2017 Subaru Outback 2.5i Limited on 2040-cars

Auto blog

Subaru celebrates 4-millionth vehicle built in Indiana

Subaru has produced its four-millionth vehicle at its Lafayette, Indiana factory. The Deep Indigo Blue 2014 Outback is pictured above, alongside the very first Subaru to leave the Lafayette facility, a first-generation Legacy. Formally known as Subaru of Indiana Automotive, SIA opened its doors in 1989 and currently produces the Outback, Forester and Tribeca for Subaru, in addition to the Toyota Camry.
The plant, which was originally a joint venture between Subaru and Isuzu, has produced nine different models for four different manufacturers over the years, and is getting ready to add a tenth as Impreza production will be coming to SIA. Subaru announced plans to move Impreza production to Indiana when it made a $400-million investment in the facility earlier this year. As production continues, the Lafayette Journal-Courier reports that SIA will produce another million units by the end of 2017.

Subaru recalls new Forester over pedal entrapment fears

Pedal entrapment and unintended acceleration are hot-button topics these days, so automakers are always staying alert for potential problems. For Subaru and its newly introduced 2014 Forester, the National Highway Traffic Safety Administration has issued a recall due to improperly manufactured floor mats that could become an obstruction for the gas, brake or clutch pedals. The good news, of course, is that even if drivers experience this problem, the 2014 Forester comes standard with brake override.
At issue with the floor mats on 10,137 Forester models built between January and March of this year is that the resin material used on the underside of the mats can curl when exposed to heat. If the leading edge of the driver's mat curls enough, it can come in contact with the pedals making acceleration, braking and shifting more difficult - possibly resulting in a crash. To fix the problem, Subaru is replacing the entire set of floor mats in all of the affected units. The official NHTSA recall notice is posted below.

Subaru investigation confirms vehicle data tampering in Japan

Subaru has admitted that alteration of fuel-economy and emissions data took place in its Gunma and Yajima manufacturing plants between December 2012 and November 2017. Some 900 vehicles were affected by data tampering, which Subaru says was done in the vehicles' final inspections by factory-floor inspectors. In a report, Subaru says "non-conforming" final vehicle inspections were identified in late 2017, and that the Japanese Ministry of Land, Infrastructure, Transport and Tourism demanded that Subaru undertake an internal investigation of the matter. Almost 7,000 vehicles were subject to inspection in the investigated time period, and the measurement equipment retained test data for some 6,500 of those. It showed that 903 vehicles had had their data "inappropriately altered," partially so that average data values would meet quality control standards. Subaru says that the decision to do this was made among vehicle inspectors and their foremen. As Subaru's statement reads: "Inspectors engaging in sampling of fuel economy and emissions were instructed by their seniors that, if results for each vehicle did not meet such standards, measurement values should be altered to those that meet such standards, and, according to such instructions, the inspectors altered measurement values. [...] Even if there were no problems in comparison with the internal quality control standards, inspectors altered measurement values with the intention of reducing variance in measurement values in order to avoid questions from the Group Chiefs and the Section Chief on such variance. It should be noted that alterations were made not only to make results better, but also to make them worse." It appears that everything was done to keep the average values right. Subaru adds: "Although the relevant laws and regulations stipulate that, in certain limited cases, measurement values could be altered in order to adjust errors caused by measurement equipment, inspectors misunderstand such adjustment method because of deficient internal rules and inadequate training. Inspectors altered measurement values by adjustment methods not stipulated in the relevant laws and regulations, without understanding that their methods were inappropriate." Test equipment did not contain data from earlier than 2012, but Subaru suspects such tampering took place as long ago as 2002. However, the matter will not result in recalls.