Sport Utility on 2040-cars

Auto blog

Buy this instead of a Wrangler | 2017 Jeep Grand Cherokee Trailhawk Review

In our first encounter with the 2017 Jeep Grand Cherokee Trailhawk at Fiat Chrysler's Chelsea Proving Grounds, we saluted the new model's impressive on-road demeanor. In its off-road mode, however, we couldn't ignore the pre-production throttle calibration – it was super sharp and difficult to modulate with the precision needed to navigate obstacles. We were told then that Jeep's engineers were aware of the problem and were fixing it for production models. So we recently set off for Bundy Hill Off-Road Park in Jerome, Michigan, in a production-spec Grand Cherokee Trailhawk to check their work and get a better idea of the overall package. We can report that the Trailhawk's throttle has been fixed for production, landing it properly in Goldilocks territory. In the off-road Mud setting, the throttle is soft and easy to modulate. You can balance this rig with the gas pedal, reaching just past tip-in to steadily prod forward. But the gas pedal doesn't delay when you really need power. Move beyond the initial tip-in, and the engine responds quickly, which is a good thing, as a sluggish throttle is almost as dangerous off-road as one that's too sharp. Rock mode promises even more precise control over the throttle, although our lack of a spotter and a desire to avoid damaging the 700-mile-young Trailhawk kept us from hitting Bundy Hill's rockier sections. The wet, non-snowy weather meant we didn't properly test Snow or Sand mode. This test model was equipped with FCA's popular 3.6-liter V6, but like the rest of the Grand Cherokee range, more power is available from the 3.0-liter EcoDiesel V6 and the 5.7-liter Hemi V8. You don't need them – the 3.6-liter and eight-speed automatic are perfectly fine on the trails. Faced with an incline, the transmission holds its gear without complaint – you don't even need to switch into manual mode. Despite the 4,800-rpm torque peak, the V6's 260 pound-feet arrive early enough that you don't need to strong-arm the throttle. So that's resolution for the pre-production issue. But our time at Bundy Hill exposed a different and ultimately much easier to fix problem for the production model. Late fall in Michigan is not always a good time to go off-road – sub-40-degree temperatures and a steady, depressing drizzle can turn a relatively simple trail into a slippery mess of wet clay. Conditions like these can easily overwhelm an on-road tire like the Goodyear All-Terrain Adventures the Trailhawk uses.

Chrysler adding 200 jobs at Ohio Jeep Wrangler plant

Chrysler is betting that the Jeep Wrangler will continue its strong sales surge as it continues to push the legendary brand out across the globe. The Auburn Hills automaker is reportedly adding 200 workers at the Toledo, Ohio plant that builds the Wrangler. What's more, those new hires will be at their posts quickly - they'll be on the job by April 1. Of those 200 workers, 130 employees will be there to relieve those who need breaks.
Why do they need so many relief workers? The Toledo Jeep Complex is currently working at a torrid pace with two ten-hour shifts. A third shift has been ruled out for the moment because of a production botttleneck - the plant's paint shop is already maxed out. According to Reuters, Wrangler production in 2012 cleared 200,000 units, and US sales were up by 16 percent.
Another part of the Toledo plant is presently down as Chrysler retools the line to build Jeep's divisively styled Liberty replacement, the Cherokee (seen in our gallery below). Production for the new model is scheduled to begin toward the end of May.

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.