2014 Ram 1500 Tradesman/express on 2040-cars

Auto blog

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

2020 Ram 1500 EcoDiesel fuel economy numbers are right in the zone

Every new truck spec gets it own awards show nowadays. In this next envelope we have EPA fuel economy ratings for the 2020 Ram 1500 EcoDiesel — drumroll, please: 22 miles per gallon in the city, 32 mpg highway, 26 mpg combined for the 4x2 trim; 21 mpg city, 29 mpg highway, 24 mpg combined for the 4x4. As one would expect, the numbers plop the EcoDiesel in the middle of the pot with light-duty diesel versions of the 2020 Chevrolet Silverado 1500 and 2019 Ford F-150. In 4x2 guise, city mileage for the EcoDiesel ties the F-150 and is one mpg short of the Silverado, highway mileage rates two mpg more than the F-150 and one mpg short of the Silverado. In 4x4 trim, EcoDiesel city mpg is one mpg more than the F-150 and two mpg short of the Silverado, EcoDiesel highway number is four mpg more than the F-150 and ties the Silverado.    Of course, Ram would also like you to know that when it comes to output and carrying, the third-generation oil-burner tops the half-ton trio with 480 pound-feet of torque, 20 lb-ft more than the Silverado, and posts the highest tow rating at 12,560 pounds. Buyers who opt for the 4x2 diesel Ram and the 33-gallon tank will be able to travel the furthest, too, going beyond 1,000 miles before the fumes give out. Every trim gets the new EcoDiesel option for 2020, including the Ram Rebel for the first time. The 3.0-liter V6 is a $4,995 option, making it either $3,000 or $3,300 more than the 5.7-liter Hemi V8 eTorque trim depending. The EcoDiesel price ladder starts with the Tradesman Quad Cab at $36,890 plus a $1,695 destination charge, for $38,585 total. The 2019 Ram 1500 Classic will continue offering the second-generation 3.0-liter EcoDiesel, starting at the unchanged price of $40,835 for the Tradesman Crew Cab 4x2.

Maxwell RHEV Prototype First Drive Review | More than meets the eye

The Maxwell RHEV looks just like any small business' panel van, sporting large vinyl graphics and unassuming steel wheels. You'd have no idea that the co-founders of the startup based out of Seattle had grafted a salvaged Voltec powertrain from a junkyard Chevy Volt into this Ram ProMaster. Somewhere, a battery pack lurks. Maxwell's co-founders, CEO Max Pfeiffer and engineer Trey Camp, open the cargo area to reveal a completely unaltered space. Both are ex-Tesla employees with a long fascination for the #vanlife movement – that their interests intersected in a hybrid cargo van isn't surprising once you start talking to them. This is their first vehicle, a salvaged ProMaster sidelined with a blown 3.6-liter Pentastar, and it's both their prototype and the only Maxwell in existence right now. That said, the company is building a low-roof version for a customer, which will be lighter, have less aero drag and therefore be more efficient. The company is just emerging from a stealth startup mode, and while their backstory is fascinating, I'm still wondering where the Volt's 18.4 kWh battery pack is. "There's nothing in the back ... we're able to get the battery underneath the floor, in the center," Pfeiffer says. Ducking my head under the side reveals, sure enough, a little underside blister that contains the battery, tucked up neatly. The other changes to the RHEV – short for Range-extended Hybrid Electric Vehicle – are minimal. He pops the hood. There are some rough edges, but the 1.5-liter, 101-horsepower engine and 48-kW motor fit comfortably on custom engine mounts and with re-routed exhaust, behind a fascia that improves aero and houses the charge port. Custom axles send power to unaltered Ram hubs and brakes. "This version, it's a little bit prototype-y," Pfeiffer says. "We've had more time to work with the CAD [computer-aided design, engineering drawings] we were able to get from GM and Chrysler, and we've done a better job packaging for production." GM already spent billions on the Voltec and its controlling software, and Maxwell can happily ride those coattails. Despite the help GM has lent Maxwell, there are no official ties. An emulator sends spoofed signals to the Ram instruments, which have a new custom-printed face. The Ram's body control module is left alone. For powertrain faults, Maxwell says the vehicle can theoretically be serviced by any Chevy dealer, and any issue with the rest of the vehicle can be handled by a Ram service shop.