2014 Jeep Compass Latitude on 2040-cars

Auto blog

Jeep going bigger with new Grand Wagoneer, smaller with sub-Renegade?

The headlines are still rolling in for the new Renegade that Jeep unveiled at the Geneva Motor Show last week, but already reports are surfacing, citing sources within the company, about what Chrysler's iconic off-road brand will do next.
Speaking with Auto Express (whose reports we tend to take with a grain of salt or two), Jeep chief Mike Manley suggested that two courses of action are currently under consideration at Auburn Hills to develop two very different new models - one smaller and one larger than anything Jeep currently makes.
One plan would be to make an SUV or crossover even smaller than the new Renegade, although it isn't immediately clear what platform it would take. The Renegade (pictured above in Trailhawk spec) will be built in Italy alongside Fiat's upcoming 500X, but uses a heavily modified platform. We figure the smaller model, if approved, could base itself on the new Fiat Panda Cross.

7 months later, Jeep 'trailer hitch' recall still stalled

For the past few years, Chrysler and its CEO, Sergio Marchionne, have gone head-to-head with the National Highway Traffic Safety Administration and its boss, David Strickland, over the government safety agency's request for Chrysler to recall almost three-million Jeep vehicles due to what NHTSA says is a safety issue that has caused at least 51 deaths. After a three-year investigation and Chrysler's initial refusal to issue a recall because it deemed the vehicles safe and built to the day's federal requirements, last summer, the two parties compromised on a "voluntary campaign" to inspect 1.56 million vehicles, those being the 1992 to 1998 Grand Cherokee and 2002 to 2007 Liberty.
Those vehicles were designed with their gas tanks between the rear axle and the bumper, and NHTSA says that in rear-end collisions, damage to the fuel tank has caused fires responsible for those 51 deaths. The compromise reached last summer was that Chrysler would inspect 1.56 million vehicles and, "if necessary, provide an upgrade to the rear structure of the vehicle." Practically speaking, that meant Chrysler would replace aftermarket trailer hitches, but would take no action if a vehicle had a factory-installed hitch or an aftermarket hitch from Mopar.
A report in The Detroit News says the "voluntary campaign" is just now getting under way, with Chrysler saying last week that the design of the replacement part had been finalized and it was tooling up "to deliver the required volume." Seven months later, still in question is whether NHTSA will crash-test the fix engineered by Chrysler, noteworthy because not only did the vehicles in question pass every safety standard necessary to be cleared for sale at the time, there are still questions (to those of us on the outside) as to how the Jeeps at issue fare among their peers in such incidents. Either way, Chrysler and NHTSA apparently still disagree on the efficacy of the remedy itself: the carmaker says it might help in low-speed crashes but not high-speed collisions, a position the NHTSA is at odds with. All of this means the campaign doesn't yet have an end in sight.

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.