2010 Lexus Rx 450 Hybrid Navigation Awd 39k Priced To S on 2040-cars

Auto blog

Why is there a huge bulge in 2021 Lexus IS 300 AWD's driver footwell? We explain

After an initial turn a few weeks ago for the 2021 Lexus IS first drive review, the revised luxury sedan has returned to the Autoblog garage for a second look. This middle-of-the-road IS 300 AWD pairs a 260-horsepower V6 with a six-speed automatic transmission and four driven wheels, and frankly it's the least interesting way to spec out the redesigned sedan. While there are cars in this segment designed to get a performance boost from their all-wheel-drive systems even in dry conditions, the IS isn't one of them. Adding insult to injury, you get stuck with a cramped driver-side footwell care of the engineering shenanigans that went into making this system possible.  While we've mentioned this particular compromise before, we rarely touch on the reasons why it exists in the first place. The fundamentals are fairly obvious; the standard IS utilizes a longitudinal, rear-wheel-drive powertrain. As is typical with this configuration, the transmission sits in a tunnel beneath the center console. This arrangement works just fine, provided you don't need to power the front wheels.  To do so in a traditional car like the IS requires a literal end-around maneuver involving the engine and transmission, which we've diagrammed for you below care of MSPaint. This is a bit simplified for the sake of this write-up, and it should be noted that this is not the only way to implement AWD in an inherently RWD platform, but it illustrates how the power for the front axle (red) and rear axle (blue) flows from the transmission to the drive wheels. To get juice flowing to the front axle, Lexus had to add a parallel output shaft, exiting the transmission from the front with enough clearance for the bell housing and engine, which sits between the transmission and the front differential. This requires quite a bit of lateral reach, meaning the housing has to extend much farther out than usual to accommodate it (yellow arrow). As a result, the all-wheel-drive transmission looks a lot like a sci-fi gun with a chunky drum magazine hanging off the side of it. The hump (above right) in the footwell is there to clear this protrusion. This basic configuration isn't unique to Lexus. In fact, if you look at a BMW xDrive cutaway, it's similar. So, why no "hump" in other cars? There are multiple factors, but to boil it down to what is most relevant, it's a combination of the resulting shape of the Lexus transmission housing and the size of the IS chassis.

Takata air bag recall list

The National Highway Traffic Safety Administration confirmed yesterday that 33.8 million vehicles with Takata airbags are going to be recalled. It's the largest recall in automotive history. The already record-breaking rate of automotive recalls this year shows no signs of slowing down, especially since millions of cars with defective airbags made by global supplier Takata are under ongoing scrutiny. The federal government is warning owners that inflator mechanisms in the air bags can rupture, causing metal fragments to fly out when the bags are deployed. The faulty air bags have already been blamed for multiple deaths. How do you know if your vehicle is safe? The National Highway Traffic Safety Administration released an updated list of vehicles under recall. Sometimes however, the government's website will crash and the list may not be complete. Check your VIN at the NHTSA website to make sure. The list of cars affected by the recall has not been released, but seem to span multiple models over the years for many of the automakers.

Toyota recalls 370k Sienna minivans, 10.5k Lexus GS models over separate issues

The year of the recall continues, but this time it isn't from General Motors. Toyota is announcing two, separate recalls affecting a pair of its models.
First, Toyota is recalling 370,000 Sienna minivans from the 2004 to 2011 model years that are registered or originally sold in cold-weather states. The problem is that the spare tire carrier assembly cable can be splashed by water contaminated with road salt and cause corrosion. There is a splashguard in place to prevent this, but it sometimes gets lost in "normal usage," according to the company. If the cable does break, then "the spare tire may separate from the vehicle."
This is actually the second repair for this problem for some of these vehicles. In 2010, Toyota issued a recall on 600,000 Siennas from the 1998 to 2010 model years. At the time, it installed a new splashguard and sprayed the area with an anti-rust chemical. However, according to Toyota spokesperson John Hanson speaking to Autoblog, the campaign worked for the 1998 to 2003 models but wasn't sufficient for the newer ones. For the latest recall, the vehicles are getting the entire cable replaced with a stainless steel unit and a new splashguard.