2005 Gto 8000 Miles Cyclone Gray Metallic on 2040-cars

Auto blog

Junkyard Gem: 2010 Pontiac Vibe

Just over a month before filing for Chapter 11 bankruptcy in June 2009, General Motors announced that the 83-year-old Pontiac Division would be "phased out" by the end of 2010. Only three Pontiac vehicles were sold as 2010 models in the United States: the Solstice, Vibe and G6 (new G3s were sold here during 2010 but they were all 2009 models, while the G5 was available as a 2010 model only in Canada and Mexico). Today's bit of junkyard automotive history is one of the very last Vibes ever built, found in a yard near Denver, Colorado. This car is significant not just as one of the final vehicles to bear Pontiac badges but also as one of the last cars built by the New United Motor Manufacturing Incorporated GM-Toyota joint venture in California, better known as NUMMI. The NUMMI factory began life as GM's Fremont Assembly, which built its first vehicle (a C-Series pickup) in 1963 and closed in 1982 after building its final vehicle (an Oldsmobile Cutlass Ciera). Rebooted as NUMMI, the first 1985 Chevrolet Nova (an Americanized AE82 Toyota Corolla Sprinter) rolled off the line in December of 1984. A quarter-century and better than eight million vehicles hence, NUMMI shut down production after its last Corolla was finished on April 1, 2010. While there was some noise about the Oakland Athletics building a new stadium on the site at the time, Tesla ended up buying most of the site soon after that. Tesla now builds more vehicles per year there than NUMMI ever did. The Vibe was co-developed with Toyota and based on the same platform as the ninth-generation Corolla. The Toyota Matrix was mechanically identical and was built in Canada, while the Japanese-market version (known as the Toyota Voltz) was built on the same NUMMI line as the Vibe and shipped across the Pacific. The Vibe/Matrix/Voltz got a redesign for the 2009 model year, but few noticed due to all the turmoil in the GM world at the time. The final Vibe was built in August 2009. This car was built in July of 2009, just before the end. It was living in West Texas just prior to coming to Colorado. El Paso is about a ten-hour drive from this car's current location. Once in the Centennial State, it got parked somewhere it shouldn't have been and ended up being auctioned to Pick Your Part. An occupant of this Vibe had time to sample some of the local agricultural products before that happened.

Junkyard Gem: 1986 Pontiac Fiero 2M4

The mid-engined, plastic-bodied Pontiac Fiero two-seater caused great excitement when it hit the streets as a 1984 model, then became something of an embarrassment for GM when its design flaws became clear to the car-buying public. Still, when a V6 engine became available for 1985, followed by a fastback roof for 1986, the air of Pontiac Excitement around the Fiero lingered to a certain extent. We took a look at a discarded '86 Fiero GT with both the 2.8-liter V6 and the fastback body last year, and now we'll take a look at an example of the econo-commuter four-cylinder notchback version from the same year. Pontiac used the 2M4 designation (standing for two seats, mid-engine, four cylinders) on four-cylinder Fieros, while the six-cylinder cars were known as 2M6s. 2M4 decals went on four-banger Fieros for the 1984-1986 model years, while 2M6 decals seem to have been applied less consistently to the V6 cars of that period. During the early development period of the car that became the Fiero, the idea was that it would be a nimble sports car with a lightweight engine. Then the plan shifted, with the Fiero intended to be a gas-sipping commuter. When the car finally hit showrooms, it was a lot heavier than intended, it had a Chevy Citation front suspension in the back plus a Chevette front suspension, and its engine was the low-revving, weighty Iron Duke 2.5-liter straight-four. The Duke was about the least sports-car-appropriate four-cylinder engine The General could dredge up from his parts bins, but it was cheap and there was no shortage of production capacity. By the time the Fiero came out, the Iron Duke had been renamed the Tech 4. This one was rated at 92 horsepower and 132 pound-feet. The V6 Fieros get all the press today, but plenty of the Duked versions were sold (amazingly, the Chevrolet Camaro was available with Iron Duke power from 1982 through 1986). The emissions sticker tells us that this was a California-market car, rather than the "49-state" model the rest of the country got. California-specific emissions hardware added $99 to this car's price ($277 in 2023 dollars). While this car is a base model, the original buyer loaded it with options. The transmission is a three-speed automatic, priced at $465 (about $1,303 in 2023 dollars). A five-speed manual was standard equipment on the 1986 Fiero, though the old-fashioned four-speed manual was still available for a $50 credit ($140 now).

Hurst Edition Trans Am proves the Screaming Chicken will rise from the ashes

It seems the Pontiac Trans Am steadfastly refuses to die. Ever since Chevrolet was granted a retrofied Camaro to compete with the Ford Mustang, Pontiac lovers have lamented the loss of this 1970s icon. And, looking at the Hurst Edition from Trans Am Depot, shown here at the 2012 SEMA Show, may explain what all the fuss is about.
It's not going to appeal to everyone's muscle-car tastes, but there's certainly room for a brash-and-bold black-and-gold Special Edition in many a Trans Am lover's garage. After all, if you want the keys to a custom pony car, you'll certainly get noticed in this one. If this scheme isn't your bag,, you can alternatively order your Hurst Edition in white and gold or silver and black. Oh, and don't forget a color-coordinated Screaming Chicken on the hood.
No matter which way you choose to go, your inner Burt Reynolds will appreciate the Eibach suspension kit, forged wheels with Pirelli PZero tires, functional shaker hood, fender air extractors, rear spoiler and, of course, a Hurst shifter inside. The interior is emblazoned with all manner of special touches, including a Hurst dash plate and T/A stitching on the Katzkin two-tone leather seats.