1992 Lexus Es300 3.0l V6 Auto Low Mileage Leather Loaded Sunroof on 2040-cars

Auto blog

Why is there a huge bulge in 2021 Lexus IS 300 AWD's driver footwell? We explain

After an initial turn a few weeks ago for the 2021 Lexus IS first drive review, the revised luxury sedan has returned to the Autoblog garage for a second look. This middle-of-the-road IS 300 AWD pairs a 260-horsepower V6 with a six-speed automatic transmission and four driven wheels, and frankly it's the least interesting way to spec out the redesigned sedan. While there are cars in this segment designed to get a performance boost from their all-wheel-drive systems even in dry conditions, the IS isn't one of them. Adding insult to injury, you get stuck with a cramped driver-side footwell care of the engineering shenanigans that went into making this system possible.  While we've mentioned this particular compromise before, we rarely touch on the reasons why it exists in the first place. The fundamentals are fairly obvious; the standard IS utilizes a longitudinal, rear-wheel-drive powertrain. As is typical with this configuration, the transmission sits in a tunnel beneath the center console. This arrangement works just fine, provided you don't need to power the front wheels.  To do so in a traditional car like the IS requires a literal end-around maneuver involving the engine and transmission, which we've diagrammed for you below care of MSPaint. This is a bit simplified for the sake of this write-up, and it should be noted that this is not the only way to implement AWD in an inherently RWD platform, but it illustrates how the power for the front axle (red) and rear axle (blue) flows from the transmission to the drive wheels. To get juice flowing to the front axle, Lexus had to add a parallel output shaft, exiting the transmission from the front with enough clearance for the bell housing and engine, which sits between the transmission and the front differential. This requires quite a bit of lateral reach, meaning the housing has to extend much farther out than usual to accommodate it (yellow arrow). As a result, the all-wheel-drive transmission looks a lot like a sci-fi gun with a chunky drum magazine hanging off the side of it. The hump (above right) in the footwell is there to clear this protrusion. This basic configuration isn't unique to Lexus. In fact, if you look at a BMW xDrive cutaway, it's similar. So, why no "hump" in other cars? There are multiple factors, but to boil it down to what is most relevant, it's a combination of the resulting shape of the Lexus transmission housing and the size of the IS chassis.

Lexus RC F takes star turn in 'Men in Black: International' blockbuster

Here's a little car candy for the holidays. There have been three :Men in Black" films, the last one in 2012 (even though it seems a lot longer ago, doesn't it?). "Men in Black: International," due for release on June 14, looks like it will showcase its vehicles in a way the previous movies didn't, starting with getting the Lexus RC F ready for its close-up. This will be Lexus' second blockbuster turn in two years, after putting an LC in the line of fire in this year's "Black Panther". And if "MIB: International" gives off the whiff of petrol, that's at last partly because F. Gary Gray directs, the man behind 2003's "The Italian Job " and 2017's " The Fate of the Furious." This is the first "MIB" to give the agents a whiz-bang modern car. The most modern vehicle previously was a "new hotness" 2003 Mercedes-Benz E550 in the 2002 sequel, but that was primarily a joke referring to the 1986 Ford LTD, referred to as a "Ford P.O.S.," in the first movie. The third film, which took place in the sixties, used a 1964 Ford Galaxie. "MIB: International" includes a few throwbacks to the movies and the television series. The RC F goes airborne with the help of a big red button, just like that '86 LTD. A bigger and better hovercycle ties into the hovercycle from the TV show. The all-new move comes with a mid-seventies Jaguar XJ; whereas the first agents merely retrieved their weapons from the trunk, the XJ not only holds weapons, it disassembles into weapons systems. As Jalopnik noted, in many ways this movie " looks just like 'Thor: Ragnarok' but set in a different universe." Should go well enough with a bucket of popcorn and pail of Coca-Cola, though. Related Video:

Post-earthquake, Toyota prepares to reopen some plants in Japan

Toyota will restart vehicle production at most of its closed factories in Japan next week, but the factories that build the Mirai and many Lexus models will remain closed through at least April 28 and possibly longer. The earthquakes around the city of Kumamoto on the island of Kyushu forced the automaker to stop most of its assembly throughout the country due to a lack of parts supply. Toyota will reopen the plants in phases from April 25 to 28. However, the Motomachi factory with its LFA works, which makes the Mirai, and the Miyata factory will remain closed. These sites also build the Lexus NX, RX, ES, GS, and CT, according to Toyota. The automaker didn't say when production would begin again or how this would affect vehicle supply. "In the update, we received this morning from TMC, they said that at this stage it is too soon to tell what the impact on production will be, so we can't say yet whether there might be vehicle shortages in the US," spokesperson Aaron Fowles told Autoblog. While the quakes were focused on Kyushu, they damaged Aisin Seiki factories, which supplied parts to Toyota plants across the country. The automaker worked with its partner to import the necessary components from China and Mexico, and Aisin started moving molds from the damaged plants to operational ones in Japan, which gets production under way sooner. Automotive News Europe estimates the week of lost production cuts total assembly by 90,000 vehicles. It could cost Toyota the equivalent of $458.2 million to $641.5 million. The company could make up some of the losses through overtime. Toyota says these plans are subject to change because on ongoing tremors in the region, which could cause more damage. Reuters reported there was a magnitude 5.5 aftershock in the Kumamoto area on April 19. So far, the quakes have killed at least 47 people and around 100,000 people have moved to evacuation centers. Toyota to Restart Production on Vehicle Assembly Lines in Japan from April 25 Apr. 20, 2016 Toyota City, Japan, April 20, 2016-Between April 25 and 28, Toyota will restart production on most of its vehicle assembly lines in Japan. On April 17, Toyota announced that, due to parts shortages resulting from the severe earthquakes that struck Japan's island of Kyushu last week, production would be suspended on almost all of its vehicle assembly lines in stages between April 18 and 23.