2024 Ram Promaster High Roof on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Here's how Detroit is selling more luxury vehicles than Germany and Japan

Now there's an attention-grabbing headline, eh? Although the answer to the riddle - pickup trucks and SUVs - might be somehow deflating, the numbers involved deserve a going over. According to TrueCar's figures (click on the table to enlarge), six of the year's ten best-selling vehicles in the US that sell for a transaction price above $50,000 are body-on-frame, and the Mercedes-Benz E-Class is the only foreigner to crack the top five. Every enthusiast knows that pickup trucks are 'Murica's most popular vehicle by a colossal margin, and there have been plenty of reports about the popularity of luxuriously appointed trucks and SUVs, but compare these figures from TrueCar: 70 percent of Chevrolet Tahoe sales have a transaction price above $50K, and The Bowtie is expected to make $3.9 billion in revenue on 66,945 predicted high-dollar sales; 95.1 percent of E-Class sales break $50K, so the German company will make $4.0 billion on 67,006 predicted sales in that pricing sphere. It's about the only time you'll see the Tahoe ranked right next to Mercedes' bread-and-butter sedan. Ram is ahead of those two with $4.2B coming from $50K-plus sales. The Ford F-Series does almost as much revenue as the next three combined, with an expected $10.8 billion coming from sales of trucks over $50K - more than a quarter of the model's total sales, when a base F-150 can be had for about $26,000. Yes, the Germans make a lot more money on fewer sales, but considering the comparison, the bottom line isn't too troubled by such facts. Weighing like-for-like, the full-size Ford walks it in every category; elsewhere, the Chevrolet Silverado outsells the Ram, but the Ram outsells the Chevy by 6.7 percent above $50K. And for all the flak GMC takes over swapping out grilles, the Sierra also outsells the Chevy in the well-appointed segment, 16.1 percent of sales versus 11 percent – the Professional Grade brand is a huge profit center for The General. You'll find more info in the TrueCar press release below. TrueCar finds pickup trucks far outsell premium brands among top 10 vehicles over $50,000 Ford F-Series pickup sales over $50,000 surpass combined BMW 3, 5, 7 Series luxury car sales SANTA MONICA, Calif. (December 10, 2014) - TrueCar, Inc., the negotiation-free car buying and selling platform, finds mainstream pickup trucks and sport-utility vehicles dominate U.S.