2013 Ram 1500 Slt on 2040-cars

Auto blog

EPA suspected Fiat Chrysler of using 'defeat device' in 2015

U.S. regulators told Fiat Chrysler Automobiles in November 2015 that they suspected some of the automaker's vehicles were equipped with secret software allowing them to violate emission control standards, according to emails disclosed on Friday. The U.S. Environmental Protection Agency and California Air Resources Board accused Fiat Chrysler in January of using the software, known as a "defeat device," to illegally allow excess diesel emissions in 104,000 Jeep Grand Cherokees and Dodge Ram 1500 trucks built between 2014 and 2016. Byron Bunker, director of the EPA's Transportation and Air Quality compliance division, said in a January 2016 email to Fiat Chrysler, obtained by Reuters under the Freedom of Information Act, that he was "very concerned about the unacceptably slow pace" of the automaker's efforts to explain high nitrogen oxide emissions from some of its vehicles. Nitrogen oxide is linked to smog formation and respiratory problems. Bunker's email said the EPA had told Fiat Chrysler officials at a November 2015 meeting that at least one auxiliary emissions control device on the car maker's vehicles appeared to violate the agency's regulations. Mike Dahl, head of vehicle safety and regulatory compliance for Fiat Chrysler's U.S. unit, responded in a separate email that the company was working diligently and understood the EPA's concerns. He added that if the EPA identified Fiat Chrysler vehicles as containing defeat devices it would result in "potentially significant regulatory and commercial consequences." The documents redacted the vehicles named, but two officials briefed on the matter said they referred to diesel models. The EPA's November 2015 meeting with Fiat Chrysler came two months after Volkswagen AG, mired in a major tailpipe emissions scandal, admitted to installing secret defeat device software in hundreds of thousands of U.S. diesel cars to make them appear cleaner than they were on the road.

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

Autoblog Podcast #339

Farewell, Zach Bowman; Pikes Peak 2013; Datsun; 2014 Ram lineup
Episode #339 of the Autoblog Podcast is here, and it's the last rodeo for Zach Bowman before he departs for other pastures. The crew this week consists of Dan Roth, Zach Bowman and Jeff Ross, who talk about the astounding records set at this year's Pike's Peak hill climb, the return of the Datsun brand name and the recently-announced 2014 Ram truck lineup. Of course, we start with the garage and end with your questions and comments. For those of you who hung with us live on our UStream channel, thanks for taking the time. You can follow along after the jump with our Q&A. Thanks for listening!
Autoblog Podcast #339: