2019 Ram 1500 Classic Express on 2040-cars

Auto blog

Detroit Three automakers and UAW will continue to require masks

GM CEO Mary Barra at a Warren, Mich., training center in September. (Reuters)   WASHINGTON — Detroit's Big Three automakers and the United Auto Workers (UAW) union said on Wednesday that workers will continue to be required to wear masks in workplaces. The joint statement from the UAW and General Motors, Ford and Chrysler-parent Stellantis NV said it was continuing the requirements "out of an abundance of caution." The U.S. Centers for Disease Control and Prevention (CDC) said in May that fully vaccinated people do not need to wear masks in most instances, including at work. The UAW and the automakers said temperature screening upon entering facilities is expected to be phased out. The UAW and automakers continue to recommend autoworkers get vaccinated. Many U.S. employers are still requiring vaccinated workers to wear masks in workplaces. Volkswagen AG's U.S. unit said it will "no longer require masks for fully vaccinated employees after June 21, and will continue to follow CDC guidelines." Toyota is among the automakers that has ended temperature checks and entry questionnaires at U.S. plants but it is continuing to require facial coverings. Honda and Nissan said they had made no changes to their U.S. employee COVID-19 requirements.   Plants/Manufacturing Chrysler Dodge Ford GM Jeep RAM Safety coronavirus

Common Dodge Ram 1500 vs. Chevrolet Silverado breakdowns

These two trucks are famous for their ability to get the job done. Still, even the toughest vehicle can have mechanical problems at some time. What if we match the Dodge Ram 1500 and Chevrolet Silverado head to head? Let's find out more about common repairs for each model. Also, learn some tricks to pay for car repairs. Clunky Steering Both Dodge and the Chevy owners sometimes notice bumping and clunking when steering. This might be more noticeable when driving over bumps. The cause is usually different in each truck though. In the Dodge Ram, clunky steering is more likely due to a defective lower ball joint. Replacement costs around $300 - $400, parts and labor. Clunky Chevy Silverado steering is probably a steering rack failure. This problem appears more often in trucks with over 90,000 miles. Silverado steering rack repair will run you up to $1,000 or more. Starting Woes For the Chevy Silverado with over 130,000 miles, you might notice trouble starting. This problem may appear occasionally at first, but it typically gets worse. Excluding a weak battery, the culprit is usually the starter. Replacement will cost you around $330 - $500. Of the total cost, $90 is for labor only. Now the Dodge Ram might make a ticking sound when starting, especially on models with over 94,500 miles. The noise often disappears after the engine warms up. These symptoms may indicate a broken exhaust manifold. Repair costs range from $800 - $900. Burning Oil & Gas Gauge On The Blink Sometimes, the Dodge Ram burns oil much faster than normal. In models with over 125,000 miles, this often points towards a leaky intake manifold gasket. A knocking sound may also appear with acceleration along with possible engine misfire. The cost to repair is around $200 - $300. The Chevy Silverado has its own surprises, especially when you've filled the gas tank but the gauge still reads low. Or the needle fluctuates widely from low to full while driving. In trucks with over 120,000 miles, it's likely due to a faulty fuel sensor. You might need a full fuel pump replacement, which can cost you up to $820, parts and labor. Water Inside And Poor Heat The Ram 1500 rear window has been known to leak. You might notice the back seat and floor wet after a rainstorm. This is more common in trucks with over 65,000 miles. Resealing the Ram 1500 rear window costs around $150 - $250.

2019 Ram 1500 spotted with split tailgate

A little over three years ago, we discovered a patent from Fiat-Chrysler that showed a pickup truck tailgate that not only dropped down like a normal one, but was also split into two swing-out halves. It appears to be a reality now, since one of the Ram 1500 prototypes shown above has just such a tailgate. The tailgate above does look a bit different from the one shown in the patent drawings. For one thing, it's not a 50/50 split in the middle. Instead, Ram seems to have opted for something like a 60/40, or maybe 70/30 split. We're not sure exactly why this is, but there could be a few advantages. For one, It probably allows for the use of the same or nearly the same handle as on conventional Rams, as well as the same badging. For another, if the tailgate operates as described in the patent, it might be possible to open just one side without opening the other, and having the shorter piece could offer some flexibility in tight areas where a larger half couldn't open fully. Testing alongside the split tailgate truck were some other Ram 1500s that had their tailgates completely covered. They did reveal some other cargo management features that should show up on the production truck, such as a return of the RamBox bedside storage compartments. One of the trucks also revealed some ribbed bedsides that would allow the positioning of a cargo divider just about anywhere in the bed. We expect to see the new Ram 1500 to be fully revealed at the Detroit Auto Show in January. In the meantime, you can check out what we believe the production truck will look like, as well as everything we know about it, here. Related Video: