Find or Sell Used Cars, Trucks, and SUVs in USA

1991 Mazda Rx-7 Base Coupe 2-door 1.3l on 2040-cars

Year:1991 Mileage:133160 Color: Blue /
 Blue
Location:

Fayetteville, Arkansas, United States

Fayetteville, Arkansas, United States
Advertising:
Transmission:Manual
Body Type:Coupe
Engine:1.3L 1308CC R2 GAS N/R Naturally Aspirated
Vehicle Title:Clear
Fuel Type:GAS
For Sale By:Private Seller
VIN: JM1FC3315M0902849 Year: 1991
Number of Cylinders: 2
Make: Mazda
Model: RX-7
Trim: Base Coupe 2-Door
Warranty: Vehicle does NOT have an existing warranty
Drive Type: RWD
Options: CD Player
Mileage: 133,160
Power Options: Power Locks, Power Windows
Sub Model: Base
Exterior Color: Blue
Interior Color: Blue
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"Chassis/suspension in great shape. Engine can use work. Needs paint."

Up for sale is my 1991 RX-7 Coupe. I am the third owner and have owned the car since 2003. 


The good:

The car is from Florida so the body has only a few small (dime size) spots of rust, except the lower window trim. Has never been in an accident. Suspension still tight, motor pulls strong, brakes are great, interior is in decent shape. Car is stock except for factory replacement 4 piston brakes on the front and a Miata shift knob (still have original). Power windows, wipers, and seat belts work. Seat belts are only 2 years old. Comes with two sets of tires, currently wearing the winter set. It has always been run on 2 cycle premix. All gauges work, but digital clock has the cold solder issue (common). 


The bad:

The front rotor has an o-ring leak on the exhaust side. Although the car runs normally, it leaks exhaust into the cooling system. After about 20-30 minutes of driving the low water buzzer can go off because the exhaust has forced the coolant out. You can stop, dump the coolant into the radiator and keep going, though. If you're not driving it long distances, you wouldn't notice a problem at all. CD/radio has mostly stopped working. Power antenna is broken and is in the up position. The mufflers are rusted through. Fuel injectors leak when it's cold so sometimes it smokes on start up. Transmission is notchy before it is warmed up and shifter feels a little loose. Has A/C hardware, but it hasn't had freon in years. Body has some small dents.


The ugly:

The paint is mostly faded away. The passenger door was repainted after a broken window and it has cracked (see picture). The hood has been resprayed with primer, but there is rust creeping back under it. The driver's seat has two tears in it. The speedo/tach console surround has broken from its mount. Above the speedo console the vinyl dash is cratered. The rubber trim on the hatch is pulling up on the driver's side (see picture). 

Summary: 

The car could use new paint and the engine will likely need to be overhauled/replaced eventually.

Buyer to arrange for pickup/delivery. Deposit due within 48 hours, full payment with cash or cashier's check on pickup. 

Auto Services in Arkansas

Xtreme Collision & Auto Sales ★★★★★

New Car Dealers, Automobile Body Repairing & Painting, Used Car Dealers
Address: 12369 Three Elms Rd Ste 3640, Farmington
Phone: (479) 267-5027

Wholesale Tire Outlet Automotive ★★★★★

Auto Repair & Service, Tire Dealers, Brake Repair
Address: 66 Batesville Blvd, Concord
Phone: (870) 793-9183

Western Auto NAPA ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Brake Repair
Address: 1307 Albert Pike Rd, Hot-Springs-National-Park
Phone: (501) 623-1497

U-Haul of North Little Rock ★★★★★

Used Car Dealers, Trailer Renting & Leasing, Truck Rental
Address: 601 Cypress St, Cammack-Village
Phone: (501) 758-2924

Texarkana Tire & Wheel ★★★★★

Auto Repair & Service, Tire Dealers, Tire Recap, Retread & Repair
Address: 1307 East St, Genoa
Phone: (870) 774-8473

Rusty`s Automotive ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automotive Tune Up Service
Address: 126 Golf Links Rd, Hot-Springs-National-Park
Phone: (866) 595-6470

Auto blog

2019 Mazda MX-5 Miata First Drive Review | More power is the icing on top

Mon, Aug 13 2018

SAN DIEGO — When Mazda announced that the 2019 Mazda MX-5 Miata was getting a serious increase in power, I was both excited and nervous. I was excited because more power is always exciting, and it was no insubstantial increase. At 181 horsepower, it's the most powerful production Miata ever offered, beating out turbocharged Mazdaspeed Miata's 178 horsepower. Plus it has more revs to play with. But what had me worried was whether this power would mess up the friendly, playful character of the Miata. The 155-horsepower 2.0-liter engine is just about perfect, almost universally loved by the Autoblog staff and other reviewers, with good midrange torque and short gearing that always made it feel quick in nearly every rev range. It felt like the right amount of power for the chassis, too. There was just enough to get it loose without working too hard, but it wouldn't spin you around unexpectedly. I could imagine a couple of ways the new engine could affect that sweet balance, too. A bit too much power could risk some of the Miata's accessibility and predictability. It might become more serious and less fun-loving. I also feared that in pursuit of a higher redline and more horsepower, the low-end of the rev range might become painfully slow. Honda owners know this feeling whenever their VTEC-equipped screamers drop out of the aggressive cam profile, and the Toyota 86 and BRZ suffer from an awful lack of torque right in the mid-range that doesn't recover until nearly redline. All of this was on my mind when the assembled reviewers were briefed by Mazda engineers about the car. It started out like most presentations, with a brief rundown of the goals of the car and what Mazda has done with the model so far. Then came a chart showing the power curves of the NC, current ND, and the 2019 model, and my fear of a loss of low-end grunt dissipated. The amount of power and torque over engine speed is nearly identical between the old and new ND Miatas right up to around 4,500 rpm. And then from there, the 2019 continues making more power all the way to its 181-horse peak at 7,000 rpm, 500 rpm higher than the previous model's redline. This was a good sign. Mazda managed to get these gains with no sacrifices through many small upgrades. The throttle body is wider with a slimmer throttle plate, the intake manifold has longer runners and dual paths, and the intake ports are larger.

New Mazda CX-4 teaser shots emerge ahead of Beijing debut

Wed, Apr 6 2016

The Kodo styling language seen on last year's Koeru concept seems to translate well to a production car, judging by these teaser images of the upcoming CX-4 from Mazda's Chinese press site. And, as has been seen on several recent Mazdas, concept cars can be quite close to their eventual production versions. An earlier press release implies the CX-4 should be seen as a more coupe-like counterpart to the CX-5, with some of the MX-5's characteristic and often emphasized jinba ittai feel injected into it – if the MX-5 is all about the rider and horse being one, the CX-4 would just be a slightly bigger steed. The 19-inch wheels and LED headlights are some of the more attention-grabbing details on the car. Inside, there's a head-up-display and a MZD connect infotainment screen as seen on other current models. The hardware on the "Exploring-Coupe SUV", as Mazda call it, should match the CX-5: 2.2-liter SKYACTIV-D turbodiesels in some markets, 2.0 and 2.5-liter SKYACTIV-G gasoline engines in most. There will also be a choice of front-wheel-drive or all-wheel-drive. The Beijing Motor Show opens to the public on April 29th, so we won't have to wait a whole lot longer to see the whole thing. Related Video:

Toyota delays Mexico plant as it plans U.S. plant with Mazda

Thu, Aug 10 2017

TOKYO — Toyota will push back the start of operations at its scheduled new plant in Mexico, to the first half of 2020 from the initial plan of 2019, the company said on Thursday. Japan's top automaker had initially planned to start building the Corolla sedan at the $1 billion Guanajuato plant but said last week it would switch production to a new U.S. factory to be built with Mazda. Toyota said the delay was necessary to adjust its supply chain in Mexico to produce the Tacoma pickup instead of the Corolla compact car. That factory could also build sport utility vehicles, a Toyota spokesman in Mexico said last week. "With the production model change to the Tacoma pickup, the start of production will consequently be in the first half of 2020," a Toyota spokeswoman said. "However, we will make our utmost effort to advance the timing in order to minimize the impact to suppliers and the local community." Until the scheduled start of the joint venture plant with Mazda in 2021, Toyota will supply the Corollas that were initially slated to be built in Mexico from its factories in Mississippi and Japan, the company said.Related: Mazda-Toyota partnership has us dreaming of a rotary hybrid Reporting by Makiko YamazakiRelated Video: