1995 Pontiac Firebird Formula Lt1 6 Speed Manual on 2040-cars

Auto blog

General Motors Recalls Nearly 780,000 Cars To Fix Deadly Problem

General Motors is recalling nearly 780,000 compact cars in North America because the engines can shut down unexpectedly and cause crashes. The company says six people have been killed in crashes related to the problem. The recall affects Chevrolet Cobalts and Pontiac G5s from the 2005 through 2007 model years. U.S. safety regulators say the weight of the key ring and rough roads can move the ignition switch out of the run position, cutting the engine and electricity. If that happens, air bags may not work. GM says there have been 22 crashes from the problem. All happened at high speeds. Dealers will replace the ignition switch for free. GM says owners should remove nonessential items from key rings until the problem is fixed. Related Gallery Chevy Impala Earns Highest Accolades From Consumer Reports Recalls Chevrolet GM Pontiac Cobalt

Junkyard Gem: 2010 Pontiac Vibe

Just over a month before filing for Chapter 11 bankruptcy in June 2009, General Motors announced that the 83-year-old Pontiac Division would be "phased out" by the end of 2010. Only three Pontiac vehicles were sold as 2010 models in the United States: the Solstice, Vibe and G6 (new G3s were sold here during 2010 but they were all 2009 models, while the G5 was available as a 2010 model only in Canada and Mexico). Today's bit of junkyard automotive history is one of the very last Vibes ever built, found in a yard near Denver, Colorado. This car is significant not just as one of the final vehicles to bear Pontiac badges but also as one of the last cars built by the New United Motor Manufacturing Incorporated GM-Toyota joint venture in California, better known as NUMMI. The NUMMI factory began life as GM's Fremont Assembly, which built its first vehicle (a C-Series pickup) in 1963 and closed in 1982 after building its final vehicle (an Oldsmobile Cutlass Ciera). Rebooted as NUMMI, the first 1985 Chevrolet Nova (an Americanized AE82 Toyota Corolla Sprinter) rolled off the line in December of 1984. A quarter-century and better than eight million vehicles hence, NUMMI shut down production after its last Corolla was finished on April 1, 2010. While there was some noise about the Oakland Athletics building a new stadium on the site at the time, Tesla ended up buying most of the site soon after that. Tesla now builds more vehicles per year there than NUMMI ever did. The Vibe was co-developed with Toyota and based on the same platform as the ninth-generation Corolla. The Toyota Matrix was mechanically identical and was built in Canada, while the Japanese-market version (known as the Toyota Voltz) was built on the same NUMMI line as the Vibe and shipped across the Pacific. The Vibe/Matrix/Voltz got a redesign for the 2009 model year, but few noticed due to all the turmoil in the GM world at the time. The final Vibe was built in August 2009. This car was built in July of 2009, just before the end. It was living in West Texas just prior to coming to Colorado. El Paso is about a ten-hour drive from this car's current location. Once in the Centennial State, it got parked somewhere it shouldn't have been and ended up being auctioned to Pick Your Part. An occupant of this Vibe had time to sample some of the local agricultural products before that happened.

Gordon Murray, F1-driven production and .. the Pontiac Fiero

Gordon Murray's design and engineering chops are unquestionable. But does his carmaking approach owe something to the short-lived Pontiac Fiero, a scrappy little car program that emerged from GM against serious resistance? Murray had a Formula One career that ran from 1969 to 1991, with stints at Brabham ('69 to '86) and McLaren ('87-'91), that resulted in several shelves' worth of trophies for the cars he was instrumental in designing. He moved on to McLaren Cars, the consumer side of things, where, during his tenure from 1991 to 2004, he helped design the McLaren F1 and the Mercedes-Benz SLR McLaren, two cars that took learnings from his two decades in Formula One. What do all of these cars have in common? Three things: They are light. They were built in limited numbers. And they were (and are) exceedingly expensive—when the McLaren F1 debuted in 1994, it stickered at $815,000. Murray went on to establish Gordon Murray Design in 2007. GMD has created some interesting concept vehicles, such as the diminutive T.25 city car (94.5 inches long, 51.1 inches wide and 55.1 inches high), and the OX, a lightweight truck for the developing world that packs like an IKEA shelf and is working toward realization through a worthy crowdfunding campaign established by the Global Vehicle Trust. Now he has created a vehicle manufacturing company, Gordon Murray Automotive, that will use manufacturing methods that he developed under the moniker "iStream." Unlike a unibody, there are the "iFrame," a cage-like construction made with metallic components, and the "iPanels," which are composite. The panels aren't simply a decorative skin; they actually provide structure to the vehicle. Presumably this has something of the F1 monocoque about it. Going back to the three elements, (1) this arrangement results in a vehicle that can be comparatively light; (2) Murray has indicated that his manufacturing company will be doing limited-run production; and (3) to launch Gordon Murray Automotive they are going to be building a flagship model, about which Murray said, "With our first new car, we will demonstrate a return to the design and engineering principles that have made the McLaren F1 such an icon." Which seems to imply that it will be on the pricey side. According to the company's verbiage, "iStream forges an entirely new production method that defies conventionality with its Formula One-derived construction and materials technologies." It also sounds a whole lot like ...