1971 Pontiac Lemans Sport Convertible Restomod 400ci 200r4 Od Restored Showcar on 2040-cars

Auto blog

Junkyard Gem: 1986 Pontiac Fiero GT

If you like affordable, mid-engined two-seaters, the 1980s were your decade. Fiat (and, a bit later, Bertone) offered the X1/9, Toyota sold MR2s, and even General Motors got into the act by creating the Fiero. Available from the 1984 through 1988 model years, the Pontiac Fiero showed plenty of promise but ended up being mostly disappointing, in some ways echoing the career of the Chevy Corvair of a couple of decades earlier. Today's Junkyard Gem is a once-spiffy 1986 Fiero GT, found in a self-service yard near Denver, Colorado. After a long and painful development period stretching all the way back to John DeLorean's XP-833 Banshee (which ended up being a major influence behind the original Opel GT), the Fiero finally debuted in 1983 as a 1984 model. The top-of-the-model-range GT appeared the following year. The Fiero was built as a notchback coupe and as a fastback, with all the GTs being the latter type. I couldn't get the engine lid open, but this car would have left the assembly line (in Pontiac, Michigan) with a 2.8-liter V6 rated at 140 horsepower. This car has a five-speed manual transmission, making it a credible rival for Toyota's MR2.  The 1986 MR2 was less powerful than the Fiero GT (112 horsepower versus 140), but also scaled in significantly lighter (2,459 pounds against the Pontiac's 2,780 pounds). The MR2 also cost less, priced at $11,298 while the Fiero GT cost $12,875 (that's about $30,540 and $34,805, respectively, in inflation-adjusted 2022 dollars). Meanwhile, the $6,998 Honda Civic CRX two-seater lured away many potential Fiero buyers despite being a front-engined/front-wheel-drive car, and the $7,186 Ford EXP/Mercury LN7 also put a dent in Fiero sales. I can't find a price for the 1986 Bertone X1/9, but it cost a hard-to-believe $13,990 in 1984. GM still was using five-digit odometers in many vehicles by the middle 1980s, but this Fiero has a six-digit unit and thus we can see that it nearly achieved 150,000 miles during its driving career. The 1984-1987 Fiero suffered from a parts-bin suspension design, with the front suspension borrowed from the Chevrolet Chevette and the entire rear transaxle/suspension assembly lifted from the front end of the Chevrolet Citation. For the 1988 model year, GM finally spent the money to design an improved Fiero-specific suspension … and then promptly put a halt to production.

Junkyard Gem: 2000 Pontiac Grand Prix Daytona 500 Edition

The W Platform proved to be extremely long-lived and versatile for General Motors, remaining in production from 1988 all the way through 2016. You had your Impalas and your Regals and your Cutlass Supremes, and of course the 1988-2008 Pontiac Grand Prix was a W-body. For the 2000 model year, Pontiac made the racy-looking Daytona 500 Edition Grand Prix, an example of which I just found in a Northern California self-service wrecking yard. 2,000 of these cars were made, presumably because it was the year 2000, and each one sports plenty of cool-looking Daytona 500 graphics. Perhaps some Regal owner will buy these seats and swap them. This is the second junked Daytona 500 Grand Prix I have seen recently, after this one in Colorado. The Daytona 500 was about the same as the GTP version, with Eaton-supercharged 3800 engine making a respectable 240 horsepower. Disappointingly, this car has an automatic transmission. It never saw 150,000 miles, unlike most 21st-century W-bodies I see in wrecking yards. Featured Gallery Junked 2000 Pontiac Grand Prix Daytona 500 Edition View 21 Photos Auto News Pontiac Sedan

2020 Porsche 911 Speedster spied with an angry driver

Porsche gave us details and showed us a concept of the 911 Speedster at the Paris Motor Show. Today, we bring you spy shots of what appears to be the production version of that concept with a few changes on board. They're rather minimal modifications, but the Speedster's driver appears especially angry with our spy photographer as he extends his middle finger directly toward the camera. Sorry, not sorry, Mr. Test Driver. Public testing of pre-production cars always comes with photo risks, and Porsches tend to attract more attention than others. You'll notice what appears to be a Cayenne Coupe prototype we've previously spotted running around with the 911. The Speedster Concept we saw in Paris had epic retro mirrors and fuel cap on the front hood, but both those design touches are absent from this pre-production car. It's tougher to see, but we lost the vents in between the two humps, as well. Everything else appears to have made it to production-spec. We can't say we're surprised these concept car features probably won't show up on the production car, but it is a tad deflating. You'll notice the Speedster is based-off the 991.2 generation of 911 and not the new 992. Porsche did a similar thing when the 997 generation was coming to an end with a Speedster model paying tribute to that car's life. The chassis is said to utilize parts from the 911 GT3, and the wonderful naturally aspirated flat-six engine gets carried over from that car, too. Porsche didn't specify if power will be exactly the same as the GT3, but we'll be expecting about 500 horsepower and a 9,000 rpm redline. We were told the six-speed manual would be offered on the Speedster in Paris, too. Let's just say that we strongly approve of that combination. Production will be limited to only 1,948 cars and begin in the first half of this year. We'll expect a reveal with a full spec breakdown soon, possibly for the upcoming Geneva Motor Show. Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.