2011 Honda Accord Lx-s on 2040-cars

Auto blog

Honda recalling 143K Civic, Fit models for CVT

Honda is recalling 143,676 examples of the 2014-2015 Civic and 2015 Fit for a problem with the way that its software controls the CVT. Currently, the system uses high hydraulic pressure in the transmission at times, which can put stress on the drive pulley shaft. Also, some of those parts "may have been produced at the low end of the hardness specification" during manufacturing, the automaker reports. When the two factors are combined over time, the high pressure could cause the shaft to break. If this happens, it would result in losing drive to the front wheels or in them locking up. According to documents submitted to the National Highway Traffic Safety Administration (as a PDF), Honda received the first report of a shaft breaking in July 2014 in the US, and there was a wheel lockup in Canada in January 2015. As of September 3, there were 23 warranty claims about this issue but no reported injuries. The fix will be an update to the CVT's software, and the recall will begin October 16, according to NHTSA. Honda is urging owners to get their vehicles repaired as soon as they receive the notification. Related Video: Statement by American Honda Regarding CVT Drive Pulley Shaft Recall: 2014-2015 Civic and 2015 Honda Fit Oct 1, 2015 - TORRANCE, Calif. Honda will voluntarily recall approximately 143,000 model-year 2014-2015 Civic and 2015 Fit vehicles in the United States to update the software that manages the continuously variable transmission (CVT), free of charge. Affected vehicles have CVT control software that is written to use high hydraulic pressure during certain CVT operation modes, which as a result may subject the drive pulley shaft to high stress. In addition, during manufacturing of the drive pulley shaft, some parts may have been produced at the low end of the hardness specification. If shafts with lower hardness are repeatedly subjected to the specific high hydraulic pressure modes, it may result in the shaft breaking during operation. If the drive pulley shaft breaks, the vehicle may lose acceleration or the front wheels may lock up while driving, increasing the risk of a crash. No crashes or injuries have been reported related to this issue, which was discovered through the warranty claim process in the United States. Honda is announcing this recall to encourage each owner of an affected vehicle to take it to an authorized dealer as soon as they receive notification of this recall from Honda.

Honda adds tech to 2016 CR-Z, no powertrain upgrades

Rumors suggest that the next-gen Honda CR-Z could finally become a real performance machine by dropping the hybrid setup in favor of a detuned version of the European Civic Type R's 2.0-liter turbocharged four-cylinder. We aren't there yet, though, and for 2016 the wedge-shaped model instead receives a styling upgrade and some new tech. However, the hybrid powertrain is still exactly the same. As previewed by the Japanese version earlier this year, the 2016 CR-Z receives a revised face with a reshaped grille. The front diffuser now slashes through the lower air dam to create triangular niches for the foglights. At the back, a redesigned bumper further echoes the nose's styling. Honda's designers also tweak the interior by switching to an electric parking brake. This might seem minor, but because there's no longer a lever, a center console with an armrest can take up the open space. In addition, drivers can enjoy better infotainment from a standard, seven-inch Display Audio system. For the EX trim and above, the screen is used for the company's LaneWatch tech, too. Moving up to the top-spec EX-L adds navigation and heated leather seats. Even with the powertrain the same, the 2016 CR-Z might drive a little better. Honda's engineers thicken the front stabilizer bar a hair and widen the rear track by 0.4 inches. The brake discs are also now 11.1 inches at the both ends, versus 10.3-inches at the front and 10.2 inches at the back previously. For 2016, Honda revises the trims to LX, EX, and EX-L, but prices jump slightly. A base model now starts at $21,130 (with the $835 destination charge) versus $20,965 last year (with $820 destination). Perhaps these upgrades are enough to goose CR-Z sales because through September the model is down 25.1 percent with a volume of just 2,205 units. Related Video: Design Updates, Enhanced Tech and New Higher-Level Trim Make the Fun and Efficient 2016 CR-Z Hybrid Sport Coupe More Stylish and Feature Rich • New styling, inside and out, and new line-topping EX-L with standard navigation • New available features include 7-inch Display Audio, Smart Entry and Push Button Start/Stop, Electric Parking Brake and Honda LaneWatch™ • New Honda accessories options TORRANCE, Calif., Nov.

Honda Project 2&4 is our kind of sidecar sideshow [w/video]

Honda makes cars and Honda makes bikes. It makes a whole lot of other things, too, but those are the two areas of expertise that have given rise to the thoroughly enticing Project 2&4 concept. It's one of the smallest vehicles unveiled here at the 2015 Frankfurt Motor Show, but also among the most enticing. The result of a global in-house design competition, Project 2&4 was envisioned by the company's motorcycle studio in Asaka and brought to fruition with help from the automotive studio in Wako. It's powered by the 1.0-liter V4 engine Honda developed for MotoGP competition, driving 212 horsepower and 87 pound-feet of torque through a six-speed, dual-clutch transmission. With less than 900 pounds to motivate, that adds up to blistering performance of the kind we'd give most anything to experience firsthand. The 14,000-rpm redline would be enough to make our heart sing all on its own, but the novelty of Project 2&4 is its design. As you can see, it hands the driver's seat and controls off the side, with room for a hold-on-for-dear-life passenger seat on the other side. The neo-retro styling is inspired by the company's RA272 grand prix racer from the Sixties, but gives up on the center driving position for an altogether more original configuration. The result looks ready to take on the likes of the Ariel Atom and BAC Mono... to say nothing of the curbs of Suzuka and Fuji. If only Honda were (able) to put it into production.