2007 Ext Cab Long Box Diesel Navigation Heated Leather Trailer Brake on 2040-cars
Coeur d'Alene, Idaho, United States
Vehicle Title:Clear
Engine:8
Fuel Type:Gasoline
For Sale By:Dealer
Transmission:Automatic
Make: GMC
Cab Type (For Trucks Only): Extended Cab
Model: Sierra 3500
Mileage: 100,995
Sub Model: SLT
Disability Equipped: No
Exterior Color: Blue
Doors: 4
Interior Color: Gray
Drive Train: Four Wheel Drive
GMC Sierra 3500 for Sale
2005 slt crew 4x4 longbed leather heated v8 turbo diesel we finance 61k miles
2003 gmc sierra 3500 slt extended cab -diesel--4x4--runs great--no reserve !!
Diesel 6.6l cd 4 wheel disc brakes abs brakes am/fm radio air conditioning
2005 gmc sierra 3500 slt crew cab dually 6.6l diesel allison automatic 4wd(US $26,000.00)
1996 gmc 3500 diesel crew cab with enclosed aluminum utility body
2005 gmc crew cab long bed 4x4 one ton(US $17,000.00)
Auto Services in Idaho
The Shop 24/7 ★★★★★
Robinson Auto Glass Experts ★★★★★
Palouse Country Transmission ★★★★★
Merwin`s Repair ★★★★★
McCall Glass Works ★★★★★
Lett`s Downtown Car Wash & Auto Center ★★★★★
Auto blog
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
2015 Chevy Silverado, GMC Sierra recalled for steering issues
Thu, Sep 13 2018DETROIT — General Motors Co is recalling more than 1 million pickup trucks and sport utility vehicles in the United States due to issues with a temporary loss of power steering, the National Highway Traffic Safety Administration said. The recall is for 2015 models. They are: the Chevy Silverado 1500, Suburban and Tahoe, GMC Sierra 1500, Yukon and Yukon XL and Cadillac Escalade. The problem may cause difficulty steering the vehicle, especially at low speeds, increasing the risk of a crash, the auto safety regulator said in a document dated Sept. 12. The document did not highlight any reports of accidents and injuries, because of the power steering issue. GM dealers will update the power steering module software, free of charge for owners of the affected vehicles. In 2014, the No.1 U.S. automaker had recalled nearly 800,000 pickup trucks worldwide because of the same problem. GM did not immediately respond to a request for comment.Related Video:
Chevrolet Silverado, GMC Sierra could get independent rear suspension
Fri, Jan 3 2020The Chevrolet Silverado and the GMC Sierra could reportedly receive a variant of the four-link independent rear suspension found under the new Tahoe and Suburban. While that's not a surprise, a recent report suggests electrification, not comfort, convinced General Motors to make the change. Replacing the time-tested solid rear axle with an independent suspension will improve comfort, handling and off-road prowess, while adding weight, and likely making the trucks a little bit more expensive. It's a fair trade-off, but GM Authority learned the real reason for the swap is that at least one of the pickups will spawn an electric model, and it's more difficult to package a bulky battery pack around a solid rear axle. The independent rear suspension takes up far less space, even if it has more moving parts. General Motors will build its first regular-production electric pickup on an evolution of the Silverado's T1 platform named BT1, according to the same source. The b stands for -- you guessed it -- batteries. The firm reportedly doesn't want to make two suspensions for cost reasons, so the independent setup will come standard regardless of whether the truck runs on gasoline, diesel, or electricity. As a bonus, Chevrolet and GMC could choose to offer their T1-based trucks with Magnetic Ride Control or an air suspension, options available on the 2021 Suburban and Tahoe. The independent rear suspension will also find its way to the next-generation GMC Yukon due to be revealed January 14, and to the 2021 Cadillac Escalade scheduled to make its debut February 4. The long-rumored, born-again Hummer will get it, too, because it will arrive as an electric model built on the BT1 platform. It's worth noting none of this is official, and General Motors has remained quiet about what's next for its new suspension design, and what will be under its electric truck's sheet metal. If the GM Authority report is accurate, the Silverado (pictured) and the Sierra could ditch their solid rear axle for the 2021 model year. The change will likely be accompanied by other tweaks inside and out. Featured Gallery 2019 Chevrolet Silverado 1500 View 16 Photos Chevrolet GMC Truck