2007 Gmc Yukon Denali Awd Damadge Repairable Rebuilder Good Cooling!! Runs!!!! on 2040-cars

Auto blog

GM recalling 54k Cadillac SRX, HD pickup models

There are more recalls to report General Motors, but these latest actions pertain to newer examples of the Cadillac SRX, Chevrolet Silverado HD and GMC Sierra HD. With so much scrutiny on the company's recall strategy, GM is under increasing pressure to call in defective models more quickly, and it appears to be doing so here.
Here in the US, the automaker is recalling 50,571 Cadillac SRX crossovers from the 2013 model year fitted with the 3.6-liter V6 because the transmission control module programming can cause a three- or four-second lag in acceleration at low speeds. The explanation filed with the National Highway Traffic Safety Administration states, "if the following sequence occurs within two seconds: during an upshift from first to second gear (8-10 mph), the driver then brakes the vehicle to less than 5 mph, and then accelerates again," the delay can occur. According to Automotive News, the recall effects 56,400 vehicles worldwide, and the company is not aware of any crashes caused by the problem. The fix consists of a transmission control module (TCM) reflash.
In a separate recall, GM is repairing 51 Chevrolet Silverado HD and GMC Sierra HD pickups from the 2015 model year in the US. In vehicles with diesel engines and dual fuel tanks, the nuts that connect the fuel pipe to each side of the transfer pump between the tanks may be improperly torqued, which could cause a fuel leak. Obviously, this could be a fire hazard. The remedy is simply tightening the hardware. According to GM spokesperson Alan Adler, there have been no fires actually caused by the potential leak. "Only 21 of the trucks are in customer possession and they can be fixed anytime because there are no parts involved. The others are being fixed at dealerships," Adler said in an email to Autoblog.

GMC Sierra Denali CarbonPro bed is finally, almost here

GMC revealed the Sierra 1500 with the optional CarbonPro bed on March 1, 2018. The bed wasn't available at launch, though. You can't buy it now, either, but it will hit dealerships with limited availability after production starts in early June, exclusively for the Denali 1500 and AT4 1500 trims. The carbon floor and sides replace the steel panels in a normal bed, providing "strength, durability, and scratch resistance" and a potential 59-pound weight saving, depending on the truck's configuration. To make sure the bed had a chance, development engineers replicated "extreme use scenarios" like dropping 1,800-pound gravel loads, 450-pound steel drums, and cinder blocks from various heights. They put a 250-pound man on a snowmobile with studded tracks, had him drive into the bed and then go wide-open throttle. We're told the result was "minimal scratching." On top of the extreme weather testing any vehicle goes through, the team also put a generator in the bed and aim the exhaust into a corner to ensure vibration and direct heat wouldn't deform the carbon fiber. Because of the finer shaping area-specific strength possible with carbon fiber, the bed provides one cubic foot of additional payload space by having its sidewalls pushed further out. The CarbonPro bed doesn't need a bedliner, and is grained at the top for better traction but smooth on the bottom for easier hosing down and dirt removal. Tie-downs at the front of the bed work with molded indentations to hold motorcycle tires, and slots in the sidewalls hold two-by-sixes. The truck maker says the carbon-lined payload area confers "best-in-class dent, scratch and corrosion resistance," but we suppose the nation's pickup truck army will prove that or not. The trucks likely won't have the hardest life at the start, since the Sierra Denali costs $56,790 before even a basic option like four-wheel drive. The real test probably won't come until around 2029, when third owners begin treating their aerospace-inspired thoroughbreds like dray horses.

GM can't keep up with most popular pickup orders

With the market for pickup trucks at its best since before the recession, General Motors can't afford any hiccups with the launch of its new 2014 Chevrolet Silverado and GMC Sierra twins, but it sounds like the popularity of V8-powered trucks is causing some supply-chain issues. Bloomberg reports that GM is experiencing a shortage of 5.3-liter V8 engines because an unnamed parts supplier has been unable to keep up with demand. This is leading GM to restrict the number of V8 Silverado and Sierra trucks that Chevrolet and GMC dealers are allowed to order.
Although it's unclear how long it will take to resolve the parts shortage, GM doesn't have much time to sort it out, as a new Ford F-150 looms on the horizon. At launch, GM's fullsize trucks were offered only with a base 4.3-liter V6 and the 5.3-liter V8, but a burlier 6.2-liter V8 will be available soon. Interestingly, at least at the moment, GM truck buyers don't seem as willing to downsize to V6 power as buyers of the F-150, which gets some 42-percent of its sales from trucks equipped with its EcoBoost V6 engine (not including the normally aspirated base V6).
Working out the kinks in the Silverado and Sierra's supply chain couldn't be more important to the health of the company. Full-size pickups are a huge profit driver - in 2012, the trucks were said to make up about two-third of GM's total profits.