Red 1 Owner Air Auto Cruise Low Miles 4x4 Wheel Turbo Diesel Crew Finance Trade on 2040-cars

Auto blog

FCA recalls 2 million Ram trucks over airbag issues

Airbag issues have prompted Fiat Chrysler Automobiles to issue another pair of recalls. The two separate issues both affect Ram pickups, one campaign stemming from oversensitive sensors, the other from a wiring harness. Between them, the problems affect an estimated combined total of some 2 million units. The first recall affects 2013-15 Ram 1500, 2500, and 3500 trucks, specifically four-door models, manufactured between June 20, 2012, and January 26, 2015. The calibration of the side impact sensor in those affected units may to be too sensitive. As a result, if the door is slammed too hard, the side-curtain airbag and seatbelt pre-tensioner may inadvertently activate. FCA reports that this issue affects an estimated 667,406 units in the United States, plus 153,011 in Canada, a further 8,272 in Mexico, and another 14,847 in markets outside of North America, amounting (in Chrysler's estimation) to less than 0.005 percent of those vehicles produced. The automaker says it is aware of two minor injuries (but no accidents) that may have resulted from the glitch, and is taking action to have the Occupant Restraint Control module recalibrated in the affected units. The second issue also affects Ram pickups, including 1500, 2500, 3500, 4500, and 5500-series models from the 2012 to 2014 model years, built between January 18, 2011, and October 7, 2014, and fitted with the optional Electronic Vehicle Information Center. The problem here stems from a wiring harness in the steering wheel that may rub against a retainer spring in the air bag control module, which in turn could cause an electrical short and deploy the driver's side air bag unexpectedly. In the United States alone, the issue is estimated to affect 1,060,531 units, which will need to be inspected and, where necessary, have their steering wheel wiring harnesses secured, with protective caps added to the ends of the airbag retainer spring. These do not represent the first issues we've seen from Fiat Chrysler in recent days. The automaker recently issued a recall for approximately 1.4 million vehicles to have their Uconnect software updated to prevent hacking. A few days ago it also announced a recall for 350,000 Dodge Journey (and Fiat Freemont) crossovers to secure loose engine covers. And the National Highway Traffic Safety Administration is expected to issue Fiat Chrysler Automobiles a $105-million fine for mishandling other recent recalls and safety issues.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Ram 1500 TRX spied hiding production body work under camouflage

We've seen the upcoming Ram 1500 TRX pickup truck a few times with its Raptor-rivaling suspension and Hellcat-derived powertrain. Those past mules have all worn plain Ram bodies, sometimes with cheap bolt-on fender flares. This time, one of our spy photographers has caught a TRX that seems to be wearing production body work under its heavy camouflage. What stands out on this prototype are the bulging fenders front and rear. Instead of simple wheel housing extensions, these are full-on box flares like the ones worn by the Raptor. The hood appears to be equally bulging, good for highlighting the supercharged V8 underneath. The front bumper is similar to that of the Ram 1500 Rebel's with more raised sections in front of the tires to provide more clearance. We get a solid look under the body, too. Still present are the extra beefy suspension control arms front and rear. Skid plates seem to line the whole underside down the middle. The tires are big Goodyear Wrangler all-terrain tires, though we can't make out what size they are. Previous spy photos have revealed remote-reservoir shocks. The wheels at each end are six-lug units, so it seems Ram isn't playing with a heavy-duty axle like a previous prototype suggested. We're expecting the Ram TRX to go on sale before 2022, so it could be revealed sometime next year as a 2022 model. Based on the TRX concept, the production truck should make at least 575 horsepower and have dune-busting off-road performance. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Driving a Jeep Cherokee to Rocky Mountain National Park | Behind the Wheel S01 // E06 Disclaimer: Autoblog accepts vehicle loans from auto manufacturers with a tank of gas and sometimes insurance for the purpose of evaluation and editorial content. Like most of the auto news industry, we also sometimes accept travel, lodging and event access for vehicle drive and news coverage opportunities. Our opinions and criticism remain our own — we do not accept sponsored editorial.