2020 Ram 3500 Tradesman/slt/laramie/limited on 2040-cars

Auto blog

Analysts wary over FCA lawsuit but say emissions not as bad as VW

MILAN - Any potential fines Fiat Chrysler (FCA) may need to pay to settle a US civil lawsuit over diesel emissions will unlikely top $1 billion, analysts said, adding the case appeared less serious than at larger rival Volkswagen. The US government filed a civil lawsuit on Tuesday accusing FCA of illegally using software to bypass emission controls in 104,000 vehicles sold since 2014, which it said led to higher than allowable levels of nitrogen oxide (NOx) that are blamed for respiratory illnesses. FCA's shares dropped 16 percent in January when the U.S. Environmental Protection Agency (EPA) first raised the accusations, adding the carmaker could face a maximum fine of about $4.6 billion. The stock has been under pressure since. Volkswagen agreed to spend up to $25 billion in the United States to address claims from owners, environmental regulators, U.S. states and dealers. FCA, which sits on net debt of 5.1 billion euros ($5.70 billion), lacks VW's cash pile but analysts said its case looked much less severe. While VW admitted to intentionally cheating, Fiat Chrysler denies any wrongdoing. Authorities will have to prove that FCA's software constitutes a so-called "defeat device" and that it was fitted in the vehicles purposefully to bypass emission controls. Even if found guilty, the number of FCA vehicles targeted by the lawsuit is less than a fifth of those in the VW case. Applying calculations used in the German settlement, analysts estimate potential civil and criminal charges for Fiat Chrysler of around $800 million at most. Barclays has already cut its target price on the stock to take such a figure into account. Analysts also noted that FCA's vehicles are equipped with selective catalytic reduction (SCR) systems for cutting NOx emissions, so it is likely that any problem could be fixed through a software update. "Should this be the case, we estimate a total cost per vehicle of not more than around $100, i.e. around $10 million in aggregate," Evercore ISI analyst George Galliers said in a note. The estimates exclude any additional investments FCA may be asked to make in zero emissions vehicles infrastructure and awareness as was the case with VW. FCA said last week it would update the software in the vehicles in question, hoping it would alleviate the regulators' concern, but analysts said it may have been too little too late. The carmaker is also facing accusations over its diesel emissions in Europe.

Chrysler recalls AWD 300, Charger, Ram 1500 over ZF transmission

What do the Chrysler 300, Dodge Charger and Ram 1500 all have in common? Yes, they're all Chrysler products, and two of them are based on the same platform. And we're sure you could find more similarities between them all, but the common trait we're looking at here is that, while they all come standard in rear-drive form, they're also available with all-wheel drive. And it's the transmission in those models that's the subject of the latest recall notice issued by the National Highway Traffic Safety Administration.
The output shaft on the eight-speed automatic transmission supplied by ZF to Chrysler for the AWD versions of the 300, Charger and Ram 1500 is apparently prone to fracture. That in the end could leave the vehicle without power and could, according to the NHTSA investigation, increase the chance of a crash. The vehicle could also roll away if even if left in Park without the handbrake applied.
That's why Chrysler is calling in 4,194 examples of those three models from the 2013 model year. Dealers will be responsible for inspecting the transmissions and, where necessary, replace the entire unit. See the full recall notice below for all the details.

2019 Ram 1500 pickup production problems costing FCA $300M to fix

Fiat Chrysler is spending more than $300 million to fix production issues with the new 2019 Ram 1500 pickup as the plant where it's built is running below capacity and suppliers reportedly struggle to keep up with building it and the 2018 version simultaneously. The truck's ramp-up is well behind schedule, Automotive News reports. FCA's Sterling Heights Assembly plant in Michigan began building the pickup in mid-January but is running at only 60 percent capacity, CEO Sergio Marchionne said on an earnings call last week. Sources told the publication the plant is still undergoing construction and was building about 1,000 trucks per day toward a run rate of 1,400 per day. It's operating two 10-hour shifts per day, seven days a week, with plans to keep the factory running every weekend and holiday through Labor Day to meet production targets. More than 2,500 of the new pickups were reportedly awaiting unspecified electrical repairs before they could be shipped. FCA could use the boost from the heralded new 2019 Ram 1500, which figures prominently in its aggressive annual financial goals. The company is relying on the previous-generation 2018 Ram 1500, demand for which has been sagging. First-quarter sales of the pickup are down almost 13 percent year over year to 103,964, according to carsalesbase.com figures. Meanwhile, sales of Ford's F-Series pickups over the same period rose 4 percent to 214,191, while Chevrolet Silverado sales have climbed 5 percent to 135,545. Dealers have started receiving deliveries of the 2019 Ram 1500, but only the version fitted with the 5.7-liter V8. The EPA has yet to issue fuel economy ratings for the standard 3.6-liter Pentastar V6 paired with the eTorque 48-volt mild hybrid system, nor the same system mated with the V8. As we noted in our recent First Drive review, upgrading to the (non-hybrid) V8 costs $1,195, which is actually $255 cheaper than before. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Image Credit: FCA Plants/Manufacturing RAM Truck sales