2012 Ram 3500 Longhorn Mega Cab Xd Series Chrome Wheels on 2040-cars

Auto blog

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.

Ram recalls HD pickups for loose windshield wipers

Ram is recalling heavy-duty pickups (Ram 2500, 3500, 4500 and 5500) built between April 27, 2019, and March 9, 2020, to address a potentially defective windshield wiper design that can result in loose and/or underperforming wipers that don't rotate properly on their pivot arms when activated.  "Some 2019-2020 MY Ram [...] vehicles may have been built with one or both windshield wiper arms with an improperly formed wiper arm head joint," Ram said in its defect notice to NHTSA. "An improperly formed wiper arm head joint may not properly form the splines of the head joint on the wiper arm, which can allow the joint to strip and result in the wiper arm failing to operate properly when the system is activated." "An improperly functioning wiper system may, in certain circumstances, lead to a diminution in road visibility which can cause vehicle crash without prior warning," it said.  Symptoms of a defective wiper arm head joint could be similar to the diminished performance of a worn wiper blade, but vehicles with the defect may exhibit other warning signs, such as wiper blades that don't sit in their normal "rest positions" (Ram's words, not ours) when set to "off."  Dealers will tighten the nuts on the wiper arm head joints for customers as part of the campaign.  Recalls RAM Truck Commercial Vehicles

Three Ram recalls affect more than a million pickups

Millions of Ram pickups across many of its model lines in the US are in need of recall repairs due to three campaigns by the truck maker. The largest of this trio covers 1.06 million examples in the US of the 2012-2014 Ram 1500, 2500, 3500, and chassis cab versions of the 3500, 4500, and 5500 because of potential inadvertent driver-side airbag deployment. In addition to those affected here, there are 235,925 in Canada, 26,543 in Mexico, and 23,635 elsewhere. There are also two related injures from this problem, but no reports of accidents, according to the company. While the recall was mysteriously ignored in the media at the time, the National Highway Traffic Safety Administration announced details of this campaign in late July. The next largest among the three covers 188,000 examples of the 2014 and 2015 Ram 1500 Quad Cab in the US because their side-curtain airbags don't fully overlap the C-pillars when deployed, which is in violation of federal rules. Conceivably, rear passengers not wearing their seatbelt could be more likely to be ejected in a crash. Ram's repair for the issue is still being developed, according to the National Highway Traffic Safety Administration, but the company advises all occupants to be buckled in. The final campaign affects 156,498 the company's heavy-duty trucks in the US, including the 2013 Ram 3500 and 2014 Ram 2500, 3500, and 3500 Chassis Cab. In addition, there are 20,603 in Canada and 3,241 elsewhere. Of the 13,236 in Mexico, a few units of the 2014 Ram 1500 exclusive to that market are also covered. The company found that the welds for some steering parts might have "insufficient fusion." If the part breaks, then vehicles are still controllable but with diminished response. There are no reported injuries but one minor accident. The fix involves installing a reinforcement bracket. Related Video: Statement: Steering-wheel Wiring Harness September 10, 2015 , Auburn Hills, Mich. - FCA US LLC is conducting a voluntary safety recall to inspect and service, as required, wiring harnesses in an estimated 1.06 million U.S.-market trucks. Investigation by FCA US discovered certain trucks may have steering-wheel wiring harnesses that wear because of contact with a spring. Such wear may cause a short-circuit that may lead to inadvertent driver-side air-bag deployment. The Company is aware of two related injuries, but no accidents.