Limited Lift Gate Cruise Control Lift Kit 4x4 Factory Warranty Off Lease Only on 2040-cars

Auto blog

Jeep Wrangler likely to get aluminum body, will stay in Toledo

Perhaps more than any other vehicle currently for sale in the United States, the Jeep Wrangler is viewed by purist fans as a vehicle that simply must maintain the status quo. In this case, that means a body-on-frame design, solid axles, a relatively large engine sitting up front and a removable top. It's always been that way, and it always will be.
Maybe.
According to the most recent reports, the next-generation Jeep will continue to soldier forth with a full steel chassis underneath its stamped bodywork. The biggest change, reports Automotive News, will be that said panels will be hewn from aluminum instead of steel, a seismic shift of a transition not unlike what's happened with the new Ford F-150. Because it won't be a unibody, the SUV will likely continue to be assembled in Toledo, OH as it (almost) always has been - the latter has been a source of heartburn in recent weeks for the Northwestern city in the Buckeye State.

Chrysler recalls 468,700 Jeep Grand Cherokees, Commanders over rollaway risk

Chrysler has issued a recall covering a combined 469,000 units of the 2005-2010 Jeep Grand Cherokee and the 2006-2010 Jeep Commander (inset). Of that number, 295,000 are in the US, roughly 33,000 in Canada and Mexico and the remainder in other markets. It seems an electrical fault in the transfer case can allow the affected SUVs to shift into neutral on their own, while an Associated Press report says that Chrysler had "found cracks in a circuit board that turns the four-wheel-drive system on and off." The issue was discovered when an owner started his car remotely and it rolled away.
Chrysler is expected to begin notifying owners in June 2013, who can then take their cars to dealers. The dealer will reflash the final drive controller free of charge. There's a bulletin from the National Highway Traffic Safety Administration below with more information.

Fiat 500X poised for Paris catwalk

We've known for some time that the new, Fiat-based baby Jeep (which may or may not be called the Jeepster) is set to arrive at the 2014 Geneva Motor Show. What we weren't sure of was whether its platform mate, the so-called Fiat 500X, would be doing so alongside or at a later date. Well, according to Reuters, we'll get to see the first all-wheel-drive 500 later this year in the City of Lights.
Yes, we can expect the 500X to arrive at the 2014 Paris Motor Show, according to an official with an Italian trade union. The unnamed source cited retooling at Fiat's Melfi factory, in southern Italy, which currently produces the Grande Punto. It's expected that the newest member of the growing 500 family will replace the Suzuki SX4-based Fiat Sedici, although when the X will go on sale remains an open question.
According to Reuters, both the Jeepster and 500X will be built alongside each other in Italy. Whether the 500X will cross the pond with it's slat-grilled cousin, though, remains to be seen (we're leaning towards yes).