2013 Mazda Mazda3 I Sport on 2040-cars

Auto blog

Mazda plans to launch an EV in 2020, plug-in hybrid by 2022

Thanks to an interview Automotive News Europe conducted with Mazda president and CEO Akira Marumoto, we have more insight on Mazda's plans to lower its vehicle emissions in Europe. This will undoubtedly bring changes to the U.S. lineup, too, but The Continent sees the first fruits in part because Mazda is well over the European Union's fleet CO2 emissions target for 2021 of 95 g/km. In response to how Mazda plans to achieve the necessary reduction, Marumoto said the carmaker will launch its first EV in 2020 and have a plug-in hybrid on the road in 2021 or 2022. First, some clarification on the emissions numbers and timeline. The 95g/km figure is based on the New European Driving Cycle (NEDC) emissions schedule being phased out next year; the AN piece cites JATO Dynamics findings that Mazda Europe's fleet CO2 average is 135.2 g/km. The new Worldwide Harmonised Light Vehicle Test Procedure (WLTP) schedule comes into full effect in 2020, the fleet CO2 target under that methodology translating to 114.9 g/km. The rules dictate that 90 percent of an automaker's range needs to meet the cap number by the end of 2020, the rest of the lineup must come into compliance by the end of 2021. Failure means enormous fines. Industry analyst IHS Markit estimates "average fines for those not complying could reach ˆ624 ($707) per vehicle at the end of 2020, with a further ˆ190 ($215) increase in 2021." The penalties quickly grow so large that Fiat will reportedly pay Tesla hundreds of millions of euros to pool their fleets and avoid an even larger bill. Mazda's most popular vehicle in Europe is the CX-5 with CO2 emissions ranging from 128 g/km to 150 g/km. On top of that, for a small automaker, the size of potential fines has material effect on the R&D budgets necessary to develop the technologies that will lower emissions, and whatever EV Mazda launches in 2020 needs to sway legions of customers into purchases to be of practical use. This will be challenging. A line in the IHS Markit summary about the industry in general states, "Once in 2021 and subject to full WLTP regulatory monitoring, only a seismic shift (over the baseline) in consumer demand for BEV ('Electric-Plug-In') and PHEV ('Hybrid-Full Plug-In) will result in the full mitigation of EU28 fleet level excess emissions premiums." Mazda hooked up with Toyota and Denso in 2017 on a joint venture called EV Common Architecture Spirit Co Ltd to develop EV technology.

Stock Miata beats bunch of high-powered cars in wet 1/4-mile drag race

When is a stock, 167-horsepower Mazda MX-5 Miata quicker than a Chevrolet Corvette, Ford Mustang, Lamborghini Gallardo, Lotus Elise and a Porsche 911? When it's raining. Sort of.
Mazda Canada arranged a unique drag race to show off the fact that the Miata's optional power retractable folding hardtop can go from top-down to top-up in just 12 seconds flat. In this video, all six cars line up for a drag race, and it starts to rain (well, sort of - but you'll have to watch the video all the way to the end to see what we mean). The green flag is waved, and the timer starts as soon as the convertibles begin to put their tops up. But because the Miata's roof mechanism gets the car's roof back up a full 5.1 seconds quicker than the second-place car, the Mazda gets a serious advantage off the line for the actual drag race.
It's a fun video. And while we've spoiled the results (come on, the video was uploaded by Mazda, you knew the Miata was going to win), be sure to see how it all unfolds, below.

Mazda recalling 190,000 CX-7s due to rusty ball joints

UPDATE: This post has been updated with additional information from Mazda. The Basics: Mazda is recalling 190,102 Mazda CX-7 crossovers built between February 14, 2006, to May 9, 2012 – model years 2007 through 2012. The Problem: Water can sneak in between the suspension ball joint fittings. If snow and road salt are common in your neck of the woods, the joints can corrode and separate from the lower control arms. That's bad if you enjoy steering your CX-7. According to Mazda, owners of affected models may notice a rattle from the front suspension due to the loose ball joint in the lower control arm fitting. Mazda describes separation of the ball joint and control arm as a "worst case" scenario "after extended operation in such condition." Injuries/Deaths: It's unknown if the rusting issue has led to any crashes, injuries, or deaths. Autoblog has a call into Mazda for additional details and will update this post with any new information. There have been no reports of accidents, injuries, or fatalities related to this recall. The Fix: Owners should report to their local Mazda service center, where techs will replace the both front lower control arms. Any work done is free of charge. If you own one: Mazda will perform some automotive triage with this recall, focusing on CX-7s that have had the longest exposure to salt and are most likely to suffer control arm separation first. Owners of 2007s and 2008s come first, followed by 2009 through 2011 models. Mazda will also focus on vehicles registered in states where snow and road salt are most common – Connecticut, Delaware, Illinois, Indiana, Iowa, Kentucky, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, Virginia, West Virginia, Wisconsin, and Washington, D.C. If you live in a more temperate region or own a 2012 CX-7, Mazda will perform recall work as "parts are available." Owners can contact Mazda customer service at 1-800-222-5500 for additional info. Recall notices should hit the mail around October 10th. Related Video: Featured Gallery 2011 Mazda CX-7: Review View 21 Photos News Source: NHTSAImage Credit: Copyright 2016 AOL Recalls Mazda Crossover mazda cx-7