2019 Ram 1500 Laramie Longhorn on 2040-cars

Auto blog

A beginner's guide to plowing snow with a heavy-duty truck

I live in a desert, so the only things getting plowed around here are mud flows and brewer neighbors. But I enjoy machinery and haven't plowed any snow since a "loaded" truck meant one with A/C and a CD player, so I jumped at the chance for a plow primer in a Ram HD on a Canadian airfield. Running a plow is like welding – the basics come quickly but experience pays dividends. The first thing to deal with is a frequently changing horizon because, stout as they are, even three-quarter-ton heavy-duty trucks will move up and down in front considerably with a 600-to-800-pound plow hanging off, and fast plow hydraulics rival some low-riders for bounce effect. Getting going is easy unless you forgot blocks and the plow froze to the ground, rookie. If you have to drive to your plowing assignment, blade height needs some experimentation to find the best cooling airflow; if you think sub-freezing temperatures negate that concern, remember you've installed what amounts to a 20-square-foot air brake up front that the truck has to overcome, and blowing snow could block some cooling air passages. Whether it's a "straight" blade or V design, always have it tilted to the right lest you catch a hidden post, solid mailbox, or edge of a snow bank. Most plow operators I spoke to rarely exceed 45 mph in transit because of cooling, front suspension travel, and common sense, and you should go even slower if you don't have some ballast like chains, extra fuel tanks, or a salt spreader to balance the load on the back. With trucks' relatively slow steering and all that weight up high, oversteer is best avoided. With a little clean space to get a run, stick it in Drive to gather momentum and lower the plow simultaneously to float, where the weight of the plow rests on and lets it run along the surface. Momentum is good until you hit something you didn't know about, at which point the plow's breakaway systems limit damage but your truck could still hit something big; caution never hurts. Start out at 10 to 15 mph, depending on consistency and depth, making a clean wave off one side. If you have to push it straight, as you slow coincidentally raise the blade at the bottom of the pile to shove it up higher. Carry too much speed here and you'll stop with an unceremonious thud. Common mistakes cited among a few experts were people pushing banks of snow rather than plowing it, and rushing the shift between Drive and Reverse, throttling up before the shift is completed.

Chrysler recalling 382k Ram HD diesel pickups, 184k SUVs

Between GM's ignition switches and Takata's airbags, it's been a big year for recalls, but they keep rolling in. The latest comes from Chrysler, which has announced a pair of recalls for certain heavy-duty pickups and SUVs.
The first issue revolves around the 6.7-liter Cummins diesel engine available in the 2010-2014 Ram HD trucks, including 2500 and 3500 series pickups as well as 4500 and 5500 series chassis cabs. In the affected units, "a terminal connector near the fuel heater may be subject to friction-induced corrosion," according to the first of the two announcements from Chrysler below.
The problem could result in overheating and fuel leakage. Chrysler launched its investigation following cases of overheating, none of which actually started a fire, much less an injury or accident. As a precautionary measure, however, Chrysler is instructing service technicians to replace the terminals on an estimated 381,876 Ram units around the world - the vast majority of those (314,704) registered in the US, another 59,432 in Canada, 1,803 in Mexico and 5,937 abroad.

China's Geely says it has no plan to buy Fiat Chrysler — as FCA stock leaps

HONG KONG — Chinese carmaker Geely Automobile denied media speculation on Wednesday that it planned to make a takeover bid for Fiat Chryslerk Automobiles (FCA), the world's seventh-largest automaker. Geely was one of several Chinese carmakers cited in by Automotive News, which said representatives of "a well-known Chinese automaker" had made an offer this month for FCA, which has a market value of almost $20 billion. "We don't have such a plan at the moment," Geely executive director Gui Shengyue told reporters at an earnings briefing, when asked if Geely was interested in Fiat. He said a foreign acquisition would be complicated, but he did not elaborate. "But for other (Chinese) brands, it could be a fast track for their development," Gui added. However, a source close to the matter said FCA and Geely Automobile's parent firm, Zhejiang Geely Holding Group, had held initial talks late last year, without disclosing their nature. The source confirmed Geely was no longer interested in FCA, noting that the parent company had only three months ago announced its first push into Southeast Asia with the purchase of 49.9 percent of struggling Malaysian carmaker Proton, a deal that also included a stake in Lotus. Geel's denial failed to dent FCA's stock. The price of its Milan-based shares has jumped more than 10 percent to a 19-year high since Automotive News first reported on Monday, citing unnamed sources, that FCA had rejected the Chinese offer as too low. FCA stock on the New York Stock Exchange rose sharply on Monday from $11.60 to $12.38 and on Wednesday was trading at $12.84. FCA declined to comment on Wednesday. FCA Chief Executive Sergio Marchionne has repeatedly called for mergers as a way of sharing the costs of making cleaner, more advanced cars, but he has repeatedly failed to find a partner and retreated from his search for in April, saying FCA would stick to its business plan. He has also spoken of spinning the successful Jeep and Ram divisions off from FCA. Europe's largest carmaker, Volkswagen, and General Motors have both said they are not interested in talks with FCA. On Wednesday, Geely Automobile reported a doubling of first-half profit, above expectations, as cars designed with Sweden's Volvo won over domestic consumers. Volvo is a unit of the Zhejiang Geely group, and has recently announced it will share its technology with Geely.