2000 Honda S2000 ***no Reserve*** on 2040-cars

Auto blog

Honda flaunts freshened 2014 Civic Coupe at SEMA

Honda took the wraps off its 2014 Civic Coupe (red car pictured above) and 2014 Civic Si (gray car in the gallery below) at SEMA today, revealing a mid-cycle refresh for each model. The standard Civic coupe benefits from several cosmetic enhancements, while the Civic Si gets the bulk of its improvements under the hood - precisely where the enthusiasts want them.
The best-selling Civic Coupe sports a new front fascia that is "fun and sporty," says the automaker. The more aggressive snout is a step in the proper direction, as its new shape and exclusive grille design gives the two-door a distinctive appearance that sets it apart from its sedan sibling. The rear end follows the same design language, as the lower portion of the urethane bumper gains some character - its smooth surface has been resculpted and recontoured. Newly available 18-inch wheels complete the exterior transformation.
The 2014 Civic Si benefits from a larger spoiler and new wheels, but the big news is in the powertrain. Honda has massaged the 2.4-liter i-VTEC engine and opened up the exhaust system. As a result, output climbs to 205 horsepower (up from 201) and torque increases to 174 pound-feet (up from 170). The power gains aren't extraordinary, but they should allow the coupe to hit 60 miles per hour from a standstill in about six seconds flat and still return over 30 mpg on the open road. Scroll down for the official release.

Automakers drop support for Trump effort against California emissions

WASHINGTON — Toyota, Fiat Chrysler (now known as Stellantis following its merger with Peugeot) and other major automakers said on Tuesday they were joining General Motors in abandoning support for former President Donald Trump's effort to bar California from setting its own zero emission vehicle rules. The automakers, which also included Hyundai, Kia, Mitsubishi, Mazda and Subaru, said in a joint statement they were withdrawing from an ongoing legal challenge to California's emission-setting powers, "in a gesture of good faith and to find a constructive path forward" with President Joe Biden. The automakers, along with the National Automobile Dealers Association, said they were aligned "with the Biden administrationÂ’s goals to achieve year-over-year improvements in fuel economy standards." Nissan in December withdrew from the challenge after GM's decision in November shocked the industry and won praise from Biden. On Monday, the Justice Department asked the U.S. Appeals Court for the District of Columbia to put the California emissions litigation on hold to "ensure due respect for the prerogative of the executive branch to reconsider the policy decisions of a prior administration." Biden has directed agencies to quickly reconsider TrumpÂ’s 2019 decision to revoke CaliforniaÂ’s authority to set its own auto tailpipe emissions standards and require rising numbers of zero-emission vehicles, as well as Trump's national fuel economy rollback. Asked to respond to the automakers' action, White House climate adviser Gina McCarthy said in a statement that "after four years of putting us in reverse, it is time to restart and build a sustainable future, grow domestic manufacturing, and deliver clean cars for America." California Governor Gavin Newsom praised the automakers on Twitter for "dropping your climate-denying, air-polluting, Trump-era lawsuit against CA" and urged them to join the voluntary framework. TALKS WITH BIDEN Separately, an industry trade group on Tuesday proposed to start talks with Biden on revised fuel economy standards that would be higher than Trump-era standards but lower than ones set during the prior Democratic administration. The Trump administration in March finalized a rollback of U.S. Corporate Average Fuel Economy standards to require 1.5% annual increases in efficiency through 2026, well below the 5% yearly boosts under the Obama administration rules it discarded.

A closer look at the motorcycle El Chapo used to escape prison

Joaquin Archivaldo Guzman Loera, better known by his nickname, El Chapo, stands five-feet, five-inches tall. This defining trait – his nickname, not coincidentally, can be translated as "Shorty" in Spanish – is an important detail in his escape, as the tunnel that stretched a mile underground that led the drug kingpin to safety measures just one inch taller than Guzman's height. Clearly, this was a well-planned and executed escape. The tunnel that was custom-sized to perfectly fit El Chapo started at an abandoned building in the middle of an empty field and ended in a tight shaft that led to the shower stall in Guzman's jail cell. In between those start- and finish-points was an impressively dug-out hole in the Earth, complete with ventilation shafts, wiring for electricity and lights, and rails on the bottom to serve as tracks for a custom-built motorcycle that El Chapo apparently rode to freedom. There are specific traits that could be useful in figuring out what kind of motorcycle we're looking at. All of these facts are well-known to anyone who's been following the story of how the most notorious criminal in Mexico could escape from a maximum-security prison in broad daylight. Especially considering that this event marks the second time since 2001 that Guzman has arranged his own prison break. There's one detail, though, that has caught our attention. A close look at the images released by Mexican authorities shows us a motorcycle that's been heavily modified specifically to work underground. We can't be certain, based on the grainy shots and limited viewing angles of the pictures we have access to, but there are some specific traits that could be useful in figuring out what kind of motorcycle we're looking at. For starters, there's the engine. It's a single-cylinder, air-cooled powerplant, canted slightly forward. The exhaust exits on the right side of the bike, when looking from above, and there's a short chain guard on the opposite side. Granted, that doesn't narrow it down all that much. A look at the shape of the fins on the cylinder and the shape of the head, though, makes us think this may be one of Honda's ubiquitous CG-series of engines. A quick look at the bike's frame shows a single downtube, dual shocks and a steel-tube swingarm. That means it's probably not of particularly recent vintage, but we can't really pinpoint exactly what model it may be.