2014 Honda Odyssey Ex on 2040-cars

Auto blog

Honda recalls Accord to replace airbag control unit

The Basics: Honda will recall 341,444 examples of the 2008-2010 Accord sedan in the US. The Problem: Moisture can enter the supplemental restraint system electronic control unit and cause corrosion. Over time, this could cause the part to fail, which might prevent the airbags from deploying in a crash. Injuries/Deaths: Honda confirms two injuries from this problem. The Fix: Dealers will replace the supplemental restraint system electronic control unit. If You Own One: Honda won't begin the recall until fall 2016 because of the large number of vehicles that will need the repair. The company will inform owners about the problem by mail in mid-March and will notify them again when the parts are available. However, if owners see the supplemental restraint system warning light illuminate before the recall begins, they can visit a dealer for a diagnostic check. If technicians find the problem, then they can replace electronic control unit immediately from Honda's limited supply of replacement parts. Related Video: Statement by American Honda Regarding SRS Electronic Control Unit Recall: 2008-2010 Honda Accord Sedan Feb 3, 2016 - TORRANCE, Calif. Approximately 341,000 Accord Sedans affected in the United States The SRS electronic control unit will be replaced, free of charge Two injuries have been confirmed related to this issue American Honda will voluntarily recall approximately 341,000 Honda Accord Sedans from the 2008-2010 model years in the U.S. to replace the Supplemental Restraint System (SRS) electronic control unit. Manufacturing process issues may allow moisture to enter the circuitry within the SRS electronic control unit, which, over time, can cause corrosion and eventual malfunction of the unit. If the SRS control unit fails from this scenario, the SRS indicator will illuminate on the vehicle's dashboard, and, in the event of a vehicle crash, the airbags may not deploy, increasing the risk of injury. Honda has confirmed two injuries related to this issue. A new SRS control unit will be installed in affected vehicles, free of charge. However, due to the large volume of new parts needed to repair affected units, the necessary parts will not be available until fall 2016. As a result, owners of affected vehicles will be informed of the recall in an initial mailed notification letter in mid-March 2016. A second notification letter will be sent to inform owners when parts become available.

Toyota Camry to go turbo

As automakers strive to meet regulations, turbocharging is rapidly becoming the norm whether looking at pickups, sports cars or family sedans. However, Toyota remains a stalwart to the changing tide, and for the time being a trip into one of the brand's dealers shows nary a hint of forced induction – probably not for long, though. With models like the Lexus NX 200t and forthcoming IS 200t pointing the way, a big shift is afoot for one of the Japanese automaker's most popular products. Obviously, Toyota is no stranger to forced induction for performance applications like the turbocharged models of the Supra and MR2 in the '90s. But rather than reducing lap times, the latest application is more about improving emissions and fuel economy. According to Automotive News, the Camry is getting a 2.0-liter turbo four-cylinder in the near future as a replacement for its V6 engine option. The 3.5-liter six currently in the venerable sedan already makes 268 horsepower and 248 pound-feet of torque, versus 235 hp and 258 lb-ft in the NX 200t or 241 hp and 258 lb-ft in the IS from the new four. The base four-cylinder also might receive some upgrades. It could grow larger and run on the Atkinson cycle to find improvements, according to Automotive News. There might be a move towards CVTs, as well. Toyota is hardly alone in the shift towards forced induction. Honda is known to have a 1.5-liter turbo mill on the way for the next-gen Civic. In addition, that engine might find its way into the Accord and CR-V as well, according to Automotive News. Among the major Japanese automakers, only Nissan is taking a more measured approach towards forced induction in mainstream models. Rather than going all-in on turbos, the company is expected to shift more of its engines to direct injection to go after fuel economy gains.

Clarion Builds 1991 Acura NSX Review | Restored to greatness

Few automobiles garner as much mystique as the original Acura NSX. I worshiped this car from afar, consigned to the fact that the closest I was ever going to get to the steering wheel was a Playstation controller. When I got the email inviting me to drive Clarion Builds' restored and tuned 1991 NSX, I thought it was spam, a chain email with some generic header sent to a dozen or so people to garner some press coverage. Surely this wasn't a real invite where I get to drive a real NSX using my real hands and feet. Some people say don't meet your heroes. Some people are wrong. I knew the car by reputation. In roughly 10 months, Clarion Builds, a division of the Japanese electronics company mostly known for high-end audio systems, worked with partners like AEM and AutoWave to transform a '91 NSX with nearly a quarter-million miles on the clock into what you see here. Everything, from the engine to the bodywork to the leather on the seats, has been upgraded and restored with a mix of both OEM and aftermarket parts. The final product is a stunner. It's tuned, but not slammed, stanced or any other adjective that describes a car with compromised performance and questionable looks. It's simply a tastefully tuned NSX. The NSX, especially an early car with pop-up headlights, is one of the all-time great car designs. There are no unnecessary lines or curves. It's all purposeful. As expected with something with 230,000 miles, this NSX had a number of dings and dents. Clarion Builds has fixed those, replacing the hood and spoiler with carbon-fiber parts from an NSX-R. The fenders are slightly wider than stock, helping cover the staggered Rays Engineering VOLK ZE40 wheels, 18-inch up front and 19-inch out back. After seeing it in the flesh with the blue paint, black roof and bronze wheels, I don't think there is a better fit for this car. The original but tired 3.0-liter V6 and five-speed manual have been swapped for a 3.2-liter V6 and six-speed manual from a 2004 NSX. Stock, this engine is a wonderful ode to the internal combustion engine. It sings a sweet song all the way to a sky-high 8,200 rpm redline. Still, it wasn't enough. The engine now wears a Whipple-style supercharger, pushing roughly 9 psi of boost. Other modifications include a one-off carbon-fiber intake, a hand-built exhaust and a new ECU, all from AEM. All in, Clarion Builds says this NSX makes 403 horsepower and 296 pound-feet of torque at the wheels. God, it feels good to push this thing.