2014 Ram 3500 Laramie on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Chrysler's internal documents question Ram quality as workers protest

Chrysler is reportedly having a hard time ramping up production of its 2013 Ram 1500. According to The Detroit News, only 16 of the 58 trucks built at the Warren Truck Assembly Plant during the model's first hour passed final inspection. While quality eventually improved over the course of the day, just over half of the units built on Thursday were approved for shipment. Even with workers ordered to stay late to fix their mistakes, some 1,078 units remained outside the facility with defects. The problem, according to workers at the plant, is morale.
According to the report, Chrysler recently changed the shift schedule at the plant and workers are unhappy with the new situation. The new plan has workers split into three shifts, each covering four 10-hour days. With the shifts staggered, some workers now have to work nights and on Saturdays. Some employees are so upset that they've taken to protesting, though the move isn't sanctioned by the United Auto Workers.
Meanwhile, Chrysler admits there were internal issues with the launch, but that the company was able to contain them. A spokesperson has said "plant quality indicators are getting progressively better."

Fiat Chrysler expands Takata airbag recall to 3.3M vehicles

Fiat Chrysler Automobiles is expanding its recall of vehicles equipped with Takata airbags, moving beyond Florida, Hawaii, Puerto Rico and the US Virgin Islands to the greater US, as well as Mexico, Canada and beyond. The affected vehicles, some 3.3 million in total, were built between 2004 and 2007, with many models, including the Dodge Ram 1500, 2500 and 3500, Durango and the Chrysler 300, having been affected by Chrysler's previous recall. Despite the somewhat alarming nature that comes with a recall of this many vehicles, it seems that Chrysler is moving more out of an abundance of caution (and federal pressure) than anything else, saying: "Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles." Owners of affected vehicles will be notified and asked to report to dealers for a free replacement driver's side airbag. Scroll down for the official press release from FCA. Statement: Global Air-Bag Inflator Replacement December 19, 2014 , Auburn Hills, Mich. - FCA US LLC will replace driver's-side air-bag inflators in an estimated 3.3 million older-model vehicles worldwide, in an expansion of an ongoing regional field action. Neither FCA US, nor Takata Corporation, the supplier, has identified a defect in this population of inflators. These components also are distinct from Takata inflators cited in fatalities involving other auto makers. More than 1,000 laboratory tests have been performed on these components. All deployed as intended, but FCA US continues to study the suspect inflators, which are not used in the Company's current production vehicles. Outside of Florida, one of the areas covered by the original action, no FCA US vehicle has been linked to an air-bag deployment of the type that has raised public concern. Nevertheless, the Company is replacing the Takata components tied to that concern. FCA US is aware of one related injury involving one of its vehicles, an older-model sedan. It occurred in a southern Florida region marked by persistent, high, absolute humidity – a condition believed to be a contributing factor in the air-bag deployments under investigation.