2007 Gmc Yukon Xl Slt on 2040-cars

Auto blog

GM pushing back on proposed pickup and SUV brake recall [w/poll]

Through the first six months of 2014, General Motors has recalled 29 million cars and trucks in 54 different actions. If your author's notoriously sketchy math is correct, that'd work out to one recall every 3.5 days (as of this writing). GM is actively fighting to make sure there isn't a 55th recall, though.
Safety critics, including perennial nemesis Clarence Ditlow of the Center for Auto Safety, are calling on GM to recall a further six million pickup trucks and SUVs in northerly climes due to corroding brake lines caused by the use of road salt. There is a catch, here, though ­- the vehicles in question are over 10 years old, and include the 1999 to 2003 Chevrolet Silverado, Suburban and GMC Sierra, as well as the 2000 to 2003 Tahoe and Yukon (shown above).
GM issued the following statement on the matter, obtained by CNN Money:

2020 GMC Acadia AT4 priced just a little more than the SLT trim

Cars Direct has seen the order guide pricing the 2020 Acadia AT4 at $42,495 after destination; that means a $41,300 MSRP plus $1,195 for shipping and handling. GMC has left a lot of pricing room between the rugged, all-wheel drive AT4 and the dressed-up, top-shelf Acadia Denali with AWD, the latter costing $49,495, a $7,000 difference. The spread's blown out some by what appears to be an $800 increase for the 2020 Acadia Denali with all-wheel drive. The 2019 model costs $48,695. On the other hand, it looks like the 200 Acadia SLT trim has gone down in price. Cars Direct says that model will run $41,995, which is $300 less than the 2019 version that goes for $42,295 after destination. The new price leaves a $500 gap between the SLT-1 model with all-wheel drive and the AT4 trim, a figure that's a no-brainer to justify for any buyers trying to get a more butch curb appeal.     The Acadia AT4 package comes standard with all-wheel drive and the 3.6-liter V6 with 310 horsepower and 271 pound-feet of torque, puts black chrome on the grille, and nabs a set of exclusive 17-inch wheels on all-terrain tires. The other two engines in the lineup are a new turbocharged 2.0-liter four-cylinder with 230 horsepower and 258 pound-feet of torque, and cylinder deactivation. That motor will be the standard kit on the SLT and Denali trim levels, supplanting the 3.6-liter that's standard on the 2019 models. The entry-level engine carries over, a naturally aspirated 2.5-liter four-cylinder making 193 horsepower and 188 pound-feet of torque.

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video: