2004 Mercury Monertay on 2040-cars

Auto blog

Fitting Retirement: Grand Marquis last Mercury off the line

The signs have come down and retail production ended back in October of 2010. Now, the very last Mercury model has rolled off the assembly line. This last Mercury somewhat fittingly takes the form of a Grand Marquis reporting for fleet duty. It was built at the St. Thomas plant in Ontario, Canada, which is the same facility that continues to produce the Ford Crown Victoria and Lincoln Town Car for fleet and livery duty.
St. Thomas' days are numbered, however, as the factory is slated to close on August 31. When it goes, the Panther platform is likely to follow. So long, and thanks for all the fish memories.
[Source: Autoweek]Read | Permalink | Email this | Comments

NHTSA closes rollaway investigation into 1.56M Ford SUVs

It's taken four years of study, but the National Highway Traffic Safety Administration has finally closed the books on its investigation into rollaway accusations surrounding 1.56-million Ford SUV models.
The probe, which centered on the 2002-2005 Ford Explorer, 2002-2005 Mercury Mountaineer and 2003-2005 Lincoln Aviator, ends without the federal agency calling for a recall. According to The Detroit News, the investigation was closed due to a "low number of complaints" - NHTSA documented 180 such complaints that resulted in 14 crashes and six minor injuries, but the number of incidents have been slowing. The suspected defect rate for the trucks' automatic transmissions was found to be 4.4 per 100,000 units, and the brake-shift interlock mechanism failure rate was judged to be even lower at 3.4 per 100k.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.