1986 Jeep Cj7 Wrangler 4.2l 5 Speed on 2040-cars

Auto blog

Buy this instead of a Wrangler | 2017 Jeep Grand Cherokee Trailhawk Review

In our first encounter with the 2017 Jeep Grand Cherokee Trailhawk at Fiat Chrysler's Chelsea Proving Grounds, we saluted the new model's impressive on-road demeanor. In its off-road mode, however, we couldn't ignore the pre-production throttle calibration – it was super sharp and difficult to modulate with the precision needed to navigate obstacles. We were told then that Jeep's engineers were aware of the problem and were fixing it for production models. So we recently set off for Bundy Hill Off-Road Park in Jerome, Michigan, in a production-spec Grand Cherokee Trailhawk to check their work and get a better idea of the overall package. We can report that the Trailhawk's throttle has been fixed for production, landing it properly in Goldilocks territory. In the off-road Mud setting, the throttle is soft and easy to modulate. You can balance this rig with the gas pedal, reaching just past tip-in to steadily prod forward. But the gas pedal doesn't delay when you really need power. Move beyond the initial tip-in, and the engine responds quickly, which is a good thing, as a sluggish throttle is almost as dangerous off-road as one that's too sharp. Rock mode promises even more precise control over the throttle, although our lack of a spotter and a desire to avoid damaging the 700-mile-young Trailhawk kept us from hitting Bundy Hill's rockier sections. The wet, non-snowy weather meant we didn't properly test Snow or Sand mode. This test model was equipped with FCA's popular 3.6-liter V6, but like the rest of the Grand Cherokee range, more power is available from the 3.0-liter EcoDiesel V6 and the 5.7-liter Hemi V8. You don't need them – the 3.6-liter and eight-speed automatic are perfectly fine on the trails. Faced with an incline, the transmission holds its gear without complaint – you don't even need to switch into manual mode. Despite the 4,800-rpm torque peak, the V6's 260 pound-feet arrive early enough that you don't need to strong-arm the throttle. So that's resolution for the pre-production issue. But our time at Bundy Hill exposed a different and ultimately much easier to fix problem for the production model. Late fall in Michigan is not always a good time to go off-road – sub-40-degree temperatures and a steady, depressing drizzle can turn a relatively simple trail into a slippery mess of wet clay. Conditions like these can easily overwhelm an on-road tire like the Goodyear All-Terrain Adventures the Trailhawk uses.

Star Trek actor's death may be linked to Jeep shifter issue

The tragic death of Anton Yelchin on Sunday may have resulted from a known design flaw with his Jeep Grand Cherokee. The 27-year-old actor, best known for playing Pavel Chekov in the latest Star Trek movies, was reportedly crushed when his vehicle rolled backwards down the driveway in front of his house, pinning him against a brick pillar and metal gate. The 2014-15 Grand Cherokee was one of three models (alongside the Dodge Charger and Chrysler 300 sedans) that Fiat Chrysler recalled this past April due to roll-away risk. The vehicle was equipped with an unintuitive "e-shifter" that didn't deliver the usual tactile response of being shifted into position, leading to numerous drivers exiting the vehicle mistakenly thinking that it was in Park. The problem was reported to have resulted in 41 injuries – and now possibly Yelchin's death as well. The manufacturer stated at the time of the recall that "the vehicles involved in these events were inspected and no evidence of equipment failure was found." It determined that while the vehicle warned occupants if the driver's-side door was opened while the engine was running and the transmission not in the Park position, such measures may have been insufficient. Its remedy for the problem involved updating the vehicle software to better warn drivers in such an event, and changing the design for subsequent models. "Regarding the recall," an FCA spokesman told Autoblog, "I can confirm notices were mailed to affected customers. Included in those notices were tip sheets describing proper operation of the shifter. This supplemental information echoes the instructions in the owner's manual." Yelchin was born March 11, 1989, in St. Petersburg, Russia. His parents were a figure-skating pair, and defected to the United States when Anton was just six months old. In the prime of his career, Yelchin had several films currently in development, including Star Trek Beyond, set to reach theaters next month. His body was reportedly discovered by friends when he didn't show up for rehearsal. Related Video:

Jeep owner inadvertently receives 2018 Wrangler hood from scrapyard

After an apparent mix-up, FCA may be looking for a new scrapyard to which to send prototype parts. JLWranglerForums.com member Redrockjk recently purchased a used Wrangler hood from a yard near the FCA proving grounds. When he ordered it, he thought it was from a 2014 model, and while it looked very similar to his current hood, after installing he discovered something unusual. It was too long. From what we can see in the photos from JLWranglerForums.com, the leading edge of the hood sticks out roughly two inches from the top of the Wrangler's grille. The greater length is also clear when the hood is placed next to its likely predecessor. The receivers for the exposed latches are also too far forward to be used on a current Wrangler. Redrockjk also said there wasn't a VIN or a part number anywhere on the hood. As if those details weren't a big enough red flag, Redrockjk reported that the used parts supplier contacted him to ask for the hood back. We reached out to Jeep to see if they could confirm if this is a hood for the next-generation Wrangler. Unsurprisingly, the company had no comment at this time. Considering the details, and the proximity of the scrapyard to an FCA proving ground, there's a better than zero chance this is from a pre-production 2018 Wrangler sent to the yard to be scrapped. No word on whether the hood was aluminum, as has been rumored. Except for the length, the part fits pretty well on the current model. The hood vents present are also similar to those found on some current models. It's one more piece of evidence that the next Wrangler won't stray far from a proven formula. Related Video: Featured Gallery 2018 Jeep Wrangler Hood News Source: JLWranglerForums.comImage Credit: JLWranglerForums.com Spy Photos Jeep SUV Off-Road Vehicles forum wrangler forums