1993 Jeep Yj on 2040-cars

Auto blog

7 months later, Jeep 'trailer hitch' recall still stalled

For the past few years, Chrysler and its CEO, Sergio Marchionne, have gone head-to-head with the National Highway Traffic Safety Administration and its boss, David Strickland, over the government safety agency's request for Chrysler to recall almost three-million Jeep vehicles due to what NHTSA says is a safety issue that has caused at least 51 deaths. After a three-year investigation and Chrysler's initial refusal to issue a recall because it deemed the vehicles safe and built to the day's federal requirements, last summer, the two parties compromised on a "voluntary campaign" to inspect 1.56 million vehicles, those being the 1992 to 1998 Grand Cherokee and 2002 to 2007 Liberty.
Those vehicles were designed with their gas tanks between the rear axle and the bumper, and NHTSA says that in rear-end collisions, damage to the fuel tank has caused fires responsible for those 51 deaths. The compromise reached last summer was that Chrysler would inspect 1.56 million vehicles and, "if necessary, provide an upgrade to the rear structure of the vehicle." Practically speaking, that meant Chrysler would replace aftermarket trailer hitches, but would take no action if a vehicle had a factory-installed hitch or an aftermarket hitch from Mopar.
A report in The Detroit News says the "voluntary campaign" is just now getting under way, with Chrysler saying last week that the design of the replacement part had been finalized and it was tooling up "to deliver the required volume." Seven months later, still in question is whether NHTSA will crash-test the fix engineered by Chrysler, noteworthy because not only did the vehicles in question pass every safety standard necessary to be cleared for sale at the time, there are still questions (to those of us on the outside) as to how the Jeeps at issue fare among their peers in such incidents. Either way, Chrysler and NHTSA apparently still disagree on the efficacy of the remedy itself: the carmaker says it might help in low-speed crashes but not high-speed collisions, a position the NHTSA is at odds with. All of this means the campaign doesn't yet have an end in sight.

NHTSA investigating 630k Jeep Wranglers for possible airbag fault

The National Highway Traffic Safety Administration is opening a preliminary evaluation into a possible wiring problem on some 2007-2012 Jeep Wrangler models that could affect airbag deployment. The government agency has 221 complaints alleging that the airbag warning light is illuminating, and that could indicate that the safety devices might not deploy in a crash. If a recall is necessary, an estimated 630,000 vehicles could be affected. According to the documents from NHTSA (as a PDF here), a "faulty clockspring assembly in the driver side airbag electrical circuit" could be the culprit. Also, some of the affected Wranglers are showing a fault code that indicates the safety device wouldn't deploy in an accident. However at this time, there are no reports of injuries related to this potential problem. NHTSA's preliminary evaluations are simply meant to investigate and don't necessarily lead to a recall. This isn't the first time for a potential problem like this on the Wrangler, though. A clockspring issue already led to a safety campaign for 2008-2012 right-hand drive Wranglers and an extended warranty for 2007 left-hand drive examples. Related Video: INVESTIGATION Subject : Air Bag Clockspring Wiring Failure Date Investigation Opened: JUN 19, 2015 Date Investigation Closed: Open NHTSA Action Number: PE15025 Component(s): AIR BAGS All Products Associated with this Investigation Vehicle Make Model Model Year(s) JEEP WRANGLER 2007-2012 JEEP WRANGLER 2-DR 4X4 2007-2009 JEEP WRANGLER 4-DR 4X2 2007-2009 JEEP WRANGLER 4-DR 4X4 2007-2009 JEEP WRANGLER SAHARA 2007 Details Manufacturer: Chrysler (FCA US LLC) SUMMARY: The subject vehicles display an airbag warning light that may indicate a failure of the clockspring wiring in the driver side air bag circuit. Several complaints cite the following diagnostic trouble code (DTC): Code B1B02 Open Squib to driver's air bag. This DTC would indicate a no-fire condition (disablement) for the driver air bag. ODI investigated the RHD (right hand drive) Wrangler for a clockspring issue under PE11-019 which led to NHTSA Recall 11V258 on model year (MY) 2008-2012 RHD Wranglers as well as an extended warranty campaign on MY 2007 LHD Wrangler vehicles. This investigation covers the MY07-12 LHD (left hand drive) Wranglers.

Fiat Chrysler working on an inline-six to replace the Pentastar V6?

Get out your Skeptics Hat for this one and keep it close by. Allpar cites "reliable sources" to write that Fiat Chrysler appears to be working on a new inline-six engine to be slotted into company products around the globe. The purported engine would be based on the 2.0-liter Global Medium Engine inline-four. Allpar first reported on the potential development in February 2017 and has filed a few updates since then, one citing "internal communications referring to a GME T6" — the "T" meaning turbocharged. It's said that some engineers have changed their online resumes to reflect their focus on the new motor. Apparently, FCA tried adding forced induction to the Pentastar V6 but didn't like the results. The new direction then turned toward a "compact straight-six." In at least one guise, the GME I-6 would come in at just under three liters in order to escape taxes on engines 3.0-liters and above in certain European markets; the 2.0-liter four-cylinder has an actual displacement of 1.995 liters. The present V6 Pentastar comes in 3.2-liter and 3.6-liter guises; a turbocharged 3.0-liter straight-six should be able to replace both as far as output. Hooking up to the company's eTorque system used on the 3.6-liter Pentastar and 5.7-liter Hemi would make things even more punchy. With the trend in truck engine downsizing, it wouldn't be crazy to see such an engine head straight to Ram. The four-cylinder GME unit serves in the Alfa Romeo Giulia and Stelvio, and Jeep Cherokee, Wrangler, and Grand Commander. The big Alfa Romeos and full-size Jeep and Ram models shouldn't have any problem with a longer inline engine. Maserati, which doesn't use the Pentastar engine, could be a candidate as well should it choose to step away from its Ferrari-developed engine cred. Speaking of Ferrari, the Italian brand is working up a new V6 based, in its words, on "a very, very particular architecture." It isn't clear where it will go or if one of the other Italian brands will get access to it, but the Allpar piece says the Ferrari V6 will be based on the core GME architecture for Maserati. Chrysler gave up its last inline-six 11 years ago when the 4.0-liter I-6 retired alongside the JK-series Jeep Wrangler. The engine format is back in vogue, and its reincarnations have received good reviews. But inline-sixes are generally longer, hence FCA's focus on a compact unit, and that could limit the purported engine's placement options.