Hybrid Electric Gas Gmc Yukon Slt Heated Leather 3rdrow Submodel Chevrolet Tahoe on 2040-cars

Auto blog

GM follows up Lambda CUV stop-sale with tire recall

In late January, General Motors announced a stop-sale for about 6,281 examples of the 2015 Chevrolet Traverse, GMC Acadia and Buick Enclave because of the possibility for the treads cracking on their 18-inch Goodyear Fortera HL tires. At the time, GM said that this would also eventually lead to a safety campaign to repair the problem, and the National Highway Traffic Safety Administration has just published those details. GM's recall covers 5,876 of the three Lambda platform crossovers to replace their tires. According to NHTSA, if the treads crack, there could be a loss of pressure and possible failure. Goodyear already announced its own recall of the tires after internal testing found small tread cracks. The company did not believe this was safety issue, but the problem did put the rubber out of compliance with federal laws. The business's safety campaign covered an estimated 48,512 tires. Of those, around 32,000 were reportedly made for GM to either be fitted to vehicles or sold as replacements. The remainder went to the aftermarket. Goodyear's portion of the recall is expected to begin around February 20. RECALL Subject : Tire Tread Cracking/FMVSS 110 Report Receipt Date: JAN 28, 2015 NHTSA Campaign Number: 15V044000 Component(s): TIRES Potential Number of Units Affected: 5,876 All Products Associated with this Recall Vehicle Make Model Model Year(s) BUICK ENCLAVE 2015 CHEVROLET TRAVERSE 2015 GMC ACADIA 2015 Details Manufacturer: General Motors LLC SUMMARY: General Motors LLC (GM) is recalling certain model year 2015 Buick Enclave vehicles manufactured December 9, 2014, to January 14, 2015, 2015 Chevrolet Traverse vehicles manufactured December 9, 2014, to January 20, 2015, and 2015 GMC Acadia vehicles manufactured December 9, 2014, to January 16, 2015, and all equipped with Goodyear P255/65R18 Fortera HL tires. These vehicles are equipped with tires that may experience tread cracking. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 110, "Tire Selection and Rims and Motor Home/Recreation Vehicle Trailer Load Carrying Capacity Information for Motor Vehicles with a GVWR of 4,536 kilograms (10,000 pounds) or Less." CONSEQUENCE: If the tire treads crack, a loss of tire pressure and possible tire failure may result, increasing the risk of a crash. REMEDY: GM will notify owners, and dealers will replace the tires that were manufactured within a specific date range, free of charge.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

2015 GMC Yukon Denali

Automotive enthusiasts often wonder aloud - ourselves included - why General Motors would choose to keep GMC while sending Pontiac (and Saturn, and even Oldsmobile before it) into the great automotive graveyard in the sky. The answer, as is so often the case, is profit. It's much easier for GM to rake in money hand over fist by rejiggering the trucks, crossovers and SUVs that it would already be developing for Chevrolet and making them a bit more luxurious and *ahem* "Professional Grade" with new grilles, badges and unique packaging for GMC.
While it may sound like we're being cynical, we totally approve of GM's fullsize SUV strategy. The least-expensive way to get into the fold is with the Chevrolet Tahoe, which starts at $45,595 with a 5.3-liter V8 engine and a cloth interior. Bumping that same Chevy to LTZ trim and its $59,995 sticker price lands a much nicer leather-clad interior and more techno-bells and whistles than you can shake a stick at. But it still looks like a Tahoe, and it still comes with the smaller 5.3-liter engine. Or, you could do what we'd do: Walk into your GMC dealer and take a look at the Yukon Denali. Here's why.
Driving Notes