2011 Hyundai Elantra Touring Gls Used 2l I4 16v Fwd Hatchback on 2040-cars

Auto blog

Hyundai recalls 205,000 Elantras for possible power steering failure [UPDATE]

UPDATE: Autoblog reached out to Hyundai spokesperson Jim Trainor for more information about this recall. He let us know via email: "Owners will be notified beginning in the second quarter." Also, there have been "no accidents, injuries nor fatalities," as a result of this issue. Hyundai is recalling 204,768 examples of the 2008-2010 Elantra sedan and 2009-2010 Elantra Touring because of possible failure of the electrically assisted power steering. The problem in these vehicles is that the ECU for the power steering can "sense a discrepancy in the steering input signals and, as a result, disable the steering power assist," according to documents submitted to the National Highway Traffic Safety Administration. If this happens, then drivers could suddenly experience a more difficult time driving the Elantras. According to a chronology submitted to NHTSA (that you can read in full as a PDF, here), Hyundai first became aware of this problem in 2010 and issued a TSB for it in 2011. At that time, just 0.25 percent of sedans and 0.36 percent of Touring models were shown to have the fault. However by October 2014, the issue had gotten worse, and 1.3 percent of four-doors and 1.9 percent of the hatchbacks were exhibiting it. The automaker believed that by maintaining manual steering the vehicles were still within the law, but "the industry has increasingly handled similar issues through safety recalls." In most cases, turning the ignition off and then back on rectifies things, but to fix this, Hyundai is updating the power steering control unit on these models. RECALL Subject : Electric Power Steering Assist may be Disabled Report Receipt Date: FEB 23, 2015 NHTSA Campaign Number: 15V100000 Component(s): STEERING Potential Number of Units Affected: 204,768 All Products Associated with this Recall Vehicle Make Model Model Year(s) HYUNDAI ELANTRA 2008-2010 HYUNDAI ELANTRA TOURING 2009-2010 Details Manufacturer: Hyundai Motor America SUMMARY: Hyundai Motor America (Hyundai) is recalling certain model year 2008-2010 Elantra vehicles manufactured June 1, 2008, to April 30, 2010, and 2009-2010 Elantra Touring vehicles manufactured November 1, 2008, to April 30, 2010. The electronic power steering (EPS) electronic control unit (ECU) may sense a discrepancy in the steering input signals and, as a result, disable the steering power assist.

NHTSA closes investigations into Ford Taurus, Hyundai Santa Fe

Ford and Hyundai are out from under the scrutinizing eyes of the National Highway Traffic Safety Administration after the government agency said it was closing investigations against both automakers over vehicle safety concerns.
Ford was being investigated for reported damaged speed control cables on Ford Taurus (shown above) and Mercury Sable models, both built between 2000 and 2003. Vehicles with the company's Duratec engines allegedly failed to allow owners to brake as expected. Owners lodged 100 complaints and were involved in five accidents, according to NHTSA records. The American automaker responded to the reports, and on June 21 of this year, said that it would inspect and repair all affected vehicles, regardless of the mileage.
Hyundai was under investigation for a reported loose fastener on the steering shaft of its 2011 Santa Fe (shown in the gallery below). After NHTSA launched its inquiry, the Korean automaker responded with its own investigation that yielded four affected vehicles. Following the inspection of 680 vehicles at its assembly plant, Hyundai said the issue was due to employee error and that no further defects have been found.

New autonomous testing ground in Michigan will help battle bad weather

If one of the big weaknesses of autonomous vehicles is their ability to navigate in the snow, consider this a trial by fire. The American Center for Mobility says it has opened its $110 million driverless car testing facility on the site of a former General Motors assembly plant in Michigan, with Toyota and auto supplier Visteon the first to begin testing this week. The ACM proving ground is a 500-acre site at historic Willow Run in Ypsilanti Township, near Ann Arbor. It's one of 10 sites designated by the U.S. Department of Transportation as pilot proving ground sites to test AV technologies. It features a variety of simulated environments to test driverless cars, including a 2.5-mile highway loop, two double overpasses, intersections, roundabouts and a 700-foot curved tunnel. It also opens just as the region experiences a series of snowstorms and the first frigid temperatures of the season. That ability to test autonomous vehicles in a wide variety of weather conditions is important, as autonomous vehicle sensors have struggled to handle cold, wet and snowy conditions. Google parent Alphabet in October said its Waymo division was expanding its winter testing operations to Michigan, making it the sixth state where it's testing its driverless car systems. In a Medium blog post, Waymo CEO John Krafcik wrote that "This type of testing will give us the opportunity to assess the way our sensors perform in wet, cold conditions. And it will also build on the advanced driving skills we've developed over the last eight years by teaching our cars how to handle things like skidding on icy, unplowed roads." Waymo also opened a development center in suburban Detroit in 2016, working with Fiat Chrysler to integrate its autonomous technology into Chrysler Pacifica hybrid minivans. Visteon began testing and validating its DriveCore autonomous driving platform to evaluate algorithms, vehicle-to-vehicle and vehicle-to-infrastructure technology and other systems. Toyota used the facility Wednesday to begin orientation and driver training. ACM has so far secured $110 million to construct the first two phases from founders Ford, Hyundai America Technical Center, Toyota and Visteon, and says it expects to announce more investment soon.