2016 Ram 1500 Outdoorsman on 2040-cars

Auto blog

Chrysler recalling 67k trucks with manual transmissions

Earlier this month, Chrysler announced the recall of some 280,000 pickup trucks over concerns that their axles could seize up. Now the automaker has announced an entirely separate recall of another 66,819 trucks over the springs that could break in the clutch ignition interlock switch. The recall affects Dodge Ram 1500, 2500 and 3500 pickups, as well as the Dodge Dakota and Mitsubishi Raider. The issue is relevant only to those trucks fitted with manual transmissions, from the 2006 and 2007 model years and manufactured between July 1, 2005, and July 31, 2006. Since a broken spring could, according to statements issued by the National Highway Traffic Safety Administration and FCA US LLC (previously known as the Chrysler Group) prevent the vehicle from starting, or cause it to move unintentionally once the ignition kicks over, the automaker will begin notifying owners of the affected vehicles just before Valentine's Day to bring their trucks into their local dealers to have the clutch ignition interlock switch replaced. FCA emphasizes, however, that the unintended movement would only occur "in rare cases" and only "if recommended starting procedures are not followed." Only one such case is known to have occurred, but it did regrettably result in a fatality. Statement: Clutch Ignition Interlock Switch December 29, 2014 , Auburn Hills, Mich. - FCA US LLC is launching a voluntary global recall of an estimated 66,819 older-model pickup trucks equipped with manual transmissions. The Company will replace their clutch ignition interlock switches at no charge to customers. An investigation by FCA US engineers discovered switches in certain model-year 2006 and 2007 pickups may be equipped with spring wire that differs from wire used in previous switches. The alternate wire may break and, as a result, the vehicles may not start. In rare cases, a vehicle may – if recommended starting procedures are not followed – exhibit unintended movement when its ignition key is turned. The Company is aware of one fatality related to this campaign. It stemmed from the single known accident involving this population of vehicles. The recall covers certain Dodge Dakota, Dodge Ram 1500, 2500, 3500 and Mitsubishi Raider pickups. Switches with the alternate wire were not used in any vehicles produced before July of 2005, or after June of 2006. The Dakota and Raider are no longer in production.

Recall: The Ram 1500's driveshaft could fall off

Ram is recalling 10,160 pickups built for the 2018 and 2019 model years, because the driveshaft may fall off. That would be bad. The recall involves the previous-generation truck. Specifically, some units of the normal 2018 Ram 1500 and some of the 2019 Ram 1500 Classic. In Ram-speak, "Classic" means the previous-generation truck that's sold alongside the all-new version for 2019. The trucks involved were built in a month-long time period in 2018, and Ram has identified the problematic driveshafts by part number. Apparently, the rear driveshaft may "have an incomplete weld fusion between the tube and tube yoke, which may lead to weld cracking or the driveshaft fracturing," according to the recall documents. This could cause the driveshaft to drop off the vehicle, and cause you to lose drive power (among other hazards involved with a driveshaft falling off a truck). At this point, FCA says it's not aware of any accidents or injuries related to the problem. However, it has seen eight occurrences of the driveshafts breaking, prompting this voluntary safety recall. Ram says that an extra noise or vibration could signal that the driveshaft is on the way out. FCA is going to start notifying owners about the recall in mid-June. When you take your truck in, the dealer will replace your driveshaft with one verified to have complete weld fusion. It will, of course, be free of charge to the owners of the affected vehicles.

FCA looking into Ram-based SUV, midsize pickup

Fiat Chrysler Automobiles (FCA) is looking into manufacturing a large SUV based on the Ram 1500 pickup truck's current platform, reports USA Today. If built, the SUV would compete against the Chevrolet Tahoe and could even spawn a smaller pickup. Ram already has most of the bases covered with its current lineup, but a smaller pickup truck would allow it to enter the booming midsize pickup segment where it would compete with the segment-leading Toyota Tacoma along with the Chevy Colorado and GMC, which are the newest entries. Mike Manley, head of Fiat Chrysler's Jeep and Ram brands, told USA Today that the current platform found in the Ram 1500 could be utilized for a body-on-frame SUV. With a large SUV, FCA would be able to capitalize on the ever-growing SUV market and go toe-to-toe with General Motors (GM) and Ford. The next-generation of Ram pickup trucks is expected to go on sale in early 2018, which would put a large SUV close behind. In an attempt to increase the automaker's production capacity, FCA also plans to move Ram's current production facility from Warren to Sterling Heights, MI. With Jeep continually posting healthy numbers, it makes perfect sense for FCA to build more SUVs. GM currently uses the same platform on a plethora of its SUVs with good results, which makes FCA's proposed plan a viable option. Related Video: News Source: USA Today, Scott Olson/Getty RAM Truck SUV