2019 Ram 1500 Big Horn W/add-ons on 2040-cars

Auto blog

Ram recalling 1,747 diesel trucks for short-circuit risk

Diesel-powered Ram owners, it's recall time. Fiat Chrysler Automobiles has announced a voluntary recall of 1,747 Ram 1500 EcoDiesels from model years 2014 and 2015. Why so few? Well, this campaign is limited to just rear-wheel-drive models. The problem, this time around, is with a battery wiring harness that will chafe against a bracket if it wasn't assembled properly. This chaffing can lead to a short, causing a loss of power (the best-case scenario) or even a fire (probably the worst-case scenario). Fortunately, FCA is unaware of any accidents, fires, or other injuries caused by short circuits. The affected vehicles were sold in both the US and Canadian markets, although the vast majority of the trucks, 1,697 to be precise, are here in the land of the free and home of the brave. The remaining 50 vehicles were sold in Canada, and were likely purchased by those crazy enough to drive a high-torque, rear-drive pickup in a country almost perpetually covered in snow and ice. Regardless of whether your truck has an illuminated dashboard warning light or not, FCA is encouraging drivers of the affected vehicles to report to dealers for a free service when they receive a recall notice. Scroll down for the official press release from FCA, as well as the bulletin from the National Highway Traffic Safety Administration. Statement: Wiring Harness September 9, 2015 , Auburn Hills, Mich. - FCA US LLC is recalling an estimated 1,747 trucks in the U.S. and Canada to inspect, reroute and replace – as required – their wire harnesses to prevent a potential short-circuit. An investigation by FCA US discovered a battery wiring harness may chafe against a bracket if assembly protocols were not followed. This condition is limited to vehicles equipped with diesel engines and 4x2 drivelines. Such a condition has the potential to cause a short-circuit, which may lead to power loss or fire. The Company is unaware of any related injuries, accidents or fires. The campaign is limited to certain 2014-15 Ram 1500 pickups. It is estimated there are 1,697 in the U.S. and 50 in Canada. Affected customers will be advised next month when they may schedule service, which will be performed at no cost. While the condition may not be present in every vehicle, FCA US urges customers to note the information on their recall notices and respond accordingly. Illumination of a dashboard warning light is among the indicators that the condition is present.

Chrysler recalling 382k Ram HD diesel pickups, 184k SUVs

Between GM's ignition switches and Takata's airbags, it's been a big year for recalls, but they keep rolling in. The latest comes from Chrysler, which has announced a pair of recalls for certain heavy-duty pickups and SUVs.
The first issue revolves around the 6.7-liter Cummins diesel engine available in the 2010-2014 Ram HD trucks, including 2500 and 3500 series pickups as well as 4500 and 5500 series chassis cabs. In the affected units, "a terminal connector near the fuel heater may be subject to friction-induced corrosion," according to the first of the two announcements from Chrysler below.
The problem could result in overheating and fuel leakage. Chrysler launched its investigation following cases of overheating, none of which actually started a fire, much less an injury or accident. As a precautionary measure, however, Chrysler is instructing service technicians to replace the terminals on an estimated 381,876 Ram units around the world - the vast majority of those (314,704) registered in the US, another 59,432 in Canada, 1,803 in Mexico and 5,937 abroad.

2019 Ram 1500 pickup production problems costing FCA $300M to fix

Fiat Chrysler is spending more than $300 million to fix production issues with the new 2019 Ram 1500 pickup as the plant where it's built is running below capacity and suppliers reportedly struggle to keep up with building it and the 2018 version simultaneously. The truck's ramp-up is well behind schedule, Automotive News reports. FCA's Sterling Heights Assembly plant in Michigan began building the pickup in mid-January but is running at only 60 percent capacity, CEO Sergio Marchionne said on an earnings call last week. Sources told the publication the plant is still undergoing construction and was building about 1,000 trucks per day toward a run rate of 1,400 per day. It's operating two 10-hour shifts per day, seven days a week, with plans to keep the factory running every weekend and holiday through Labor Day to meet production targets. More than 2,500 of the new pickups were reportedly awaiting unspecified electrical repairs before they could be shipped. FCA could use the boost from the heralded new 2019 Ram 1500, which figures prominently in its aggressive annual financial goals. The company is relying on the previous-generation 2018 Ram 1500, demand for which has been sagging. First-quarter sales of the pickup are down almost 13 percent year over year to 103,964, according to carsalesbase.com figures. Meanwhile, sales of Ford's F-Series pickups over the same period rose 4 percent to 214,191, while Chevrolet Silverado sales have climbed 5 percent to 135,545. Dealers have started receiving deliveries of the 2019 Ram 1500, but only the version fitted with the 5.7-liter V8. The EPA has yet to issue fuel economy ratings for the standard 3.6-liter Pentastar V6 paired with the eTorque 48-volt mild hybrid system, nor the same system mated with the V8. As we noted in our recent First Drive review, upgrading to the (non-hybrid) V8 costs $1,195, which is actually $255 cheaper than before. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Image Credit: FCA Plants/Manufacturing RAM Truck sales