1999 Saturn Sl Sl2 Auto Low Miles on 2040-cars

Auto blog

303 Deaths Tied To Airbag Non-Deployment In 2 General Motors' Cars

At least 303 motorists died in car accidents after their airbags didn't deploy in now-recalled General Motors vehicles, according to a study released late last night. The Center for Auto Safety, a non-profit automotive watchdog, reviewed data from the Fatality Analysis Reporting System, and counted deaths involving the Chevrolet Cobalt and Saturn Ion, two vehicles at the heart of several ongoing investigations, to reach its conclusion. If the airbag non-deployments were the result of a faulty ignition switch that inadvertently turns them off, the death toll would be the largest in automotive history attributed to a single defect, surpassing the 250 deaths investigators linked to defective Firestone Tires more than a decade ago. The rising death toll would further amplify questions about why GM and federal safety regulators at the National Highway Traffic Safety Administration didn't act sooner to correct the problem. Safety advocates have said both GM and NHTSA failed to act in a timely fashion to alert motorists of the dangers posed by the dangerous defect, of which documents GM had knowledge of as early as 2001 and NHTSA knew about in 2007. "The question today for NHTSA is how so many ... death reports without an airbag deployment and so many FARS deaths without an airbag deployment failed to trigger an investigation," wrote Clarence Ditlow, the executive director of the Center for Auto Safety. "... For the people who died or were seriously injured in crashes, the answer comes too late." GM has acknowledged 13 deaths related to the problem, and says the number cited by the Center for Auto Safety study is "speculation." The review of FARS data, conducted by Friedman Research at the request of the Center for Auto Safety, looked at fatal cases in which airbags did not deploy but did not analyze the causes of the crashes. FARS information is raw data submitted to a national database by state and local authorities when fatal accidents occur. Last month, GM recalled 1.37 million cars in the U.S. because a faulty ignition switch had been inadvertently moving from the "run" position to the "accessory" position, turning off engines and systems that provide power to airbags. "Shame is not a strong enough word," said Lou Lombardo, the founder of Care for Crash Victims, another safety-minded nonprofit that advocates for accident victims. The results of the CAS study were first reported by the New York Times.

Report: GM temporarily restarts Saturn Outlook, Hummer H3 production

Saturn Outlook - Click above for high-res image gallery
Even though both the Saturn and Hummer brands are being phased out, General Motors has reportedly revived production of both the Outlook crossover and H3 SUV to meet consumer demands.
Last month, GM assembled 1,037 Outlooks at its Lansing, Michigan facility, which is where the crossover's Lamda platform stablemates (Buick Enclave, Chevrolet Traverse and GMC Acadia) are built. A spokesperson for GM states that production was reinstated to utilize the rest of the Saturn-specific material at the facility, and that the automaker will continue to assemble the Outlook for a few more weeks.

GM recalling over 243,000 crossovers over possible seat belt defect

2010 Buick Enclave - Click above for high-res image gallery
The summer of 2010's recall hit parade continues unabated today, with General Motors having just announced that it is asking 243,403 owners of its 2009-2010 Lambda crossovers to bring their three-row haulers in for inspection. The culprit? Second-row seat belts in select Buick Enclave, Chevrolet Traverse, GMC Acadia, and Saturn Outlook CUVs have "failed to perform properly in a crash."
According to GM, a second-row seat-side trim piece is to blame, as it can impede the upward rotation of the buckle after the seat is folded flat. As a result, if the buckle makes contact with the seat frame, cosmetic damage can occur, potentially requiring additional force to operate the buckle properly. So far, no great shakes, but in the process of applying that additional force, the occupant may push the buckle cover down to the strap, potentially revealing and depressing the red release button. As a result of this, the belt may not latch, or in certain cases, it may actually appear to be latched when, in fact, it isn't.