5.7l V8 Hemi Laramie Leather Navigation Alpine Bedliner Tow Mp3 Bluetooth 4x4 on 2040-cars

Auto blog

FCA recalls 2 million Ram trucks over airbag issues

Airbag issues have prompted Fiat Chrysler Automobiles to issue another pair of recalls. The two separate issues both affect Ram pickups, one campaign stemming from oversensitive sensors, the other from a wiring harness. Between them, the problems affect an estimated combined total of some 2 million units. The first recall affects 2013-15 Ram 1500, 2500, and 3500 trucks, specifically four-door models, manufactured between June 20, 2012, and January 26, 2015. The calibration of the side impact sensor in those affected units may to be too sensitive. As a result, if the door is slammed too hard, the side-curtain airbag and seatbelt pre-tensioner may inadvertently activate. FCA reports that this issue affects an estimated 667,406 units in the United States, plus 153,011 in Canada, a further 8,272 in Mexico, and another 14,847 in markets outside of North America, amounting (in Chrysler's estimation) to less than 0.005 percent of those vehicles produced. The automaker says it is aware of two minor injuries (but no accidents) that may have resulted from the glitch, and is taking action to have the Occupant Restraint Control module recalibrated in the affected units. The second issue also affects Ram pickups, including 1500, 2500, 3500, 4500, and 5500-series models from the 2012 to 2014 model years, built between January 18, 2011, and October 7, 2014, and fitted with the optional Electronic Vehicle Information Center. The problem here stems from a wiring harness in the steering wheel that may rub against a retainer spring in the air bag control module, which in turn could cause an electrical short and deploy the driver's side air bag unexpectedly. In the United States alone, the issue is estimated to affect 1,060,531 units, which will need to be inspected and, where necessary, have their steering wheel wiring harnesses secured, with protective caps added to the ends of the airbag retainer spring. These do not represent the first issues we've seen from Fiat Chrysler in recent days. The automaker recently issued a recall for approximately 1.4 million vehicles to have their Uconnect software updated to prevent hacking. A few days ago it also announced a recall for 350,000 Dodge Journey (and Fiat Freemont) crossovers to secure loose engine covers. And the National Highway Traffic Safety Administration is expected to issue Fiat Chrysler Automobiles a $105-million fine for mishandling other recent recalls and safety issues.

2017 Ram EcoDiesel trucks hitting dealerships again, finally

If you've been patiently waiting for 2017 Ram EcoDiesel trucks to hit dealerships near you, you're in luck. According to Automotive News, the diesel-powered pickups are now hitting showroom floors after FCA received approval from the Environmental Protection Agency in late July to begin producing them again. And you may want to get in line now, because the EPA has yet to approve the EcoDiesel for the 2018 model year. The EPA, along with the California Air Resources Board, accused FCA in January of 2017 of using eight undeclared pieces of software code in certain Fiat Chrysler diesel vehicles. That, naturally, led to "substantially" higher than allowable levels of nitrogen oxide emissions. The violation applies to about 104,000 vehicles sold between 2014 and 2016. EcoDiesel production was stopped in late 2016. FCA says it's continuing to cooperate with the EPA and CARB. Assuming the two agencies approve the plan, the automaker will recall 2014-2016 Ram and Jeep Grand Cherokee vehicles to install the new code. We'd assume that same updated software will be used in 2018 EcoDiesels, too, again assuming they get EPA approval. Related Video:

Ram trucks set for export to Australia, New Zealand

Looking across the Pacific at Australia's car-based utes is always a little exciting because it's a glimpse at a land where models not unlike the classic Chevrolet El Camino survive. Now, the Aussies are about to see how the US builds big trucks thanks to a deal to import the Ram 2500 and 3500 into the country. This new market entry comes about thanks to a deal between Ram and the New Zealand importer of FCA products, and once across the ocean, the trucks are converted to right-hand drive. The automaker has "worked closely with our engineers to produce a vehicle that is as close to an official factory right-hand-drive vehicle as it can be without it having actually run down the factory production line," Clyde Campbell, co-owner of Fiat Chrysler New Zealand," said to Drive. The first batch of pickups is set to go on sale to Kiwis and Aussies in October, but further details about them aren't disclosed yet, including available powertrains and price. Drive estimates the Ram 3500 to retail for over 100,000 Australian dollars ($76,000). The trucks are being aimed at those with heavy loads to haul like industrial companies or people with large horse trailers. These might not be the last two Ram models to make it Down Under, either. According to Drive, the New Zealand importer is working to strike a similar deal to bring the Ram 1500 across the Pacific in the future.