1977 Amc Jeep Cj7 on 2040-cars

Auto blog

FCA recalls 570,000 SUVs from Jeep and Dodge over fire woes

Fiat Chrysler US has issued two recalls covering a total of about 570,000 Jeep and Dodge models. The first concerns vanity mirror wiring in the Jeep Grand Cherokee from the 2011 and 2012 model years, and in Dodge Durango units built before September 12, 2012. The automaker recalled almost 900,000 units last year to repair the issue, then faced more issues this year when the fires continued in repaired vehicles. This new recall seeks to resolve the issue, FCA saying that the post-recall fires happened in a tiny percentage of vehicles equipped with a specific wiring package. This recall is for 352,831 total units in the US, another 26,478 in Canada, 13,037 in Mexico, and 84,330 internationally. No injuries or deaths have been reported. FCA says it will inform customers as to when they can schedule a service visit to remedy the issue. The second recall takes aim at 60,107 examples of the Jeep Compass and Patriot from the 2015 model year in the US, plus 5,755 in Canada, 3,351 in Mexico, and 23,995 in other markets. Those models could suffer from an out-of-position clamp on the power steering fluid line. The error could allow fluid to leak, increasing the risk of a fire if the fluid ends up on a hot surface. In the case of a complete loss of fluid, drivers will need to use a lot more effort to steer. The automaker reports no injuries or accidents, and will advise customers when to head to the dealer for service. Related Video: Jeep Grand Cherokee and Dodge DurangoStatement: Vanity-Mirror WiringDecember 24, 2015 , Auburn Hills, Mich. - FCA US LLC is recalling an estimated 352,831 SUVs in the U.S. to help ensure vanity-mirror wiring may be serviced more consistently.Overheating conditions were reported among a small percentage of vehicles (<0.02%) serviced in connection with a related recall, conducted previously.** An FCA US LLC investigation discovered the service procedure, if not followed precisely, may leave vehicles susceptible to a short-circuit, creating a potential fire hazard.The Company is unaware of any related injuries or accidents. Post-service overheating conditions were observed only in vehicles equipped with a certain wiring package. These vehicles were produced before Sept. 2, 2012.Affected are model-year 2011-2012 Jeep Grand Cherokee and Dodge Durango SUVs produced before Sept. 2, 2012. Wiring in the headliners of these vehicles will be secured with a new adhesive.

Watch this Jeep Willys return to its birthplace after 70 years

Earlier this month, a very significant Jeep was celebrated at the Toledo North Assembly plant. No, it wasn't the upcoming reincarnation of the Jeep Cherokee, but instead it was a 1943 Willys MB that visited the Toledo grounds where it had been built exactly 70 years ago to the day.
Of course, the actual building where the MBs rolled off the assembly line before heading to Europe for World War II no longer exists, but that didn't stop Italian owner Vittorio Argento from having the vehicle shipped to the US to make its trek back to its birth place. According to Chrysler, Argento's MB is still 95-percent original and it drove 1,000 miles from New Jersey to Toledo.
The whole adventure was chronicled on a blog aptly named A Jeep Comes Home. Scroll down for a brief video from Chrysler and for some photos of the Toledo visit and be sure to read more at Argento's blog.

Ford will put solid axles under the Bronco as the off-roading gods intended

We've been wondering what sort of creature the Bronco would be since we first heard of the thing last October, when a union chairman spilled the beans on the SUV and the Ranger pickup. Ford confirmed a 2020 arrival date for the Bronco at the 2017 Detroit Auto Show, but at that point pretty much all we were sure of was that the Ranger and Bronco would be returning. The open question would be how hungry Ford was to spoil the Jeep Wrangler's solo party as a compact(ish) off-roader with dual solid axles, since the easiest thing would be to carry over the suspension design of the presumably related international Ford Ranger and its Everest SUV version: independent front suspension with either a leaf- (Ranger) or coil-suspended (Everest) solid rear axle. Enter Dana, the long-time supplier of Jeep stick axles, to confirm that the 2020 Bronco is getting a pair of them. That means solid axles front and rear, just like under a Wrangler. So reports Automotive News, citing an investor presentation from Dana. All signs so far, such as the report that the Bronco would be engineered by the same team in Australia that created the Ranger pickup, indicated that the Bronco would share a platform with the Ranger and thus be body-on-frame. The solid axle confirmation essentially confirms that theory. Some off-road-capable vehicles have paired solid axles with unibody frames, like the Jeep Cherokee (XJ generation) and Grand Cherokee (ZJ and WJ generations), but they are outliers. Generally, if you've got solid axles at both ends, they're going in a vehicle with a ladder frame. It also lends credence to the notion that our Bronco won't simply be an imported Everest, which might be too understated to stand out from lesser crossovers anyways. This is good news if you have Blue Oval in your blood and pine for a modern SUV that'll show up the Jeep guys on the trail. Less directly, it could mean a wholesale assault on the formula that makes Jeeps successful in the first place: the massive aftermarket of off-roading equipment and dress-up bits that appeal to Jeep buyers almost as much as a Trail Rated badge. At a minimum, Bronco enthusiasts can breathe easy that the reborn SUV won't merely be a light-duty crossover with styling "inspired" by true off-roaders. There's still a lot left to learn about the Bronco. Keep up to date with our running summary of everything we know about the returning off-roader.