel strollers will take up even more. This is essentially a best-case scenario.  First up, the 2020 Acura RDX, which is one of the most family friendly compact luxury crossovers. Actually, "compact" is almost a misnomer given how much passenger and cargo space is present. And don't you worry dear friends, that cargo space will be fully put to the test soon with good old-fashioned luggage. Since the RDX is first to be tested, we'll just have to consider it in a vacuum. Not many words to spill here. Now here's the Spring on its side. I already know that it can't fit like this in my Audi Allroad when the cargo cover and cargo net cartridges are in place. It would in the RDX with its cargo cover.  And that's all she wrote. Hopefully this series will prove helpful. Please let me know if there's anything else to be considered — I'm new to this. 

Acura RDX Luggage Test | How much cargo space?

The Acura RDX is considered a compact luxury SUV, but there's actually very little that's compact about it. When lined up against its competitors, you can see that it enjoys a clear dimensional advantage. In fact, the RDX is pretty close to the Lexus RX, with an identical rear legroom figure and considerably more cargo space with the back seat raised. Obviously, I'll be addressing the latter here. On paper, Acura provides several cargo numbers calling out specific SAE measurement standards for each one. Basically, it has 31.1 cubic-feet behind its back seat when you include its underfloor storage and 29.5 cubic-feet when you don't. Even that smaller number is superior to everything in the segment save the Volvo XC60 (29.7), while the Lexus RX apparently has a seems-way-too-small 18.4.   Let's see what that size advantage means. It's obvious that this is a comparatively deep and wide space with plenty of air above the back seat line for bulkier items. Note that the cargo cover was not present in this test vehicle, so I couldn't test capacity with it in place. As in every luggage test, I use two midsize roller suitcases that would need to be checked in at the airport (26 inches long, 16 wide, 11 deep), two roll-aboard suitcases that just barely fit in the overhead (24L x 15W x 10D), and one smaller roll-aboard that fits easily (23L x 15W x 10D). I also include my wife's fancy overnight bag just to spruce things up a bit (21L x 12W x 12D). There you go, all the bags fit easily. This is pretty much identical to the Lexus RX (below left) and a much easier fit than the Mercedes GLC, which is  one of the only other compact luxury models I've tested. Both of these examples are more capacious than their specs would indicate. However, this is not the end of the RDX story. Remember when I mentioned that it has 31.1 cubic-feet when including its underfloor storage? Well, that might actually be underselling the extra space gained. First, I like that the floor flips back and rests flat so you can easily use the extra space. You can also fully remove the floor piece to gain access to the aft bin, which is deeper but oddly shaped.  Here are my four largest bags standing up, with sufficient rear visibility maintained, and you still have the full-width section of the cargo area including the underfloor bin. What can you fit there? How about a 38-quart cooler and the remaining two bags stacked haphazardly around it.

Acura replaces chief Accavitti with designer Ikeda

Acura is shaking up its senior leadership, as Honda ushers the current chief of its luxury division out the door and replaces him with a new one. Exiting stage left is Mike Accavitti, who held the reins at the premium automaker as its senior vice president and general manager of the Acura division. Taking his place will be Jon Ikeda, one of the Japanese automaker's most senior designers. Accavitti (pictured above at left) had been promoted to the job from his previous position as senior vice president of auto operations after Honda separated the Acura brand into its own division. He had previously served as a senior executive at Chrysler, rising up the ranks to run the Dodge brand, and joined Honda in 2011 as its chief marketing officer. At this point it remains unclear why Accavitti is leaving and where he might land, but Honda says he's leaving the company altogether. To replace Accavitti, Honda has named Jon Ikeda (pictured above at right), a veteran designer with the company. A graduate of the Art Center College of Design in Pasadena, CA, Ikeda has worked for Honda on both sides of the Pacific since 1989. He previous headed up the design and product planning divisions at Honda's American R&D operations, and was instrumental in creating an independent design office for the Acura brand, separate from Honda's. This isn't the first time we've seen Accavitti replaced in his role as a senior executive by a design veteran. After only four months at CEO of the Dodge brand, he was replaced by Ralph Gilles, who retained his role as senior vice president of design for the entire Chrysler group in parallel. Gilles was ultimately replaced as head of Dodge as well, but was recently promoted to serve as head of design for Fiat Chrysler Automobiles. Related Video: Acura Announces Leadership Changes TORRANCE, Calif. July 27, 2015 – Acura today announced that Jon Ikeda has been promoted to Vice President and General Manager of the Acura Division of American Honda Motor Co., Inc. In this role, Ikeda will oversee all Acura brand activities including sales, marketing and parts and service. Ikeda was formerly Division Director of Auto Design at Honda R&D Americas, Inc. (HRA). He began his career at Honda in Japan in 1989, joining the advanced design studio in Tokyo, where he worked on the award-winning Honda FSX show car. After six years in Japan, he returned to Los Angeles in 1995, to continue his career at Honda R&D in Torrance, California.