2004 Gmc Sierra Sle 2500 Hd 4x4 * Turbo Diesel Duramax * Full Leer Camper & More on 2040-cars

Auto blog

GMC Sierra Denali CarbonPro bed is finally, almost here

GMC revealed the Sierra 1500 with the optional CarbonPro bed on March 1, 2018. The bed wasn't available at launch, though. You can't buy it now, either, but it will hit dealerships with limited availability after production starts in early June, exclusively for the Denali 1500 and AT4 1500 trims. The carbon floor and sides replace the steel panels in a normal bed, providing "strength, durability, and scratch resistance" and a potential 59-pound weight saving, depending on the truck's configuration. To make sure the bed had a chance, development engineers replicated "extreme use scenarios" like dropping 1,800-pound gravel loads, 450-pound steel drums, and cinder blocks from various heights. They put a 250-pound man on a snowmobile with studded tracks, had him drive into the bed and then go wide-open throttle. We're told the result was "minimal scratching." On top of the extreme weather testing any vehicle goes through, the team also put a generator in the bed and aim the exhaust into a corner to ensure vibration and direct heat wouldn't deform the carbon fiber. Because of the finer shaping area-specific strength possible with carbon fiber, the bed provides one cubic foot of additional payload space by having its sidewalls pushed further out. The CarbonPro bed doesn't need a bedliner, and is grained at the top for better traction but smooth on the bottom for easier hosing down and dirt removal. Tie-downs at the front of the bed work with molded indentations to hold motorcycle tires, and slots in the sidewalls hold two-by-sixes. The truck maker says the carbon-lined payload area confers "best-in-class dent, scratch and corrosion resistance," but we suppose the nation's pickup truck army will prove that or not. The trucks likely won't have the hardest life at the start, since the Sierra Denali costs $56,790 before even a basic option like four-wheel drive. The real test probably won't come until around 2029, when third owners begin treating their aerospace-inspired thoroughbreds like dray horses.

NHTSA upgrades probe into 1.7 million GM vehicles over wiper failures

WASHINGTON — The U.S. National Highway Traffic Safety Administration (NHTSA) said Tuesday it is upgrading an investigation into 1.7 million General Motors vehicles for windshield wiper failures. The auto safety agency opened the probe in November 2018 to see if GM needed to expand a 2016 recall of 2013 model year Chevrolet Equinox and GMC Terrain SUVs to cover additional vehicles. The engineering analysis probe covers 2010-2012 and 2014-2016 Equinox and Terrain vehicles. NHTSA could demand a recall after it completes the probe. NHTSA said it has reviewed 1,900 complaints and reports related to the issue in the 1.7 million vehicles. NHTSA said it has seen elevated failure rates in the 1.7 million vehicles, even though GM said the recalled vehicles have "double the warranty rate and five times the complaint rate." GM said it will "fully cooperate to support their investigation. We do not believe these windshield washer systems are defective." The wiper failures that prompted the 2016 recall were attributed to water and debris intrusion into the windshield wiper assembly ball joints, leading to excessive wear and eventual detachment of the ball joint. GM said it was installing an improved windshield wiper motor and transmission assembly and relocating a drain hole at the base of the windshield. Related Video:

2019 GMC Sierra Denali First Drive Review | The more things change...

ST. JOHN'S, Newfoundland — Canadians love their GMCs. Both anecdotal and statistical evidence supports this. In certain areas of Canada, the Sierra outsells the Chevy Silverado. But in this area of Canada, Cape Spear, the morning fog and salt air are thick. This is the most eastern point in Canada, and the most eastern point of North America if you don't count Greenland. We woke up early and drove to the coast in the new 2019 GMC Sierra Denali, hoping to catch what was promised to be an absolutely spectacular sunrise. The sunrise was a no-go thanks to the fog, turning the sky into a grey mist that melted into the Atlantic. Still, if the world had an edge, this is what it would look like. Driving in an inspiring place like this invites introspection, and since we're in an GMC Sierra, why not examine the brand's place in the world? Recall that for years, a GMC showroom was just packed with slightly more expensive versions of other GM products. Badge engineering, if you will – a dirty word in our business, applied to such notable machines as the Cadillac Cimarron, Buick Terraza, Chevy Aveo and Saab 9-7X. Things, at least on the surface, seem to be changing. GMC says it's making a concerted effort to differentiate its product portfolio from the rest of GM, but the results have been mixed. The brands were supposed to have less product crossover. There's no GMC version of the Chevy Traverse and, initially, there was no Chevy equivalent of the GMC Acadia, though the new Blazer kills that advantage. The Equinox and Terrain are still basically the same vehicle, as are the new 2019 Silverado and 2019 Sierra. At least the two trucks look decidedly different. There's still a family resemblance, but most of the bodywork has been changed. Where the 2019 Silverado adopted some curves, the Sierra stuck with straight lines. Compare things like the headlights, wheel wells and doors. The Sierra still has a massive grille and — aside from the AT4 off-road trim — packs on as much chrome as a 1958 Cadillac, but that's what customers want these days. The Ford F-150 and Ram 1500 are no different in this regard, packing lots of chrome, hard edges, and frontal areas that would give passenger trains a run for their money. At first glance, you'd be hard pressed to tell the Sierra and Silverado's interiors apart from both each other and the outgoing models. It's basically the same design, though the Sierra makes do with some slightly nicer materials.