2008 Mercedes-benz R350 4 Matic Nav And Rear Entr on 2040-cars

Auto blog

2020 Colorado Winter Driver's Notes | Behind the Wheel S02 // E12

2020 Mercedes-AMG GLC 63 I’ve had bad luck with SUVs this winter. Especially performance ones. First, I got a 2019 Range Rover Sport SVR delivered on summers right as two feet of snow fell, rendering it undriveable. Then, coronavirus cancelled Easter Jeep Safari as well as my trip out to Moab in the 2020 Jeep Wrangler Rubicon Diesel. Thankfully, when this 469 horsepower luxury mall crawler was dropped off, the sun shone down and the snow (mostly) held off.  The first thing that I noticed was there were a few blank buttons throughout the cabin, something that you may see in an entry model vehicle, but IÂ’m not accustomed to seeing in an AMG. Not a great look for a vehicle with an $80,000 price tag. Thankfully that was where the disappointment ended. As soon as you press the start button, the engine fires up and the exhaust note is incredible. Hopping on the highway ramp near my house, I floored it, and the biturbo V8 had me pressed back into the driver's seat, and this wasnÂ’t even the S version that our staff drove last year. Inside and out, the GLC 63 was everything youÂ’d expect from Mercedes. The interior was immaculate, and while the infotainment wheel and touch pad may take some getting used to for someone who isnÂ’t familiar, by now I have it down so that I can use it without looking. And while the V8 left me smiling ear to ear, I was most impressed by the amount of useable interior space there is. I happened to be moving at the time of this review and while all of my large furniture was shoved into the back of a moving van, I was able to fit almost everything else in the back of the GLC. 2019 and 2020 Fiat 500X Trekking ItÂ’s hard to say goodbye to an AMG and then turn around and be excited when a Fiat 500X pulls in your driveway (I know, I know, automotive journalist problems). That being said, when the red Fiat pulled up, I found myself admiring it. I am very familiar with the 500X. Back in 2016 Autoblog had one for a year as our long term test vehicle. I drove that car everywhere, multiple trips up north in Michigan, and even tracked it at Gingerman Raceway for a few laps before the brakes started smoking.  The 2019 model I had in my driveway and the 2020 model I drove in the snow up in the mountains feel very similar to that car. The interior is stylish and surprisingly roomy. The greenhouse is airy.

Aston Martin Vantage vs. Mercedes-AMG GT C Review | Translating German into English

GROssBRITANNIEN — No car matches the new Aston Martin Vantage as closely as the Mercedes-AMG GT, the two sharing both their 4.0-liter twin-turbocharged V8 and electrical architecture while competing for the same market niche. So, of the many challenges Aston Martin faced when developing it, ensuring that the Vantage had a unique identity must have weighed more heavily than any other. The added spice to this confrontation is the GT's status as halo model for AMG. Meanwhile, Aston Martin's brand identity, built on the sharp-suited machismo embodied by a certain big-screen spy, is a make-or-break issue for the company. The identity problem has fascinated me since the AMG deal was first announce in 2013. So exploring the Vantage on British roads with the GT literally filling the mirrors is a big deal. Now, finally, we have directly competing products with which to explore the theory. And there's much to like in both, not least of which is that common powerhouse of an engine. While they don't share a platform, both use the classic front-engine, rear-drive, transaxle layout, with traditional driving manners to match. Some quick number-crunching as an appetizer: The AMG GT C you see here has the dry-sumped M178 derivative of the V8, with 550 horsepower and 501 pound-feet of torque, driving the rear wheels through a transaxle-mounted, seven-speed dual-clutch transmission and fully active electronic locking differential. It's 179 inches long, weighs 3,748 pounds and will clear 0-60 mph in 3.6 seconds en route to 197 mph. The Vantage has the wet-sumped M177 version of the same engine, as featured in countless AMGs and shared with the DB11 V8. It makes 503 hp, 505 lb-ft and drives the rear wheels through a transaxle-mounted, eight-speed automatic gearbox and fully active electronic locking differential. Sounding familiar? It's comparable in overall length but a couple of inches longer in wheelbase, and weighs pretty much the same as the GT C, give or take a few pounds. It hits 60 in 3.5 seconds and tops out at 195 mph. Both have adaptive dampers and a variety of driver modes, both are built from aluminum and both are at the sportier end of the GT spectrum. The two U.K.-market cars you see here cost just more than $180,000 with options. Pretty darned close, then. Numbers are one thing.

Gordon Murray, F1-driven production and .. the Pontiac Fiero

Gordon Murray's design and engineering chops are unquestionable. But does his carmaking approach owe something to the short-lived Pontiac Fiero, a scrappy little car program that emerged from GM against serious resistance? Murray had a Formula One career that ran from 1969 to 1991, with stints at Brabham ('69 to '86) and McLaren ('87-'91), that resulted in several shelves' worth of trophies for the cars he was instrumental in designing. He moved on to McLaren Cars, the consumer side of things, where, during his tenure from 1991 to 2004, he helped design the McLaren F1 and the Mercedes-Benz SLR McLaren, two cars that took learnings from his two decades in Formula One. What do all of these cars have in common? Three things: They are light. They were built in limited numbers. And they were (and are) exceedingly expensive—when the McLaren F1 debuted in 1994, it stickered at $815,000. Murray went on to establish Gordon Murray Design in 2007. GMD has created some interesting concept vehicles, such as the diminutive T.25 city car (94.5 inches long, 51.1 inches wide and 55.1 inches high), and the OX, a lightweight truck for the developing world that packs like an IKEA shelf and is working toward realization through a worthy crowdfunding campaign established by the Global Vehicle Trust. Now he has created a vehicle manufacturing company, Gordon Murray Automotive, that will use manufacturing methods that he developed under the moniker "iStream." Unlike a unibody, there are the "iFrame," a cage-like construction made with metallic components, and the "iPanels," which are composite. The panels aren't simply a decorative skin; they actually provide structure to the vehicle. Presumably this has something of the F1 monocoque about it. Going back to the three elements, (1) this arrangement results in a vehicle that can be comparatively light; (2) Murray has indicated that his manufacturing company will be doing limited-run production; and (3) to launch Gordon Murray Automotive they are going to be building a flagship model, about which Murray said, "With our first new car, we will demonstrate a return to the design and engineering principles that have made the McLaren F1 such an icon." Which seems to imply that it will be on the pricey side. According to the company's verbiage, "iStream forges an entirely new production method that defies conventionality with its Formula One-derived construction and materials technologies." It also sounds a whole lot like ...