2025 Ram 1500 Big Horn/lone Star on 2040-cars

Auto blog

NHTSA closes investigation on 4.7M FCA power modules, no recall

FCA US hasn't had the best time with recalls as of late. Not only did the company recently agree to greater safety oversight and paid $105 million to the government, that came just days after hacking fears prompted a 1.4-million model recall campaign. However, a recent decision to close an investigation by the National Highway Traffic Safety Administration means that the automaker doesn't have to worry about another major recall possibly affecting 4.7 million vehicles, according to the agency's report (as a PDF). Last September, the Center for Auto Safety petitioned NHTSA to investigate an alleged problem with the totally integrated power module (TIPM) on these FCA US models. The group claimed that a fault with the component could cause a variety of maladies, including stalls, not starting, catching fire, unintended acceleration, and airbag non-deployment. At the time, it also submitted 70 cases where this had reportedly happened. According to NHTSA, "no valid evidence was presented in support of claims related to airbag non-deployment, unintended acceleration, or fire resulting from TIPM faults and these claims were found to be wholly without merit based on review of the field data and design of the relevant systems and components." The agency did find signs of an issue with the fuel pump relay in some Jeep Grand Cherokees and Dodge Durangos, but FCA US issued recalls for the problem in September 2014 and February 2015. Without anything else to go on, the Feds don't think it's worth investigating this topic any more.

444,000 Cummins diesel Ram trucks recalled for water-pump fire risk

NHTSA recently acknowledged a recall for nearly 444,000 Ram 2500, 3500, 4500 and 5500 trucks built between 2013 and 2017 with Cummins 6.7-liter diesel engines. The issue is that the water pump might do the exact opposite of keeping the engine cool. According to documents from Fiat-Chrysler and NHTSA, Concentric-brand water pumps without vent holes could suffer bearing failure, as well as start leaking coolant. This exposes coolant to hot parts of the engine, and the pump itself can become a hot part. Not all Cummins-equipped Ram trucks will be affected. If your Ram has a water pump from a different brand, or it uses a Concentric pump with some kind of vent holes, you shouldn't have any issues. In fact, the fix will be to replace the non-vented pump with a vented version. Owners with affected vehicles will be able to bring their trucks into a Chrysler dealer, where the water pump will be replaced at no charge. FCA will begin notifying owners of the issue starting on Nov. 1. Owners can also get in touch with Chrysler's customer service department at 1-800-853-1403 and should ask about recall "T51." Related Video: Featured Gallery 2013 Ram 2500 and 3500 Heavy Duty View 22 Photos News Source: NHTSA Recalls RAM Auto Repair Truck Diesel Vehicles

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.