12 Ram 3500 Mega Cab Slt 6.7l I6 Diesel Lone Star Edition! on 2040-cars

Auto blog

Recall: The Ram 1500's driveshaft could fall off

Ram is recalling 10,160 pickups built for the 2018 and 2019 model years, because the driveshaft may fall off. That would be bad. The recall involves the previous-generation truck. Specifically, some units of the normal 2018 Ram 1500 and some of the 2019 Ram 1500 Classic. In Ram-speak, "Classic" means the previous-generation truck that's sold alongside the all-new version for 2019. The trucks involved were built in a month-long time period in 2018, and Ram has identified the problematic driveshafts by part number. Apparently, the rear driveshaft may "have an incomplete weld fusion between the tube and tube yoke, which may lead to weld cracking or the driveshaft fracturing," according to the recall documents. This could cause the driveshaft to drop off the vehicle, and cause you to lose drive power (among other hazards involved with a driveshaft falling off a truck). At this point, FCA says it's not aware of any accidents or injuries related to the problem. However, it has seen eight occurrences of the driveshafts breaking, prompting this voluntary safety recall. Ram says that an extra noise or vibration could signal that the driveshaft is on the way out. FCA is going to start notifying owners about the recall in mid-June. When you take your truck in, the dealer will replace your driveshaft with one verified to have complete weld fusion. It will, of course, be free of charge to the owners of the affected vehicles.

Three Ram recalls affect more than a million pickups

Millions of Ram pickups across many of its model lines in the US are in need of recall repairs due to three campaigns by the truck maker. The largest of this trio covers 1.06 million examples in the US of the 2012-2014 Ram 1500, 2500, 3500, and chassis cab versions of the 3500, 4500, and 5500 because of potential inadvertent driver-side airbag deployment. In addition to those affected here, there are 235,925 in Canada, 26,543 in Mexico, and 23,635 elsewhere. There are also two related injures from this problem, but no reports of accidents, according to the company. While the recall was mysteriously ignored in the media at the time, the National Highway Traffic Safety Administration announced details of this campaign in late July. The next largest among the three covers 188,000 examples of the 2014 and 2015 Ram 1500 Quad Cab in the US because their side-curtain airbags don't fully overlap the C-pillars when deployed, which is in violation of federal rules. Conceivably, rear passengers not wearing their seatbelt could be more likely to be ejected in a crash. Ram's repair for the issue is still being developed, according to the National Highway Traffic Safety Administration, but the company advises all occupants to be buckled in. The final campaign affects 156,498 the company's heavy-duty trucks in the US, including the 2013 Ram 3500 and 2014 Ram 2500, 3500, and 3500 Chassis Cab. In addition, there are 20,603 in Canada and 3,241 elsewhere. Of the 13,236 in Mexico, a few units of the 2014 Ram 1500 exclusive to that market are also covered. The company found that the welds for some steering parts might have "insufficient fusion." If the part breaks, then vehicles are still controllable but with diminished response. There are no reported injuries but one minor accident. The fix involves installing a reinforcement bracket. Related Video: Statement: Steering-wheel Wiring Harness September 10, 2015 , Auburn Hills, Mich. - FCA US LLC is conducting a voluntary safety recall to inspect and service, as required, wiring harnesses in an estimated 1.06 million U.S.-market trucks. Investigation by FCA US discovered certain trucks may have steering-wheel wiring harnesses that wear because of contact with a spring. Such wear may cause a short-circuit that may lead to inadvertent driver-side air-bag deployment. The Company is aware of two related injuries, but no accidents.

Chrysler readying 20 Moparized vehicles for SEMA

The Las Vegas Convention Center has plenty of space for aftermarket companies and automakers to show off their wares, and it looks like Chrysler is taking advantage of the spacious floor plan. At next month's SEMA Show, Chrysler will have a full 20 cars from its six brands decked out with Mopar gear.
As a hint of what is to come, Chrysler released a handful of teaser sketches showing glimpses of modified Jeep Cherokee, Ram 1500, Fiat 500L and Chrysler 300 concept vehicles. The automaker will also use the venue to show off a new line of Jeep Performance Parts offered by the all-new Mopar Off-Road Division. In addition to the images, Chrysler also issued a brief press release - posted below - breaking down some of the "industry-first features" that Mopar has offered in recent years.