2014 Toyota Sienna Xle on 2040-cars

Auto blog

2014 Toyota Highlander recalled over seatbelt anchors

Toyota has announced a small recall of its redesigned, 2014 Highlander over issues with one of its seat belts. The affected vehicles, which were built from November 20, 2013 to January 18, 2014, could have a seatbelt assembly in the middle seat of the third row that wasn't properly secured to a floor anchorage at the factory.
In total, 7,067 of the new Highlanders are included in the recall, which was discovered not after a crash, but during a post-build inspection at the factory. It's unclear if there have been any injuries as a result of the faulty seat belts.
Toyota is set to inform owners of the affected vehicles as well as dealers with the recalled Highlander models in their inventory. Naturally, repairs will be performed free of charge. For the full bulletin form the National Highway Traffic Safety Administration, scroll down.

Minivan market not what it used to be, but margins make up for it

Residual values for last year's minivans are higher than they were in 2000.
Much like the station wagon was the shuttle of Baby Boomer generation, the minivan has been the primary means of transport for Generations X and Y. Just as the boomers abandoned the Country Squire, though, those kids that were toted around in Grand Caravans and Windstars are adults, and they certainly don't want to be seen in the cars their parents drove.

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.