2014 Jeep Cherokee Latitude on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

2015 Ford F-150 named Truck of Texas, Lincoln and Jeep also awarded at Truck Rodeo

The Ford Motor Company has a lot of reasons to celebrate after winning eight categories in this year's Texas Auto Writers Association's annual Truck Rodeo. Most important among them, the Blue Oval's latest 2015 Ford F-150 earned the prestigious Truck of Texas award, ending the Ram 1500's two-year winning streak. The 2015 Lincoln MKC also grabbed the honor as the CUV of Texas, and Ford was named Truck Line of Texas.
FoMoCo even took trophies for best technology with its extensive use of aluminum on its latest F-Series and best commercial vehicle for the new Transit 250. It wasn't a total sweep, though, because the Jeep Grand Cherokee grabbed the title of the SUV of Texas for the fifth straight time.
This year's event put 60 auto writers in 75 pickups, SUVs and crossovers and challenged them to find the best in a plethora of categories. All of the winners are listed below, and scroll down to read the full announcements from the Texas Auto Writers Association and Ford.

Stellantis axed the SRT engineer team, but performance isn't going away

Stellantis has broken up the Street & Racing Technology (SRT) engineering team that created over a dozen high-performance vehicles, including the Dodge Charger Hellcat, but the situation isn't as dire as it sounds. The newly-formed company assigned SRT's former engineers to different positions, where they'll continue to make hot rods. "All of the core elements of the SRT performance engineering team have been integrated into our company's global engineering organization," a spokeswoman told enthusiast website Mopar Insiders. She added that integrating SRT's personnel into other brands in the Stellantis portfolio will ensure that the lessons learned from decades of peddling speed will permeate other products. Previously, SRT operated with a high degree of independence. Don't get too excited. Her statement does not necessarily mean that Citroen will begin building cars powered by the Hellcat engine, though a C3 Chat D'enfer sounds absolutely epic. Technology transfer will likely be limited to fields like aerodynamics and thermal management, and the design department might learn a couple of neat new tricks. Dodge will still move forward with the development of its next SRT-branded cars; the decision to dissolve the SRT team will not affect future models, according to the spokeswoman. Whether they'll be powered by a V8 is up in the air, because company boss Tim Kuniskis warned that regulations are killing the eight-cylinder engine. Similarly, Jeep will continue designing high-performance models, like the Grand Cherokee Trackhawk. What changes is that the model will be developed and designed by a group of engineers and designers from Jeep, not from SRT. SRT is dead, but performance isn't going away. SRT's demise nonetheless marks the end of an era for Chrysler. The division traces its roots to 1989, when some of the company's brightest minds were brought together to develop the first-generation Dodge Viper. It merged with Team Prowler to form the Specialty Vehicle Engineering (SVE) group, which was renamed Performance Vehicle Operations (PVO) in 2002 and finally dubbed SRT in 2004. SRT has operated as the carmaker's in-house tuner since, its resume includes a diverse selection of cars ranging from the Neon SRT-4 to the 1500 TRX, and it was promoted to a standalone brand led by designer Ralph Gilles in 2011. Fiat-Chrysler Automobiles (FCA) axed the SRT brand in 2014 but kept the name and the development team. Related video: