2011 Mitsubishi Outlander Xls Sunroof Leather 20's 60k Texas Direct Auto on 2040-cars

Auto blog

Mitsubishi recalling i-MiEV models for brake problem

Mitsubishi is issuing a recall for the 2010-2014 i-MiEV that affects 1,810 units of the little electric car, because it's possible for the brake vacuum pump to stop working. If this happens, the result would be longer stopping distances, according to the company. The affected models were built between September 15, 2009, and March 25, 2014.
While this is just a single recall, there are actually two things that can cause this brake problem on the i-MiEV, according to Mitsubishi's filing with the National Highway Traffic Safety Administration. First, bad programming in the EV-ECU could cause the system to "falsely judge that the relay contact point is stuck," according to the full NHTSA defect notice PDF. Second, the vacuum pump exhaust hole could be corroded and blocked due to being splashed with road salt. However, the company says that if either fault happens, the brake warning lamp would illuminate, and there would be an audible alarm.
Depending on which issue is affecting an owner's i-MiEV, Mitsubishi is going to reprogram the software, replace the pump or both. Scroll down to read the recall report from NHTSA.

Mitsubishi recalling 166k cars, crossovers over stall risk

Mitsubishi is recalling 165,923 vehicles in the US because it's possible for the drive belt to detach from their engines, potentially causing a stall. Specifically, the campaign covers 2008-2011 model-year examples of the Lancer, Lancer Evolution (pictured above) and Outlander as well as the 2009-2011 Lancer Sportback and 2011 Outlander Sport. All of the affected models use some version of the brand's 4B1 four-cylinder engine.
According to the National Highway Traffic Safety Administration, the engine pulley can wear causing the drive belt to slip off. If this happens, the alternator, cooling fan and hydraulic power steering can all stop working, and obviously, any of those things could make driving unsafe. However, if the belt detaches, then a warning light should come on in the cabin.
To fix the problem, Mitsubishi dealers will replace the original belt with a redesigned rubber part and will inspect the pulley. If worn, it'll also be replaced free of charge.

Ever wonder how to really pronounce Japanese automaker names?

People tend to get very set in their ways when it comes to the pronunciation of words. Just look at the endless debates over whether or not to say the final 'e' in Porsche (which you should in terms of correct German enunciation). Or the argument about whether to follow the British convention and give the 'u' in Jaguar a special delivery or to say the 'ua' diphthong as more of a 'w' sound, as usually happens in the US.
This short video doesn't answer either of those automotive questions, but it does allow a native Japanese speaker to demonstrate the accepted pronunciations for several, major automakers from the country. One benefit is that it clears up the occasional debate over whether Nissan should be said with a long or short 'i' sound. Also, listen closely to how the female host says Mazda as Matsuda, the way it's actually said in the language. Even if this doesn't change the way you enunciate these brands, at least now you know the accurate way in Japanese.