Mazda: Cx-5 Grand Touring on 2040-cars

Auto blog

Japan plans real-world diesel emissions test after companies fail

Japan's transport ministry plans to start real-world diesel emissions tests after an experiment found four models from Toyota, Nissan, and Mitsubishi that produced more nitrogen oxide (NOx) emissions than the nation's rules allow, according to The Japan Times. Regulators there usually only perform emissions checks in the lab. The VW diesel scandal has everyone double-checking their figures. Diesel versions of the Toyota Hiace van, Land Cruiser Prado, and Nissan X-Trail produced up to 10 times more NOx than allowed. The Mitsubishi Delica D:5 was up to five times over the limit, The Wall Street Journal reports. There was no evidence of defeat devices in the vehicles. Mazda performed well in the experiment, though. The CX-5 passed with nearly the same results on the road and in the lab. The Demio, better known as the Mazda2, did nearly as well with only slighter higher figures in the real world than in the controlled setting. The experimenters theorized the reason for the excessive emissions was that cold weather caused the engines' software to shut off the exhaust gas recirculation to prevent damage, according to the WSJ. However, this behavior also increased NOx production. Toyota, Nissan, and Mitsubishi don't have to worry about punishment from the transport ministry because this check was just an experiment. Their models already passed the mandated lab tests, which was the only requirement, according to The Japan Times. As governments begin greater real-world emissions tests, the results suggests diesels aren't very clean. A recent check in France found models from Ford, Renault, and Mercedes-Benz that didn't perform up to the standards. Regulators in India conducted similar evaluations and ordered VW to recall over 300,000 vehicles. Related Video:

Confirmed: Mazda Miata gets more power, higher redline, telescoping wheel

Our friend over at Road & Track, Bozi Tatarevic, has a keen nose for stuff just like today's Miata news, and he spotted an article by the Japanese car magazine Car Watch that details Mazda's upcoming updates. Car Watch actually got to drive the car, too. There's a lot to go through, but the highlight has to be confirmation of what we told you earlier this year about a significant power bump: The Miata will indeed get an increase of 26 horsepower, from 155 to 181. But the power's not the whole story. Mazda has increased the redline from 6,800 RPM to 7,500. It's not clear at this point where torque and power peaks are in the rev range, or how these changes affect low-speed drivability, but more revs are almost always a good thing and aren't likely to detract from the roadster's fundamental goodness. Car Watch reports that lighter pistons and connecting rods are fitted to help reduce rotational mass in the 2.0-liter inline-four. Some valvetrain changes were needed to support the higher redline, mainly stiffer valvesprings to prevent valve float. Mazda also changed the shape of the valves and optimized the intake ports to breathe better at higher RPM. The inner diameter of the exhaust ports were increased to flow better through a new muffler better tuned to the engine's new operating range. This confirms and gives a little more detail to what we reported earlier based on a leaked document from Mazda Canada. Car Watch also confirms that the revised Miata will get a low-inertia dual-mass flywheel, which should help absorb some vibration, noise and harshness from the higher-revving engine without losing too much of the directness that a single-mass flywheel provides. Mazda usually gets stuff like this right, so while we won't know until we get a chance to drive it whether the DMF feels "right," we're not too worried about it. There's also a telescopic steering wheel, a first in any Miata, which has a range of about 1.1 inches. That doesn't sound like much, but it should help folks with longer legs reach the wheel without having to crank the seat forward. Interestingly, Car Watch reports that the telescoping wheel was opposed by some in the company seeking to save every fraction of an ounce of weight, and to get it through, the company apparently had to change some of the material in the upper steering column from steel to aluminum to satisfy the weight-conscious. Little details like these are fantastic.

Mazda RX-Vision Concept revives the rotary

Mazda continues fighting to keep the rotary alive, and with the RX-Vision concept at the 2015 Tokyo Motor Show, the company unveils its dream for the engine's revival in a curvaceous sports coupe. Before any fans burst with excitement at the prospect, Mazda only "hopes" to have this gorgeous shape available in showrooms someday, for now. The RX-Vision starts with the classic elements of a front-engine, rear-wheel drive sports coupe by combining a long, low hood, short rear deck, and a passenger compartment way at the back. From there, Mazda's stylists add the swooping touches of the brand's Kodo design language. The result looks thoroughly modern and still subtly evokes generations of the RX-7 in the sculpted fenders and flowing roofline. Under that shapely hood hides Mazda's next-generation rotary, which the company has dubbed the Skyactiv-R. Unfortunately, details about it are quite scarce at the moment, including the displacement or even the number of rotors the engine uses. Still, Mazda is abundantly clear that development of the mill is very much moving forward. Mazda's designers opt for a retro flair inside with the deeply dished steering wheel and gauges in three pods. The rest is simple and elegant with a minimalist, metal gearshift rising from the center console and leather straps for door pulls. Finishing things off is a clean mix of red and black upholstery with a little carbon fiber for contrast. Expect live shots from Tokyo soon to show how the RX-Vision looks under the lights. Related Video: Mazda Reveals Mazda RX-VISION Concept -- Powered by next-generation rotary engine SKYACTIV-R, represents Mazda's vision of the future -- HIROSHIMA, Japan—Mazda Motor Corporation unveiled the rotary-powered Mazda RX-VISION sports car concept at the Tokyo Motor Show*1 today. The rotary engine is a symbol of the company's "never-stop-challenging" spirit. RX-VISION represents a vision of the future that Mazda hopes to one day make into reality; a front-engine, rear-wheel drive sports car with exquisite, KODO design-based proportions only Mazda could envision, and powered by the next-generation SKYACTIV-R rotary engine. Rotary engines feature a unique construction, generating power through the rotational motion of a triangular rotor. Overcoming numerous technical difficulties, Mazda succeeded in commercializing the rotary engine, fitting it in the Cosmo Sport (known as Mazda 110S overseas) in 1967.