1963 Mercury Comet S-22 2.4l on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

Report: Lincoln getting all of Mercury's ad dollars

Now that the curtain has closed on Mercury, Ford Motor Company will redirect all of its marketing dollars for the oft-overlooked brand to the Blue Oval's luxury outpost, Lincoln. In speaking to Automotive News, the chairman of the Lincoln National Dealer Council, Bob Tasca, Jr., said, "You'll see a lot stronger presence in the advertising of Lincoln in 2011."
Lincoln spokesperson Christian Bokich reminded AN that the automaker is "preparing the way for seven new or significantly refreshed vehicles" that will be launched over the next four years, and the largest ad blitz in 2011 will focus on the refreshed MKX crossover, as well as the MKZ sedan and its hybrid counterpart. Following that, Lincoln has plans to launch a completely overhauled version of its Navigator SUV, an all-new C-segment vehicle and the overhauled 2013 MKZ, which Tasca says will be "strikingly different from its Ford Fusion sibling."
[Source: Automotive News - sub. req. | Image: John Neff/Autoblog/AOL]Read | Permalink | Email this | Comments

Ford finds flex-fuel engine design plays big role in emissions output

How bad is ethanol for your engine? There's been a lot of debate on this issue as the US considers upping the biofuel content in the national gasoline supply from 10 percent (E10) to 15 percent (E15). The ethanol industry and some scientists say higher ethanol blends show no "meaningful differences" in new engines while the oil industry says ethanol creates health risks. Researchers working at the Ford Research and Innovation Center decided to take a closer look at how a wide range of gas-ethanol blends - E0, E10, E20, E30, E40, E55 and E80 - affected the emissions coming out of a flex-fuel 2006 Mercury Grand Marquis. To see the full report, printed in the journal Environmental Science & Technology, requires payment, but there is an abstract and Green Car Congress has some more details. The gist is that, "with increasing ethanol content in the fuel, the tailpipe emissions of ethanol, acetaldehyde, formaldehyde, methane, and ammonia increased." At least NOx and NMHC emissions decreased. The researchers say that the effects are due to the fuel and "are expected for all FFVs," but that the way that a manufacturer calibrates the engine will affect NOx, THC, and NMOG emissions. It's this last bit that's important, since the researchers found, "Higher ethanol content in gasoline affects several fundamental fuel properties that can impact emissions. ... These changes can have positive or negative effects that can depend on engine design, hardware, and control strategy. In addition to direct emissions impacts, higher ethanol content fuel can also provide more efficient combustion and overall engine operation under part-load conditions and under knock-limited higher-load conditions." So, as we head towards more ethanol in our fuel supply (maybe), manufacturers are going to need to learn how to burn it most efficiently.