2013 Ram 1500 on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Ford F-450 claims best-in-class towing, company abandons practice of removing items to boost payload number

The ongoing heavy-duty truck battle between Ford and Ram is showing no signs of slowing down. The Blue Oval is trying to remove at least one point of contention between the two brands by testing its 2015 F-450 Super Duty using the Society of Automotive Engineers J2807 towing standard, which Ram also uses. In the new evaluation, the F-450 is rated at a max towing capacity of 31,200 pounds. That's an identical amount as under Ford's own, previous test.
"We leave no doubt with customers that the F-450 pickup truck has best-in-class towing of 31,200 pounds - whether tested using our own internal towing standards or SAE J2807," said Raj Nair, Ford group vice president for Global Product Development, in the company's release.
At the same time, Ford is also changing how it calculates the F-450's payload. Instead of using its minimum curb weight as before, the brand is now using the truck's base curb weight. The revision lowers the pickup's rating to 5,300 pounds, compared to 5,450 pounds previously. The company said in its announcement that the reason for this is "aligning its payload rating practices with other manufacturers to make it easier for customers to compare vehicles." General Motors made a similar switch for its pickups in August.

Fiat/PSA's dominance in small vans hangs up EU's merger approval

BRUSSELS — EU antitrust regulators are concerned about Fiat Chrysler and Peugeot / PSA's combined high market share in small vans and may require concessions to clear their $50 billion merger, people familiar with the matter said. The companies, which are seeking to create the world's fourth biggest carmaker, were told of the European Commission's concerns last week. If Fiat and PSA fail to dispel the European Commission's doubts in the next two days and subsequently decline to offer concessions by Wednesday, the deadline for doing so, the deal would face a four-month-long investigation. The EU competition enforcer, which has set a June 17 deadline for its preliminary review, declined to comment. Fiat was not immediately available for comment while PSA had no immediate comment. Hiving off overlapping businesses, usually a regulatory demand to ensure more competition, could prove tricky for the carmakers because of the technicalities. Fiat and PSA are looking to merge to help offset slowing demand and shoulder the cost of making cleaner vehicles to meet tougher emissions regulations. The deal puts under one roof the Italian carmaker's brands such as Fiat, Jeep, Dodge, Ram, Maserati and the French company's Peugeot, Opel and DS. Related Video: Government/Legal Chrysler Dodge Fiat Jeep Maserati RAM Citroen Opel Peugeot